Phases of fluorine
![]() | This article may require cleanup to meet Wikipedia's quality standards. The specific problem is: Cite errors. (May 2013) |
![]() | This article is actively undergoing a major edit for a little while. To help avoid edit conflicts, please do not edit this page while this message is displayed. This page was last edited at 17:25, 12 May 2013 (UTC) (11 years ago) – this estimate is cached, . Please remove this template if this page hasn't been edited for a significant time. If you are the editor who added this template, please be sure to remove it or replace it with {{Under construction}} between editing sessions. |
Fluorine forms diatomic molecules (F
2) that are gaseous at room temperature with a density about 1.3 times that of air.[1][note 1] Though sometimes cited as yellow-green, pure fluorine gas is actually a very pale yellow. The color can only be observed in concentrated fluorine gas when looking down the axis of long tubes, as it appears transparent when observed from the side in normal tubes or if allowed to escape into the atmosphere.[3] The element has a "pungent" characteristic odor that is noticeable in concentrations as low as 20 ppb.[4]
Fluorine condenses to a bright yellow liquid at −188 °C (−307 °F),[5] which is near the condensation temperatures of oxygen and nitrogen.
The solid state of fluorine relies on Van der Waals forces to hold molecules together,(ref) which, because of the small size of the fluorine molecules, are relatively weak. Consequently, the solid state of fluorine is more similar to that of oxygen or the noble gases than to those of the heavier halogens.(ref) Fluorine solidifies at −220 °C (−363 °F)[5] into a cubic structure, called beta-fluorine. This phase is transparent and soft, with significant disorder of the molecules. At −228 °C (−378 °F) fluorine undergoes a solid–solid phase transition into a monoclinic structure called alpha-fluorine. This phase is opaque and hard, with close-packed layers of molecules. The solid state phase change requires more energy than the melting point transition and can be violent, shattering samples and blowing out sample holder windows. In general, fluorine's solid state is more similar to oxygen's than to the other halogens'.[6][7]
![]() |
![]() |
Low-temperature fluorine phases | Alpha-fluorine crystal structure |
References
- ^ Jassaud et al. 2005, p. 2.
- ^ Shelquist, Richard (2010). "An introduction to air density and density altitude calculations". Shelquist Engineering. Retrieved 29 April 2011.
- ^ Burdon, J.; Emson, B.; Edwards, A. J. (1987). "Is fluorine really yellow?". Journal of Fluorine Chemistry. 34 (3–4): 471–474. doi:10.1016/S0022-1139(00)85188-X.
- ^ Cite error: The named reference
Water
was invoked but never defined (see the help page). - ^ a b Dean 1999, p. 523.
- ^ Cite error: The named reference
phases
was invoked but never defined (see the help page). - ^ Attention: This template ({{cite doi}}) is deprecated. To cite the publication identified by doi:10.1063/1.1711946, please use {{cite journal}} (if it was published in a bona fide academic journal, otherwise {{cite report}} with
|doi=10.1063/1.1711946
instead.
Cite error: There are <ref group=note>
tags on this page, but the references will not show without a {{reflist|group=note}}
template (see the help page).