Jump to content

Revolute joint

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 89.101.83.208 (talk) at 22:32, 5 September 2022. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Revolute joint cutaway view
Revolute joint with shoulders cutaway view
Revolute joint with and without shoulders cutaway view

A revolute joint (also called pin joint or hinge joint) is a one-degree-of-freedom kinematic pair used frequently in mechanisms and machines.[1] The joint constrains the motion of two bodies to pure rotation along a common axis. The joint does not allow translation, or sliding linear motion, a constraint not shown in the diagram. Almost all assemblies of multiple moving bodies include revolute joints in their designs. Revolute joints are used in numerous applications such as door hinges, mechanisms, and other uni-axial rotation devices.[2]

A revolute joint is usually made by a pin or knuckle joint, through a rotary bearing. It enforces a cylindrical contact area, which makes it a lower kinematic pair, also called a full joint. However, If there is any clearance between the pin and hole (as there must be for motion), so-called surface contact in the pin joint actually becomes line contact.[3]

The contact between the inner and outer cylindrical surfaces is usually assumed to be frictionless. But some use simplified models assume linear viscous damping in the form , where T is the friction torque, ω is the relative angular velocity, and B is the friction constant. Some more complex models take stiction and stribeck effect into consideration.[4]

The door handle rotates an internal revolute joint to retract or release the latch bolt of the spring latch

See also

References

  1. ^ Norton, Robert L. (2008). "2". Design of Machinery (4th ed.). Boston, MA: McGraw Hill Higher Education. p. 33. ISBN 978-0-07-312158-1.
  2. ^ Robotics Research Group. "Joint Types". University of Texas at Austin. Archived from the original on 2009-03-11. Retrieved 2009-02-04.
  3. ^ Norton, Robert L. Design of machinery: an introduction to the synthesis and analysis of mechanisms and machines. Boston: McGraw-Hill Higher Education, 2004. p. 31.
  4. ^ Moore, Jacobs. "Bearing Friction". Mechanics Map. Retrieved June 6, 2020.