Jump to content

M1879 Reichsrevolver

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 81.233.62.195 (talk) at 21:34, 4 October 2016. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Reichsrevolver Modell M79
M1879 German Trooper's Revolver
TypeRevolver
Place of originGerman Empire
Service history
In service1879–1940s(?)
Used byGerman Empire
WarsGerman colonial conflicts, Boxer Rebellion, World War I, World War II
Production history
ManufacturerV.C. Schilling & Cie, Spangenberg &SauerC.G. Haenel & Cie, Gebrüder Mauser & Cie, Oberndorf-am-Neckar, and Königliche Gewehrfabrik Erfurt
VariantsM1883 (5 in barrel)
Specifications
Mass2lb 5 oz (1040 g)
Length12.20 in (310 mm) (7 in barrel)

Cartridge10.6×25mmR
Caliber10.6 mm (.41 in)
ActionSingle action
Muzzle velocity670 ft/s (205 m/s)
Feed system6-round cylinder

The M1879 Reichsrevolver, or Reichs-Commissions-Revolver Modell 1879 and 1883, were service revolvers used by the German Army from 1879 to 1908, when it was superseded by the Luger.

The two versions of the revolver differ only in barrel length (The M1883 had a 5-inch barrel). Although the design was dated, the weapon was extremely robust, and they were still used through World War I. The M1879 is referred to as the "cavalry model" and the M1883 as the "officer's model," by collectors, which were not official designations.

Design

Both were single-action solid frame non-ejecting six-shot revolvers. The caliber was an indigenous 10.6×25mmR with a medium-length cartridge case, comparable to the contemporary .44 Russian round in size and power. Loading was via a gate on the weapon's right side, and the cylinder was released by pulling the hammer to half-cock. Removing empty cartridges could be done by removing the cylinder by withdrawing the axis-pin, and then removing the casings by hand, but in actual practice a separate small rod (stored in the ammunition pouch) was used to push the casings out without having to remove the cylinder. A safety lever was incorporated into weapon.

Most revolvers came with a lanyard ring for attachment to the uniform.

References

  • Military Small Arms of the Twentieth Century, 7th Edition, Weeks, John, Hogg, Ian V.

See also