Jump to content

Sanders Bridge

Coordinates: 35°12′46″N 109°19′47″W / 35.21278°N 109.32972°W / 35.21278; -109.32972
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Bearcat (talk | contribs) at 21:15, 4 July 2018 (added Category:Bridges in Arizona using HotCat). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Sanders Bridge
Sanders Bridge is located in Arizona
Sanders Bridge
Sanders Bridge is located in the United States
Sanders Bridge
LocationSanders, Arizona
Coordinates35°12′46″N 109°19′47″W / 35.21278°N 109.32972°W / 35.21278; -109.32972
NRHP reference No.88001618[1]
Added to NRHPSeptember 30, 1988

Sanders Bridge is a steel truss bridge straddling the Puerco River, near Sanders, Arizona. It was constructed in 1923, and gained National Historic status in 1988.

History

The Arizona Highway Department (AHD) began a major improvement in what was then known as the Holbrook-Lupton Highway, running between the state line with New Mexico to Adamana. The Sanders Bridge was one of two bridges included in the proposed upgrade, the other being the Allentown Bridge. Based upon engineering drawings by AHD, the Monarch Engineering Company, based in Denver, Colorado, was awarded the contract for the Sanders Bridge. Construction began on May 22, 1923, and was completed by September 10, at a cost of $15,005. This section of highway would later become part of US Route 66. However in 1931, after another realignment of the highway system, the Sanders Bridge, along with the one at Allentown, were no longer included on Route 66. Currently, it carries local traffic on the Navajo NationNavajo Indian Reservation. It is currently owned by the U.S. Bureau of Indian Affairs.[2]

Description

The substructure consists of concrete abutments and piers, on which sit timber stringers, supporting a timber deck which is covered with asphalt. The superstructure consists of a riveted steel, 6-panel Pratt pony truss. There are two spans, 75 feet in length and 14 feet 8 inches in width, with a total length of 190 feet, when the on and off ramps are taken into account.[2]

See also

References

  1. ^ "National Register Information System". National Register of Historic Places. National Park Service. July 9, 2010.
  2. ^ a b "National Register of Historic Places Registration Form: Sanders Bridge". U.S. National Park Service. April 1, 1987. pp. 6:1. Retrieved November 24, 2017.