Maryland Route 158
 Maryland Route 158 | ||||
|---|---|---|---|---|
| Bethlehem Boulevard | ||||
 Maryland Route 158 highlighted in red | ||||
| Route information | ||||
| Maintained by MDSHA | ||||
| Length | 2.35 mi[1] (3.78 km) | |||
| Existed | 1991–present | |||
| Major junctions | ||||
| West end | Riverside Drive in Sparrows Point | |||
 MD 157 in Sparrows Point MD 151 in Edgemere | ||||
| East end | North Point Road in Edgemere | |||
| Location | ||||
| Country | United States | |||
| State | Maryland | |||
| Counties | Baltimore | |||
| Highway system | ||||
| ||||
Maryland Route 158 (MD 158) is a state highway in the U.S. state of Maryland. Known as Bethlehem Boulevard, the state highway runs 2.35 miles (3.78 km) from Riverside Drive in Sparrows Point east to North Point Road in Edgemere. MD 158 parallels Interstate 695 (I-695) along the northern edge of the former Bethlehem Steel complex at Sparrows Point and connects MD 157 with MD 151. Bethlehem Boulevard was constructed as a four-lane divided county highway with several interchanges in the late 1950s. The highway was designated MD 158 in the early 1990s. When I-695 was completely rebuilt and expanded from two to four lanes through Sparrows Point and Edgemere in the late 1990s, MD 158 was also reconstructed as a mostly two-lane highway without interchanges.
Route description
MD 158 begins at a tangent intersection with Riverside Drive, which follows the western edge of the former Bethlehem Steel complex (now owned by Severstal) on Bear Creek in Sparrows Point. The two-lane state highway curves east and closely parallels the northbound lanes of I-695 (Baltimore Beltway); the two highways are separated by a Jersey barrier. After the highways cross mud flats, MD 158 veers away from the Beltway, expands to a four-lane divided highway, and receives a ramp from the northbound Interstate. The state highway meets the southern end of MD 157 (Peninsula Expressway), which provides access to southbound I-695, which heads toward the Francis Scott Key Bridge. Beyond an entrance to the steel complex and a ramp to northbound I-695, the divided highway reduces to two lanes and again closely parallels the Beltway and meets the northern end of Wharf Road, which is unsigned MD 151B. The two highways curve northeast, then diverge as MD 158 temporarily becomes an undivided highway as it crosses over the Patapsco & Back Rivers Railroad. The state highway intersects MD 151 (North Point Boulevard) before reaching its eastern terminus at North Point Road, which heads south as the main street of Edgemere.[1][2]
History
The original MD 158 was Belcamp Road from the Bush River at modern US 40 north to Creswell Road near Riverside in Harford County.[3][4] This state highway was constructed by 1915 and removed from the state highway system in 1956.[5] Bethlehem Boulevard was built as a four-lane divided highway between 1957 and 1959.[6][7] The highway's original western terminus was at Dundalk Avenue, which crossed Bear Creek on a drawbridge from Dundalk.[7] Both the Dundalk Avenue bridge and the 1960-built Peninsula Expressway drawbridge were toll bridges through 1977; the Dundalk Avenue bridge was removed around 1985.[8][9][10]
Bethlehem Boulevard was built with four interchanges.[11] The western terminus of the highway was a trumpet interchange with Tin Mill Road (now Riverside Drive) where the mainline continued northwest as Dundalk Avenue across the drawbridge. Bethlehem Boulevard had a cloverleaf interchange with the Peninsula Expressway that featured a wide split in the median. East of the Peninsula Expressway interchange was a partial interchange with Wharf Road that offered access from Wharf Road to and from the west. The fourth junction was a partial interchange with MD 151 that allowed access between Bethlehem Boulevard to the west and MD 151 to the north. Eastbound Bethlehem Boulevard continued east to MD 20 (North Point Road).[12] When MD 695 (now I-695) was completed as a two-lane freeway on a viaduct parallel to Bethlehem Boulevard from Edgemere to the Key Bridge in 1977, the only changes to the interchanges were two pairs of ramps from the west at the Peninsula Expressway interchange and from the east at the MD 151 interchange.[9][12]
Bethlehem Boulevard was brought into the state highway system as MD 158 around 1991 concurrent with MD 157 being assigned to the Peninsula Expressway south of Bear Creek.[13] Between 1995 and 1999, I-695 was transformed from a two-lane freeway on a viaduct to a four-lane surface-level freeway between Edgemere and the Key Bridge.[14][15] As part of the project, MD 158 was reconstructed. Most of the state highway was reduced to two lanes and relocated parallel to I-695 instead of passing under the Interstate Highway. In addition, all four of MD 158's interchanges were removed. Westbound MD 158 at its interchange with MD 157 became a collector-distributor lane for westbound I-695's interchange with MD 157.[15]
Junction list
The entire route is in Baltimore County.
| Location | mi [1] | km | Destinations | Notes | |
|---|---|---|---|---|---|
| Sparrows Point | 0.00 | 0.00 | Riverside Drive | Western terminus | |
| 1.07 | 1.72 |     MD 157 north (Peninsula Expressway) to I-695 south – Dundalk | |||
| 1.20 | 1.93 |  I-695 north (Baltimore Beltway) – Essex | I-695 Exit 43 | ||
| 1.52 | 2.45 | Wharf Road south | Unsigned MD 151B | ||
| Edgemere | 2.21 | 3.56 | MD 151 (North Point Boulevard) to I-695 north – Dundalk, Sparrows Point | ||
| 2.35 | 3.78 | North Point Road | Eastern terminus | ||
| 1.000 mi = 1.609 km; 1.000 km = 0.621 mi | |||||
See also
References
- ^ a b c Highway Information Services Division (December 31, 2013). Highway Location Reference. Maryland State Highway Administration. Retrieved 2011-05-25.
- Baltimore County (PDF).
- ^ "Maryland Route 158" (Map). Google Maps. Retrieved 2011-05-25.
- ^ Weller, O.E.; Parran, Thomas; Miller, W.B.; Perry, John M.; Ramsay, Andrew; Smith, J. Frank (May 1916). Annual Reports of the State Roads Commission of Maryland (1912–1915 ed.). Baltimore: Maryland State Roads Commission. p. 124. Retrieved 2011-03-01.
- ^ Maryland State Roads Commission (1939). General Highway Map: State of Maryland (PDF) (Map). Baltimore: Maryland State Roads Commission.
- ^ Maryland State Roads Commission (1956). Maryland: Official Highway Map (PDF) (Map). Baltimore: Maryland State Roads Commission.
- ^ "NBI Structure Number: 100000030349010". National Bridge Inventory. Federal Highway Administration. Retrieved 2011-05-25.
- ^ a b Maryland State Roads Commission (1959). Maryland: Official Highway Map (PDF) (Map). Baltimore: Maryland State Roads Commission.
- ^ "NBI Structure Number: 100000030365010". National Bridge Inventory. Federal Highway Administration. Retrieved 2011-05-25.
- ^ a b Maryland State Highway Administration (1977). Maryland: Official Highway Map (PDF) (Map). Baltimore: Maryland State Highway Administration.
- ^ Maryland State Highway Administration (1985). Maryland: Official Highway Map (PDF) (Map) (1985–1986 ed.). Baltimore: Maryland State Highway Administration.
- ^ Maryland State Roads Commission (1963). Maryland: Official Highway Map (PDF) (Map). Baltimore: Maryland State Roads Commission.
- ^ a b Edgemere, Maryland, United States (Map). Topo Map. United States Geological Survey. 1991-07-01. Retrieved 2011-05-25.
- ^ Maryland State Highway Administration (1991). Maryland: Official Highway Map (PDF) (Map). Baltimore: Maryland State Highway Administration.
- ^ "NBI Structure Number: 100000030370010". National Bridge Inventory. Federal Highway Administration. Retrieved 2011-05-25.
- ^ a b Highway Information Services Division (December 31, 1999). Highway Location Reference. Maryland State Highway Administration. Retrieved 2011-05-25.
- Baltimore County (PDF).
External links
