Jump to content

Mass–luminosity relation

From Wikipedia, the free encyclopedia

In astrophysics, the mass–luminosity relation is an equation giving the relationship between a star's mass and its luminosity, first noted by Jakob Karl Ernst Halm.[1] The relationship is represented by the equation: where L and M are the luminosity and mass of the Sun and 1 < a < 6.[2] The value a = 3.5 is commonly used for main-sequence stars.[3] This equation and the usual value of a = 3.5 only applies to main-sequence stars with masses 2M < M < 55M and does not apply to red giants or white dwarfs. As a star approaches the Eddington luminosity then a = 1.

In summary, the relations for stars with different ranges of mass are, to a good approximation, as the following:[2][4][5]

For stars with masses less than 0.43M, convection is the sole energy transport process, so the relation changes significantly. For stars with masses M > 55M the relationship flattens out and becomes L ∝ M[2] but in fact those stars don't last because they are unstable and quickly lose matter by intense solar winds. It can be shown this change is due to an increase in radiation pressure in massive stars.[2] These equations are determined empirically by determining the mass of stars in binary systems to which the distance is known via standard parallax measurements or other techniques. After enough stars are plotted, stars will form a line on a logarithmic plot and slope of the line gives the proper value of a.

Another form, valid for K-type main-sequence stars, that avoids the discontinuity in the exponent has been given by Cuntz & Wang;[6] it reads: with (M in M). This relation is based on data by Mann and collaborators,[7] who used moderate-resolution spectra of nearby late-K and M dwarfs with known parallaxes and interferometrically determined radii to refine their effective temperatures and luminosities. Those stars have also been used as a calibration sample for Kepler candidate objects. Besides avoiding the discontinuity in the exponent at M = 0.43M, the relation also recovers a = 4.0 for M ≃ 0.85M.

The mass/luminosity relation is important because it can be used to find the distance to binary systems which are too far for normal parallax measurements, using a technique called "dynamical parallax".[8] In this technique, the masses of the two stars in a binary system are estimated, usually in terms of the mass of the Sun. Then, using Kepler's laws of celestial mechanics, the distance between the stars is calculated. Once this distance is found, the distance away can be found via the arc subtended in the sky, giving a preliminary distance measurement. From this measurement and the apparent magnitudes of both stars, the luminosities can be found, and by using the mass–luminosity relationship, the masses of each star. These masses are used to re-calculate the separation distance, and the process is repeated. The process is iterated many times, and accuracies as high as 5% can be achieved.[8] The mass/luminosity relationship can also be used to determine the lifetime of stars by noting that lifetime is approximately proportional to M/L although one finds that more massive stars have shorter lifetimes than that which the M/L relationship predicts. A more sophisticated calculation factors in a star's loss of mass over time.

Derivation

[edit]

Deriving a theoretically exact mass/luminosity relation requires finding the energy generation equation and building a thermodynamic model of the inside of a star. However, the basic relation L ∝ M3 can be derived using some basic physics and simplifying assumptions.[9] The first such derivation was performed by astrophysicist Arthur Eddington in 1924.[10] The derivation showed that stars can be approximately modelled as ideal gases, which was a new, somewhat radical idea at the time. What follows is a somewhat more modern approach based on the same principles.

An important factor controlling the luminosity of a star (energy emitted per unit time) is the rate of energy dissipation through its bulk. Where there is no heat convection, this dissipation happens mainly by photons diffusing. By integrating Fick's first law over the surface of some radius r in the radiation zone (where there is negligible convection), we get the total outgoing energy flux which is equal to the luminosity by conservation of energy: where D is the photons diffusion coefficient, and u is the energy density.

Note that this assumes that the star is not fully convective, and that all heat creating processes (nucleosynthesis) happen in the core, below the radiation zone. These two assumptions are not correct in red giants, which do not obey the usual mass-luminosity relation. Stars of low mass are also fully convective, hence do not obey the law.

Approximating the star by a black body, the energy density is related to the temperature by the Stefan–Boltzmann law: where is the Stefan–Boltzmann constant, c is the speed of light, kB is Boltzmann constant and is the reduced Planck constant.

As in the theory of diffusion coefficient in gases, the diffusion coefficient D approximately satisfies: where λ is the photon mean free path.

Since matter is fully ionized in the star core (as well as where the temperature is of the same order of magnitude as inside the core), photons collide mainly with electrons, and so λ satisfies Here is the electron density and: is the cross section for electron-photon scattering, equal to Thomson cross-section. α is the fine-structure constant and me the electron mass.

The average stellar electron density is related to the star mass M and radius R

Finally, by the virial theorem, the total kinetic energy is equal to half the gravitational potential energy EG, so if the average nuclei mass is mn, then the average kinetic energy per nucleus satisfies: where the temperature T is averaged over the star and C is a factor of order one related to the stellar structure and can be estimated from the star approximate polytropic index. Note that this does not hold for large enough stars, where the radiation pressure is larger than the gas pressure in the radiation zone, hence the relation between temperature, mass and radius is different, as elaborated below.

Wrapping up everything, we also take r to be equal to R up to a factor, and ne at r is replaced by its stellar average up to a factor. The combined factor is approximately 1/15 for the sun, and we get:

The added factor is actually dependent on M, therefore the law has an approximate dependence.

Distinguishing between small and large stellar masses

[edit]

One may distinguish between the cases of small and large stellar masses by deriving the above results using radiation pressure. In this case, it is easier to use the optical opacity and to consider the internal temperature TI directly; more precisely, one can consider the average temperature in the radiation zone.

The consideration begins by noting the relation between the radiation pressure Prad and luminosity. The gradient of radiation pressure is equal to the momentum transfer absorbed from the radiation, giving: where c is the velocity of light. Here, ; the photon mean free path.

The radiation pressure is related to the temperature by , therefore from which it follows directly that

In the radiation zone gravity is balanced by the pressure on the gas coming from both itself (approximated by ideal gas pressure) and from the radiation. For a small enough stellar mass the latter is negligible and one arrives at as before. More precisely, since integration was done from 0 to R so on the left side, but the surface temperature TE can be neglected with respect to the internal temperature TI.

From this it follows directly that

For a large enough stellar mass, the radiation pressure is larger than the gas pressure in the radiation zone. Plugging in the radiation pressure, instead of the ideal gas pressure used above, yields hence

Core and surface temperatures

[edit]

To the first approximation, stars are black body radiators with a surface area of 4πR2. Thus, from the Stefan–Boltzmann law, the luminosity is related to the surface temperature TS, and through it to the color of the star, by where σB is Stefan–Boltzmann constant, 5.67×10−8 W m−2 K−4

The luminosity is equal to the total energy produced by the star per unit time. Since this energy is produced by nucleosynthesis, usually in the star core (this is not true for red giants), the core temperature is related to the luminosity by the nucleosynthesis rate per unit volume: Here, ε is the total energy emitted in the chain reaction or reaction cycle. is the Gamow peak energy, dependent on EG, the Gamow factor. Additionally, S(E)/E is the reaction cross section, n is number density, is the reduced mass for the particle collision, and A,B are the two species participating in the limiting reaction (e.g. both stand for a proton in the proton-proton chain reaction, or A a proton and B an 14
7
N
nucleus for the CNO cycle).

Since the radius R is itself a function of the temperature and the mass, one may solve this equation to get the core temperature.

References

[edit]
  1. ^ Kuiper, G.P. (1938). "The Empirical Mass-Luminosity Relationship". Astrophysical Journal. 88: 472–506. Bibcode:1938ApJ....88..472K. doi:10.1086/143999.
  2. ^ a b c d Salaris, Maurizio; Santi Cassisi (2005). Evolution of stars and stellar populations. John Wiley & Sons. pp. 138–140. ISBN 978-0-470-09220-0.
  3. ^ "Mass-luminosity relationship". Hyperphysics. Retrieved 2009-08-23.
  4. ^ Duric, Nebojsa (2004). Advanced astrophysics. Cambridge University Press. p. 19. ISBN 978-0-521-52571-8.
  5. ^ "The Eddington Limit (Lecture 18)" (PDF). jila.colorado.edu. 2003. Retrieved 2019-01-22.
  6. ^ Cuntz, M.; Wang, Z. (2018). "The Mass–Luminosity Relation for a Refined Set of Late-K/M Dwarfs". Research Notes of the American Astronomical Society. 2a: 19. Bibcode:2018RNAAS...2a..19C. doi:10.3847/2515-5172/aaaa67.
  7. ^ Mann, A. W.; Gaidos, E.; Ansdell, M. (2013). "Spectro-thermometry of M Dwarfs and Their Candidate Planets: Too Hot, Too Cool, or Just Right?". Astrophysical Journal. 779 (2): 188. arXiv:1311.0003. Bibcode:2013ApJ...779..188M. doi:10.1088/0004-637X/779/2/188.
  8. ^ a b Mullaney, James (2005). Double and multiple stars and how to observe them. Springer. p. 27. ISBN 978-1-85233-751-3.
  9. ^ Phillips, A.C. (1999). The Physics of Stars. John Wiley & Sons. ISBN 978-0-471-98798-7.
  10. ^ Lecchini, Stefano (2007). How Dwarfs Became Giants. The Discovery of the Mass-Luminosity Relation. Bern Studies in the History and Philosophy of Science. ISBN 978-3-9522882-6-9.[permanent dead link]