Jump to content

Bull polishing

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 81.108.164.69 (talk) at 16:55, 13 July 2016 (Added a little bit to the method). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Bull polished drill boots

Bull polishing, bulling, spit polishing or spit shining refers to a method for polishing leather products in such a way as to give an extremely high shine effect. It is commonly used in the military as a traditional method of presenting leather accessories (such as a Sam Browne belt) and boots for inspection. The finished effect should leave the surface of the leather highly reflective.

Ultimately, the process involves polishing the applied thin layers of polish, not the leather itself. The process can be lengthy and is best learned with practice. The down side to this method is that the slightest touch to the laminated layers of brittle dry polish could end up with them cracking or even shattering like glass or even the leather breaking up as the nourishment supplied by the oils in the polish never actually reached the leather.

Method

There is great debate as to the best method for bull polishing, to a point where a lore may be said to exist. Among techniques advocated are melting the polish, the addition of cigar ash to the polish, and substituting coffee for water or spit. However, the basic principles remain the same:

  • Wear the item a few times to establish any natural creases that occur during use. This is particularly important if the leather has been "burnt down" with beeswax (a process that gives the leather a smoother finish).
  • Polish the item in the normal way with a brush a few times to get a decent, regular polish. This is best achieved by applying a liberal amount of polish with one brush and using another brush to spread and smooth out the polish, as well as getting rid of any excess.
  • Apply thin layers of polish to the item in small circular motions with a cloth (e.g. a yellow duster) until a dull, smooth shine appears.
  • Polish the final layer of polish with the damp cloth or cotton wool until the desired shine appears.
  • Use small amounts of water, keeping the shoe rag damp.
  • Do not use too much polish. Using too much polish will cause it to take a long time to polish and not give a very good shine.

References