Jump to content

User:Mgouin/Raspberry Pi

From Wikipedia, the free encyclopedia

Initial Setup

[edit]

The following rough guide applies to XBian.

SSH

[edit]

Connect:

ssh xbian@192.168.2.22

File copy from PI:

scp xbian@192.168.2.22:/home/xbian/zap2xml.tar.gz .

File copy to PI:

scp zap2xml.tar.gz xbian@192.168.2.22:/home/xbian/zap2xml.tar.gz

Disabling WIFI power saving

[edit]
sudo vi /etc/network/interfaces

Add the following line anywhere in the file:

wireless-power off

Set proper timezone

[edit]

TBD: There seems to be many possible location to set the timezone.

  • SSH:
dpkg-reconfigure tzdata
  • Kodi:
System > Config > TBD > TZ
System > Config > XBian > TBD > TZ

Builds

[edit]

Enable gcc, make...

sudo apt-get install build-essential

Install perl missing libs

[edit]
sudo perl -MCPAN -e shell
install JSON::XS

MPEG-2 License

[edit]

License key = 0x16baa230

Enable via:

sudo xbian-config

Tvheadend

[edit]

EPG Downloader

[edit]
  • Copy zap2xml config to PI using scp.
  • Set cron job to fetch EPG daily:
crontab -e
# m  h  dom mon dow   command
  33 3  *   *   *     /home/xbian/zap2xml/runZap2Xml.sh
  • Enable internal grabber in path:
cd /usr/local/bin
sudo ln -s /home/xbian/zap2xml/tv_grab_file

Frontend (Kodi)

[edit]

In Kodi TV interface:

  • Install Tvheadend HTSP Client
  • Config: point to localhost

Backend

[edit]

Basic setup

[edit]
  • Create default user via ssh:
tvheadend -C
  • Enable tvheadend services via:
sudo xbian-config

Channel setup

[edit]

The following is done using the web interface: http://192.168.2.22:9981 while logged in as admin.

Goto Config > DVB Input

  • Network tab: Add network us_ATSC_center_frequencies
  • TV Adapters tab: Assign network to tuner
  • Network tab: Force scan
  • Muxes tab: Check scan results.
  • Services tab: map all selected, map all services.

Goto Config > Channel/EPG

  • EPG Grabber tab: Set EPG frequency (advanced mode)
# MGouin custom to run 04:00 after zap2xml
0 4 * * *
  • EPG Grabber Modules tab: Enable Internal tv_grab_file
  • EPG Grabber Channels tab: Assign channels to each EPG channel
  • Channels tab: give proper channel names

DVR Setup

[edit]

Possible file naming scheme:

Refer to http://docs.tvheadend.org/webui/config_dvr/

Goto Configuration > Recording > Profile

$t$-e_%F$n.$x

Debugging

[edit]

Refer to: https://tvheadend.readthedocs.org/en/latest/Appendices/command_line_options/

Debug command:

tvheadend -d -u xbian -g xbian -c /home/xbian/.hts/tvheadend

Default command:

tvheadend -f -u xbian -g xbian -c /home/xbian/.hts/tvheadend

General Infos

[edit]

HD Recordings: 30 min = 4165 MB

Recordings DB:

/home/xbian/.hts/tvheadend/dvr/log


Tuner Test

[edit]

Hauppauge Xbox One

[edit]

This tuner works well. It has the same chip as the Hauppauge WinTV-HVR-955Q (refer to dmesg listing below:

 [35258.315869] usb 1-1.2: new high-speed USB device number 8 using dwc_otg
 [35258.406298] usb 1-1.2: New USB device found, idVendor=2040, idProduct=b123
 [35258.406312] usb 1-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
 [35258.406319] usb 1-1.2: Product: Hauppauge Device
 [35258.406326] usb 1-1.2: Manufacturer: Hauppauge
 [35258.406333] usb 1-1.2: SerialNumber: 4035698510
 [35258.439050] media: Linux media interface: v0.10
 [35258.458527] Linux video capture interface: v2.00
 [35258.501645] cx231xx 1-1.2:1.1: New device Hauppauge Hauppauge Device @ 480 Mbps (2040:b123) with 7 interfaces
 [35258.502036] cx231xx 1-1.2:1.1: Identified as Hauppauge WinTV-HVR-955Q (111401) (card=21)
 [35258.502540] i2c i2c-4: Added multiplexed i2c bus 6
 [35258.502627] i2c i2c-4: Added multiplexed i2c bus 7
 [35258.627172] cx25840 3-0044: cx23102 A/V decoder found @ 0x88 (cx231xx #0-0)
 [35258.645376] cx25840 3-0044: Direct firmware load for v4l-cx231xx-avcore-01.fw failed with error -2
 [35258.645394] cx25840 3-0044: unable to open firmware v4l-cx231xx-avcore-01.fw
 [35258.701895] tveeprom 6-0050: Hauppauge model 111401, rev E3I6, serial# 4035698510
 [35258.701909] tveeprom 6-0050: MAC address is 00:0d:fe:8b:df:4e
 [35258.701916] tveeprom 6-0050: tuner model is SiLabs Si2157 (idx 186, type 4)
 [35258.701925] tveeprom 6-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88)
 [35258.701932] tveeprom 6-0050: audio processor is CX23102 (idx 47)
 [35258.701940] tveeprom 6-0050: decoder processor is CX23102 (idx 46)
 [35258.701947] tveeprom 6-0050: has no radio, has IR receiver, has no IR transmitter
 [35258.702946] cx231xx 1-1.2:1.1: v4l2 driver version 0.0.3
 [35258.754970] cx231xx 1-1.2:1.1: Unknown tuner type configuring SIF
 [35258.780088] cx231xx 1-1.2:1.1: Registered video device video0 [v4l2]
 [35258.780230] cx231xx 1-1.2:1.1: Registered VBI device vbi0
 [35258.780243] cx231xx 1-1.2:1.1: video EndPoint Addr 0x84, Alternate settings: 5
 [35258.780256] cx231xx 1-1.2:1.1: VBI EndPoint Addr 0x85, Alternate settings: 2
 [35258.780266] cx231xx 1-1.2:1.1: sliced CC EndPoint Addr 0x86, Alternate settings: 2
 [35258.780275] cx231xx 1-1.2:1.1: TS EndPoint Addr 0x81, Alternate settings: 6
 [35258.780549] usbcore: registered new interface driver cx231xx
 [35258.796429] cx231xx 1-1.2:1.1: audio EndPoint Addr 0x83, Alternate settings: 3
 [35258.796447] cx231xx 1-1.2:1.1: Cx231xx Audio Extension initialized
 [35258.896630] si2157 7-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached
 [35258.896671] DVB: registering new adapter (cx231xx #0)
 [35258.896685] cx231xx 1-1.2:1.1: DVB: registering adapter 0 frontend 0 (LG Electronics LGDT3306A VSB/QAM Frontend)...
 [35258.902066] cx231xx 1-1.2:1.1: Successfully loaded cx231xx-dvb
 [35258.902086] cx231xx 1-1.2:1.1: Cx231xx dvb Extension initialized
 [35259.074624] si2157 7-0060: found a 'Silicon Labs Si2157-A30'
 [35259.123494] si2157 7-0060: firmware version: 3.0.5
 [35259.123547] cx231xx 1-1.2:1.1: DVB: adapter 0 frontend 0 frequency 0 out of range (55000000..858000000)

Maintenance

[edit]

Check

[edit]
mount
cat /etc/fstab
sudo fdisk -l
df -h
sudo btrfs-auto-snapshot list

Remove snapshots:

sudo -i
btrfs-auto-snapshot list | grep -v /@$ | grep auto-snap | xargs -L1 btrfs-auto-snapshot destroy

Correction

[edit]

TBD? btrfs how to check for filesystem integrity?

References

[edit]