Motorcraft 2150 carburetor
The Motorcraft 2150 is a Ford (also used by AMC) 2-barrel carburetor manufactured from 1973 through 1983,[1] based heavily on its predecessor, the Autolite 2100.
The 2150 improved on the 2100s design through the introduction of a variable air bleed system, which keeps the air to fuel mixture better balanced throughout the carburetor's full range of operation. The 2150 models from 1983 to 1986 were electronic feedback carburetors equipped with Ford's EEC-IV.[2]
Variations
Unlike the Autolite 2100, the Motorcraft 2150 was available only in two venturi sizes. Both were available in manual and automatic transmission configurations.
1.08 venturi, 287 CFM[3]
These 2150s were used on Ford engines up to the 302 Windsor in cubic displacement.
Ford engines commonly equipped with the 1.08 venturi 2150:
- 1975-1986 2.8L V6[4]
- 1982-1983 3.8L Essex V6
1973-1983 250 cu in (4.1 L) I6
Note: The 250-I6 is derived from the Falcon line (144-170-200). U.S. versions were only available with an intergal cast head and intake making them only able to accept a 1 barrel carb. Foreign versions were also made with typical 2 piece intake and head.
- 1973-1983 302 cu in (4.9 L) Windsor
The last Ford vehicles to leave the factory with 2150 carburetors were 1986 Aerostars equipped with the 2.8L V6.
1.21 venturi, 351 CFM[3]
These larger 2150s were generally used in large Ford passenger cars and trucks equipped with 335-series engines.
Ford engines commonly equipped with the 1.21 venturi 2150:
- 1973-1982 351 cu in (5.8 L) Windsor
- 1977-1982 351 cu in (5.8 L) 351M
- 1977-1979 400 cu in (6.6 L)
See also
References
- ^ "Motorcraft 2150 2V Carburetor". Grantorinosport.org. Retrieved 2013-04-27.
- ^ "Slant Six Forum, :: View topic - Best 2 Barrel Carb". Slantsix.org. Retrieved 2013-04-27.
- ^ a b Ford Motorcraft 2100/2150 Carb, Opelgt.com, retrieved 2013-04-27
- ^ "The Motorcraft 2150 Carburator". Myplace.frontier.com. Retrieved 2013-04-27.