Jump to content

Electromagnetic electron wave

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Goodphy (talk | contribs) at 13:36, 5 September 2016 (Cut-off frequency and critical density: I did correction of miss use of system of units.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

In plasma physics, an electromagnetic electron wave is a wave in a plasma which has a magnetic field component and in which primarily the electrons oscillate.

In an unmagnetized plasma, an electromagnetic electron wave is simply a light wave modified by the plasma. In a magnetized plasma, there are two modes perpendicular to the field, the O and X modes, and two modes parallel to the field, the R and L waves.

Cut-off frequency and critical density

In an unmagnetized plasma for the high frequency or low electron density limit, i.e. for or where ωpe is the plasma frequency, the wave speed is the speed of light in vacuum. As the electron density increases, the phase velocity increases and the group velocity decreases until the cut-off frequency where the light frequency is equal to ωpe. This density is known as the critical density for the angular frequency ω of that wave and is given by [1]

(SI units)

If the critical density is exceeded, the plasma is called over-dense.

In a magnetized plasma, except for the O wave, the cut-off relationships are more complex.

O wave

The O wave is the "ordinary" wave in the sense that its dispersion relation is the same as that in an unmagnetized plasma. It is plane polarized with E1 || B0. It has a cut-off at the plasma frequency.

X wave

The X wave is the "extraordinary" wave because it has a more complicated dispersion relation. It is partly transverse (with E1B0) and partly longitudinal. As the density is increased, the phase velocity rises from c until the cut-off at ωR is reached. As the density is further increased, the wave is evanescent until the resonance at the upper hybrid frequency ωh. Then it can propagate again until the second cut-off at ωL. The cut-off frequencies are given by [2]

where is the electron cyclotron resonance frequency, and is the electron plasma frequency.

R wave and L wave

The R wave and the L wave are right-hand and left-hand circularly polarized, respectively. The R wave has a cut-off at ωR (hence the designation of this frequency) and a resonance at ωc. The L wave has a cut-off at ωL and no resonance. R waves at frequencies below ωc/2 are also known as whistler modes. [3]

Dispersion relations

The dispersion relation can be written as an expression for the frequency (squared), but it is also common to write it as an expression for the index of refraction ck/ω (squared).

Summary of electromagnetic electron waves
conditions dispersion relation name
light wave
O wave
X wave
(right circ. pol.) R wave (whistler mode)
(left circ. pol.) L wave

References

  1. ^ Chen, Francis (1984). Introduction to Plasma Physics and Controlled Fusion, Volume 1 (2nd ed.). Plenum Publishing Corporation. p. 116. ISBN 0-306-41332-9.
  2. ^ Chen, Francis (1984). Introduction to Plasma Physics and Controlled Fusion, Volume 1 (2nd ed.). Plenum Publishing Corporation. p. 127. ISBN 0-306-41332-9.
  3. ^ Chen, Francis (1984). Introduction to Plasma Physics and Controlled Fusion, Volume 1 (2nd ed.). Plenum Publishing Corporation. p. 131. ISBN 0-306-41332-9.

See also