Britannia Bridge

This article is about the road/rail bridge over the Menai Strait. For the rail bridge over the River Mersey, see Runcorn Railway Bridge.

Britannia Bridge Pont Britannia
The modern Britannia Bridge.
Coordinates	53°12′59″N 4°11′09″W
Carries	From 1850: North Wales Coast Line From 1980: A55
Crosses	Menai Strait
Locale	Anglesey, North Wales
Characteristics
Design	1850: Tubular bridge 1972: Two-tier truss arch bridge
Material	1850: Wrought Iron, Stone 1972: Steel, Concrete
Total length	461 metres (1,512 ft)
Width	16 metres (52 ft)
Height	40 metres (130 ft)
Longest span	140 metres (460 ft)
No. of spans	Four
Piers in water	One
Design life	Railway closed between: 23 May 1970 - 30 January 1972 Upper road deck opened: 1980
History
Designer	Robert Stephenson
Construction start	1846
Opened	5 March 1850
Location

Britannia Bridge (Welsh: Pont Britannia) is a bridge across the Menai Strait between the island of Anglesey and the mainland of Wales. It was originally designed and built by Robert Stephenson as a tubular bridge of wrought iron rectangular box-section spans for carrying rail traffic. Following a fire in 1970 it was rebuilt as a two-tier steel truss arch bridge, carrying both road and rail traffic.

The bridge design

The original box section Britannia Bridge, circa 1852.

Postcard picture of the bridge from circa 1886

The opening of the Menai Bridge in 1826, a mile (1.6 km) to the east of where Britannia Bridge was later built, provided the first fixed road link between Anglesey and the mainland. The increasing popularity of rail travel necessitated a second bridge to provide a direct rail link between London and the port of Holyhead, the Chester and Holyhead Railway.

Other railway schemes were proposed, including one in 1838 to cross Thomas Telford's existing Menai Bridge. Railway pioneer George Stephenson was invited to comment on this proposal but stated his concern about re-using the suspension bridge. By 1840, a Treasury committee decided broadly in favour of Stephenson's proposals, with final consent to the route including Britannia Bridge given in 1845. Stephenson's son Robert was appointed as chief engineer.

The design required the strait to remain accessible to shipping and the bridge to be sufficiently stiff to support the heavy loading associated with trains, so Stephenson constructed a bridge with two main spans of 460-feet (140-m) long rectangular iron tubes, each weighing 1,500 long tons (1,700 short tons) [1], supported by masonry piers, the centre one of which was built on the Britannia Rock. Two additional spans of 230-feet (70-m) length completed the bridge making a 1,511-feet (461-m) long continuous girder. The trains were to run inside the tubes. Up until then the longest wrought iron span had been 31 feet 6 inches (9.6 m).

Stephenson retained the services of two distinguished engineers as consultants. William Fairbairn was an old friend of his father. Eaton Hodgkinson was a leading theorist on strength of materials. Hodgkinson believed that it would be impractical to make the tubes stiff enough, and advised auxiliary suspension from chains. However, Fairbairn believed chains unnecessary declaring:

Provided that the parts are well-proportioned and the plates properly rivetted, you may strip off the chains and have it as a useful Monument of the enterprise and energy of the age in which it was constructed.

The consensus of received engineering opinion was with Hodgkinson, but Stephenson, rather nervously, backed Fairbairn's analysis. A 75 feet (23 m) span model was constructed and tested at Fairbairn's Millwall shipyard, and used as a basis for the final design. Although Stephenson had pressed for the tubes to be elliptical in section, Fairbairn's preferred rectangular section was adopted. Fairbairn was responsible both for the cellular construction of the top part of the tubes, and for developing the stiffening of the side panels.

Lions

One of four Monumental lions that stand at each corner of Britannia Bridge.

The bridge was decorated by four large lions sculpted in limestone by John Thomas, two at either end. These were immortalised in the following Welsh rhyme by the bard John Evans (1826 - 1888), who was born in nearby Porthaethwy :

Pedwar llew tew
Heb ddim blew
Dau 'ochr yma
A dau 'ochr drew

Four fat lions
Without any hair
Two on this side
And two over there

The lions cannot be seen from the A55 which crosses the modern bridge on the same site, although the idea of raising them to road level has been suggested from time to time.

Construction and use

Section of the original wrought-iron tubular bridge standing beside the modern crossing.

Begun in 1846, the bridge was opened on 5 March 1850. For its time, it was a bridge of "magnitude and singular novelty", far surpassing in length contemporary cast beam or plate girder iron bridges. One aspect of its method of construction was also novel; the box sections were assembled on-shore, then floated out into position before being gradually lifted into place using powerful jacks.

There was originally a railway station on the east side of the bridge at the entrance to the tunnel, run by the Chester and Holyhead Railway company, which served local rail traffic in both directions. This station closed after 8½ years in operation owing to low passenger volumes. Nothing now remains of the station other than the remnants of the lower-level station building.

The construction techniques employed on the Britannia Bridge influenced Isambard Kingdom Brunel in the construction of the Royal Albert Bridge across the River Tamar at Saltash.

Fire and reconstruction

During the evening of 23 May 1970 the bridge was greatly damaged when boys playing inside the bridge dropped a burning torch, setting alight the tar-coated wooden roof of the tubes (see Britannia Bridge Official Fire Report, BBC News video). Despite the best efforts of the Caernarfonshire and Anglesey fire brigades, the bridge's height, construction and the lack of an adequate water supply meant they were unable to control the fire which spread all the way across from the mainland to the Anglesey side. After the fire had burned itself out the bridge was still standing but the structural integrity of the iron tubes had been fatally compromised by the intense heat. As a consequence the bridge was completely rebuilt by Husband & Co.

The new design was for an arched bridge. Concrete supports were built under the approach spans and steel archways constructed under the long spans either side of the central Britannia Tower. The bridge reopened to rail traffic (albeit with only a single line of rails and with reduced speed) on 30 January 1972. Over subsequent months the original box tubes were removed and the stonework of the towers was restored. The original deck below the rail lines was cosmetically restored.

In 1980, almost 10 years after the fire, the upper road level opened, carrying a single-carriageway section of the A55 road.

Proposed bridge improvement

A 1868 engraving showing Robert Stephenson (seated centre) with the engineers that designed and built the Britannia Bridge.

In November 2007, a Public Consultation exercise into the ‘A55 Britannia Bridge Improvement’ commenced. The perceived problems stated include:

• It is the only non dual carriageway section along the A55
• Congestion during morning and afternoon peak periods
• Congestion from seasonal and ferry traffic from Holyhead
• Queuing at the junctions at either end
• Traffic is expected to significantly increase over the next 10 years or so

In the document, four options are presented, each with their own pros and cons:

• Do Nothing. Congestion will increase as traffic levels increase.
• Widen Existing Bridge. To do this, the towers would have to be removed to make room for the extra lanes. This is an issue as the bridge is a Grade 2 Listed Structure and also as the bridge is owned by Network Rail. The extra lanes would have to be of reduced width as the existing structure is not capable of supporting 4 full width lanes.
• New multi span concrete box bridge alongside. Building a separate bridge would allow the existing bridge to be used as normal during construction. The bridge would require support pillar(s) in the Menai Strait which is an environmental issue as the Strait is a Special Area of Conservation. Visual impact would be low as the pillars and road surface would be aligned with the current bridge.
• New Single Span Cable Stayed Bridge. This would obviate the need for pillars in the Strait, but the bridge would have a large impact on the landscape due to the height of the cable support pillars. This is also the most costly option.

Respondents were overwhelmingly in favour of seeing some improvements, with 70% favouring the solution of building a second bridge.

Similar Bridges

Very few other tubular iron bridges were ever built since more economical bridge designs were soon developed. The most notable of the other tubular bridges were Stephenson's Conwy railway bridge between Llandudno Junction and Conwy, and Victoria Bridge across the Saint Lawrence River at Montreal.

The Conwy railway bridge remains in use, and is the only remaining tubular bridge; however, intermediate piers have been added to strengthen it. The bridge can be seen at close quarters from Thomas Telford's adjacent 1826 Conwy Suspension Bridge.

The Victoria Bridge was the first bridge to cross the St. Lawrence River, and was the longest bridge in the world when it was completed in 1859. It was rebuilt as a truss bridge in 1898.

See also

• List of bridges in Wales

Bibliography

• Norrie, Charles Matthew (1956) Bridging the Years - a short history of British Civil Engineering, Edward Arnold (Publishers) Ltd
• Rolt, L.T.C. (1960) George and Robert Stephenson: The Railway Revolution, Penguin, Ch. 15, ISBN 0-14-007646-8
• Rapley, John (2003) The Britannia and other Tubular Bridges, Tempus, ISBN 0-7524-2753-9

External links

• Britannia Bridge (1850) at Structurae
• Britannia Bridge (1905) at Grandad's Photograph Album
• Britannia Bridge, Bangor entrance showing lion (1905) at Grandad's Photograph Album
• Britannia Bridge (1971) at Structurae
• General description of the Britannia and Conway tubular bridges on the Chester and Holyhead Railway, 1849, from Google Book Search
• In 1969 the BBC show Bird's Eye View captured an aerial view of a train crossing the bridge in the episode Man on the Move. Available in the online BBC Archives, the Britannia Bridge segment appears at the 25:47 mark.
• The Night the Bridge Caught Fire BBC programme page