Jump to content

LaSalle Street Tunnel

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Cydebot (talk | contribs) at 12:49, 9 October 2016 (Robot - Moving category Transportation in Chicago, Illinois to Category:Transportation in Chicago per CFD at Wikipedia:Categories for discussion/Log/2016 September 6.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

LaSalle St. Tunnel
South portal before 1888
Overview
StatusClosed and covered
StartMichigan (Hubbard) St.
EndDearborn St.
Operation
Opened1871 (public), 1888 (cable)
1912 (after lowering)
Closed1939
OwnerCity of Chicago
OperatorNorth Chicago Street Ry.
Chicago Union Transit
Chicago Surface Lines
Technical
Length1,887 ft (575.16 m)
(as built)
No. of lanes3
Highest elevation594 ft (181.05 m)
Lowest elevation534 ft (162.76 m)
(after lowering)
Tunnel clearance15 feet 9 inches (4.80 m)
Width30 ft (9.14 m)

The LaSalle Street Tunnel was Chicago's second tunnel under the Chicago River. It was started November 3, 1869, and completed July 4, 1871. It was designed by William Bryson who was the resident engineer for the Washington Street Tunnel. It was 1,890 feet (576m) long, from Randolph Street north to Hubbard (then Michigan) Street, and cost $566,000.

History

As built

Originally built with one lane for pedestrians and 2 lanes for horse-drawn traffic, by the 1880s it was in poor condition. On March 23, 1888 the North Chicago Street Railroad leased the tunnel. If they repaired it and made other local improvements they could use the tunnel exclusively for cable car service.[1][2][3]

The reversing of the Chicago River in 1900 exposed the roof of the tunnel in the new riverbed and in 1904 the Federal government declared it a hazard to navigation. The tunnel was closed to cable cars on October 21 1906. [1][2][3]

Reconstruction

The approaches were deepened to a new lower tunnel level. The grades were aligned for the cars to enter from a shallow subway just below street level. The subway was not built, concrete ramps raised the tracks up to street grade.[3]

The tunnel section under the river was removed and a two tube steel plate replacement built in a drydock on Goose Island was lowered into a trench in the riverbed. The tunnels connecting the approaches and the tubes were dug through and under the original tunnels.[3][4]

After lowering

The deepened tunnel was opened to electric streetcar service on July 21, 1912. It was in use until November 27, 1939, when it was closed during the construction of the Milwaukee-Lake-Dearborn-Congress subway, the Lake & LaSalle (now Clark & Lake) station of which intersected the tunnel's south ramp under Lake Street. By 1950 the south approach had been covered, the tunnel and the north approach were filled and covered by 1953.[1][2][3][5]

See also

Van Buren St. Tunnel
Washington St. Tunnel

References

  1. ^ a b c Borzo, Greg (2012). Chicago Cable Cars. The History Press. pp. 123–128, 183. ISBN 978-1-60949-327-1.
  2. ^ a b c "Tunnels". Encyclopedia of Chicago. Chicago Historical Society and The Newberry Library. 2005. Retrieved 3 March 2015.
  3. ^ a b c d e Lind, Alan R. (1979). Chicago Surface Lines: An Illustrated History(3rd ed.). Transit History Press. pp. 210–215. ISBN 978-0-934732-00-0. LCCN 74075870.
  4. ^ Genzen, Jonathan (2007). The Chicago River: A History in Photographs. Westcliffe Publishers. pp. 46–47. ISBN 978-1-56579-553-2. LCCN 2006022119.
  5. ^ Chicago Fire Insurance Maps Volume 1. Sanborn Map. 1950. pp. 14s, 34n.