Jump to content

Ohio State Route 797

Route map:
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Lorax (talk | contribs) at 04:57, 22 October 2023 (Changing short description from "Highway in Ohio" to "State highway in Muskingum County, Ohio, US"). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

State Route 797 marker
State Route 797
Map of SR 797 from 1965 until 2003
Route information
Maintained by ODOT
Length1.19 mi[1] (1.92 km)
Existed1946–2013
Major junctions
South end US 22 / US 40 near Zanesville
North end I-70 near Zanesville
Location
CountryUnited States
StateOhio
CountiesMuskingum
Highway system
  • Ohio State Highway System
SR 796 SR 798

State Route 797 (SR 797) was a very short, unsigned north–south state highway in the eastern portion of the U.S. state of Ohio. At the time of its deletion of the route from the state highway system, SR 797 ran from its southern terminus at the U.S. Route 22/U.S. Route 40 concurrency about 4.75 miles (7.64 km) northeast of Zanesville to its northern terminus less than 0.40 miles (0.64 km) to the northwest at Interstate 70 at its exit 160, a diamond interchange. North of the interchange, the road continues to Sonora on Muskingum County Road 52, Sonora Road.

SR 797 was created in the middle of the 1940s. For most of its history, this two-lane highway was a spur route that served to connect Zanesville Municipal Airport to the state highway system, specifically US 22/US 40, in the eastern half of Muskingum County. The highway was extended slightly to the northwest in the mid-1960s when I-70 was opened in the vicinity. However, in the early 2000s, maintenance of the portion of SR 797 between US 22/US 40 and Zanesville Municipal Airport was transferred from state control to Muskingum County. The remainder of the route was transferred to the county in 2013.

Route description

The short path of SR 797 existed entirely within Perry Township in the eastern half of Muskingum County. This route is not included within the National Highway System, a network of routes deemed most important for the economy, mobility and defense of the country.[2]

The southern portion of the route began at Airport Road just north of the Zanesville Municipal Airport. SR 797 traveled north along Airport Road just north of the intersection with Airpark Drive (Muskingum County Road 797). The road is lined with small homes. The route intersected US 22 and US 40 at a four-way stop intersection with a flashing beacon. The intersection of the routes was amidst a commercial strip that typically appears adjacent to a freeway interchange. The highway traveled a very short distance from this intersection to the northwest before it meets I-70 at its exit 160, a diamond interchange. This point served as SR 797's endpoint. Continuing northwest from this location is Sonora Road (CR 52).[3]

History

SR 797 was established in 1946. At the time, it was a spur route that ran from US 22/US 40 southeastward along Airport Road to Zanesville Municipal Airport.[4][5] When I-70 was completed around and to the east of Zanesville in 1965, SR 797 was extended a short distance north to end at the Interstate's exit 160.[6][7] On April 3, 2003, SR 797 southeast of US 22/US 40 was removed from the state highway system, with jurisdiction being transferred to Muskingum County.[8] The roadway became known as Airport Road and CR 796.[9] As of December 2013, the remaining portion of SR 797 was transferred to county jurisdiction.[10] The road between US 22/US 40 and I-70 has been redesignated as an extension of CR 52, Sonora Road.[11]

Major intersections

The entire route was in Perry Township, Muskingum County.

mi[1]kmDestinationsNotes
0.000.00Airport Road – Zanesville Municipal AirportSouthern terminus 1946–2003
0.921.48 US 22 / US 40Northern terminus 1946–1965, southern terminus 2003–2014
1.01–
1.19
1.63–
1.92
I-70 / CR 52 (Sonora Road) – Columbus, Wheeling, WV, SonoraExit 160 (I-70); northern terminus 1965–2014
1.000 mi = 1.609 km; 1.000 km = 0.621 mi

References

KML is from Wikidata
  1. ^ a b "2003 Muskingum Co. Average 24-Hour Traffic Volume" (PDF). Ohio Department of Transportation. 2003. p. 7. Retrieved September 6, 2014.
  2. ^ National Highway System: Ohio (PDF) (Map). Federal Highway Administration. December 2003. Retrieved 2011-01-27.
  3. ^ "Ohio State Route 797" (Map). Google Maps. Retrieved September 6, 2014.
  4. ^ Ohio Highway Map (MrSID) (Map). Cartography by ODOH. Ohio Department of Highways. 1945. Retrieved 2011-01-26.
  5. ^ Ohio Highway Map (MrSID) (Map). Cartography by ODOH. Ohio Department of Highways. 1946. Retrieved 2011-01-26.
  6. ^ Ohio Highway Map (MrSID) (Map). Cartography by ODOH. Ohio Department of Highways. 1964. Retrieved 2011-01-26.
  7. ^ Ohio Highway Map (MrSID) (Map). Cartography by ODOH. Ohio Department of Highways. 1965. Retrieved 2011-01-26.
  8. ^ "Straight-Line Diagrams County Update Table (Muskingum County, 2006)". Ohio Department of Transportation.
  9. ^ MUSKINGUM COUNTY, OHIO 2009 HIGHWAY MAP (PDF) (Map). Muskingum County Engineer's Office. 2009. Retrieved November 20, 2013.
  10. ^ "2013 County Highway System Mileage Certification (Muskingum County)" (PDF). ODOT. December 31, 2013. p. 2. Retrieved October 10, 2014. C 0052 | SONORA RD | 0.085 | TRANSFER PART OF SR797 TO CO.
  11. ^ "Roadway Description Inventory Report - DESTAPE (Muskingum County)" (PDF). Ohio Department of Transportation. July 3, 2014. p. 55-57. Retrieved September 6, 2014. SR 797 is not listed at all in the inventory; the intersection of Airport Road at US 22 on page 5 is listed as CR 796 (Airport Road) and CR 52 (Sonora Road).{{cite web}}: CS1 maint: postscript (link)