Rimfire ammunition

Rimfire ammunition, from left to right, .22 Short, .22 Long Rifle, .22 WMR, .17 HM2, .17 HMR

A rimfire is a type of firearm cartridge. It is called a rimfire because, instead of the firing pin striking the primer cap at the center of the base of the cartridge to ignite it (as in a centerfire cartridge), the pin strikes the base's rim. The rimfire cartridge is essentially an extended and widened percussion cap which contains not only the priming compound, but also the propellant powder and the projectile (bullet). Once the cartridge has been struck and discharged it cannot be reloaded, as the head is deformed by the firing pin impact. While many different cartridge priming methods have been tried, only rimfire and centerfire survive today in significant use.

Characteristics

Rimfire cartridges, due to the thin case they must have, are limited to low pressure calibers. Although rimfire calibers up to .44 (11 mm) were once common, modern rimfires tend to be of caliber .22 (5.5 mm) or smaller. The low pressures mean that rimfire firearms can be very light and inexpensive, which has helped lead to the continuing popularity of the small caliber rimfire cartridges.

Economics

Rimfire cartridges are typically inexpensive, due primarily to large production quantities. Up until 2002, a "brick" of 500 inexpensive .22 Long Rifle cartridges typically cost less than US$10.00. During the years 2003 to 2007, the price of metals used in cartridges (lead, copper and zinc) increased in price over 400% which caused the typical price of a "brick" of .22 long rifle cartridges to increase to $15.00 to $20.00, with single boxes of 50 rounds going for about $1.75 to $2.50 each. Premium or match-grade .22 Long Rifle cartridges, as well as less common or out-of-production rimfire cartridges (such as the .22 Short, .22 Long, .22 Extra Long, .22 Winchester Auto, .22 WMR, and 5 mm Remington) can cost substantially more.

History

The first rimfire cartridge was the .22 BB Cap, which used no gunpowder by relying entirely on the priming compound for propulsion. Dating back to 1857, the .22 BB Cap is essentially just a percussion cap with a round ball pressed in the front, and a rim to hold it securely in the chamber. Velocities are very low, comparable to an airgun, as the round was intended for use in indoor shooting galleries. The next rimfire cartridge was the .22 Short, developed for Smith and Wesson's first revolver; it used a longer rimfire case and 4 grains (260 mg) of black powder to fire a conical bullet. This led to the .22 Long, with a longer case and 5 grains (320 mg) of black powder. The .22 Long Rifle is a .22 Long case loaded with a longer, heavier bullet intended for better performance in the long barrel of a rifle. The .22 Long Rifle is the most common cartridge in the world. While larger rimfire calibers were made, such as the .41 Rimfire Short, the .44 Henry Flat devised for the famous Henry Repeating Rifle, up to the .58 Miller, the larger calibers were quickly replaced by centerfire versions, and today the .22 caliber rimfires are all that survive of the early rimfires. The early 21st century has seen a revival in interest in rimfire cartridges, with two new rimfires introduced, both in .17 caliber (4.5 mm).

Below is a list of the most common current production rimfire ammunition:

• The powderless .22 Cap rounds, including BB Cap, CB Cap, and CB Long versions
• .22 Short, used for target shooting and Olympic and ISSF 25 m Rapid Fire Pistol competition until 2005
• .22 Long (obsolete)
• .22 Long Rifle (.22 LR), the most common cartridge made
• .22 Stinger (slightly longer case, same overall loaded length - the basis for the .17 HM2
• .22 Extra Long (Obsolete)
• .22 Winchester Rimfire (.22 WRF) AKA .22 Remington Special (obsolete)
• .22 Winchester Magnum Rimfire (.22 WMR)
• .17 Hornady Magnum Rimfire (.17 HMR), a .17 caliber based on the .22 WMR case
• .17 Hornady Mach 2 (.17 HM2), a .17 caliber based on the .22 Stinger case

A new and increasingly popular rimfire, the 17 HMR is basically a .22 WMR with a smaller formed neck which accepts a .17 bullet. The advantages of the 17 HMR over .22 WMR and other rimfires are its much flatter trajectory and its highly frangible hollow point bullets (often with plastic "ballistic tips" that improve the external ballistics performance). The even newer .22 Long Rifle based .17 Hornaday Mach 2 and offers similar performance advantages over its parent cartridge, at a higher cost. While .17 HM2 sells for about US$6.00 per box of 50 rounds, six times the cost of inexpensive .22 Long Rifle ammunition, it is still significantly cheaper than most centerfire ammunition, and somewhat cheaper than the .17 HMR.

A notable rimfire still in production in Europe is the 9 mm Flobert, which can fire a small ball, or even a small amount of shot like a small shotgun shell. The 9 mm flobert is often called a "garden gun" in the UK, as its power and range are minimal, and it is well-suited for use in gardens, where the next-largest shotgun (a .410 bore) would be too devastating amongst the cabbages. The 9 mm Flobert is used to eradicate vermin such as mice and rats, and pigeons roosting in sheds.

Shot

There is a type of ammunition for the .22LR that fires a small amount of #12 shot (about 1/15th ounce). The shot is only marginally effective in close ranges, and is usually used for shooting rats or other small animals. At a distance of about 10 feet (3 meters) the pattern is about 8 inches (20 cm) in diameter from a standard rifle, which is about the maximum effective range. Special smoothbore shotguns, such as Marlin's Garden Gun can produce effective patterns out to 15 or 20 yards using .22 WMR shotshells, which hold 1/8 oz. of #11 shot.

Shotshells may not feed reliably in some magazine fed firearms, due to their unusual shape or relatively fragile plastic tips. Shotshells may also not produce sufficient power to cycle some semiautomatic actions.

References

• Marlin's "Garden Gun" - Model 25MG Guns Magazine, March, 2000 by Clair Rees