The Motorola 68881 and Motorola 68882 were floating-point coprocessor (FPU) devices that were used in some computer systems in conjunction with the 68020 or 68030 microprocessors. The addition of one of these devices added substantial cost to the computer, but added a floating point unit that could rapidly perform floating point mathematical calculations. At the time, this feature was useful mostly for scientific and mathematical software.
The 68020 and 68030 CPUs were designed with the separate 68881 chip in mind. Their instruction sets reserved the "F-line" instructions — that is, all opcodes beginning with the hexadecimal digit "F" were "traps" which would throw an interrupt, handing control to the computer's operating system. If a 68881 is present in the system, the CPU would allow it to execute the instruction. If not, the OS would either call an FPU emulator to execute the instruction using 68020 integer-based software code, or would return an error code to the program.
The 68881 had eight 80-bit data registers (a 64-bit mantissa plus a sign bit, and a 15-bit signed exponent). It allowed seven different modes of numeric representation, including single-precision, double-precision, and extended-precision, as defined by the IEEE floating-point standard, IEEE 754. It was designed specifically for floating-point math and was not a general-purpose CPU. For example, when an instruction required any address calculations, the main CPU would handle them before the 68881 took control.
The CPU/FPU pair were designed such that both could run at the same time. When the CPU encountered a 68881 instruction, it would hand the FPU all operands needed for that instruction, and then the FPU would release the CPU to go on and execute the next instruction.
The 68882 was an improved version of the 68881, with better pipelining, and eventually available at higher clock speeds. Its instruction set was exactly the same as that of the 68881. Motorola claimed in some marketing literature that it executed some instructions 40% faster than a 68881 at the same clock speed, though this did not reflect typical performance, as seen by its more modest improvement in the table below. The 68882 is pin compatible with the 68881 and can be used as a direct replacement in most systems.
Notable computers including 68881 or 68882 FPUs included the Sun 3 from Sun Microsystems, the Macintosh II family of computers from Apple Computer, the NeXT Computer, parts of the Atari family (Mega STE, TT and Falcon030) and the Commodore Amiga 3000. Some third-party Amiga and Atari products used the 68881 or 68882 as a memory-mapped peripheral to the 68000.
When the Motorola 68040 processor was introduced, it included the FPU internally. Most instructions and numeric representation modes from the 68881 were supported in hardware, but some were not, and were emulated in software.
- 155 000 transistors on-chip
- 16 MHz version ran at 160 kFLOPS
- 20 MHz version ran at 192 kFLOPS
- 25 MHz version ran at 240 kFLOPS
- 176 000 transistors on-chip
- 25 MHz version ran at 264 kFLOPS
- 33 MHz version ran at 352 kFLOPS
- 40 MHz version ran at 422 kFLOPS
- 50 MHz version ran at 528 kFLOPS
- 25 MHz FPU ran at 3.500 MFLOPS
- 33 MHz FPU ran at 4.662 MFLOPS
- 40 MHz FPU ran at 5.600 MFLOPS
These statistics came from the comp.sys.m68k FAQ. No statistics are listed for the 16 MHz and 20 MHz 68882, though these chips were indeed produced.