Jump to content

Deadwood Formation

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Monkbot (talk | contribs) at 03:47, 18 September 2019 (References: Task 16: replaced (1×) / removed (0×) deprecated |dead-url= and |deadurl= with |url-status=;). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Deadwood Formation
Stratigraphic range: Late Cambrian-Early Ordovician
~510–470 Ma
The Deadwood Formation at Fallingrock cliff in Dark Canyon in the Black Hills, South Dakota.
TypeFormation
UnderliesRed River, Winnipeg & Englewood Formations & Elk Point Group
OverliesPrecambrian rocks, or Lebold Formations Earlie and Pika Formations
Lithology
PrimarySandstone
OtherConglomerate, shale, limestone
Location
RegionWilliston Basin and Western Canada Sedimentary Basin
Country United States
 Canada
Type section
Named forDeadwood, South Dakota
Named byDarton, N.H. and Paige, S. (1925)[1]

The Deadwood Formation is a geologic formation of the Williston Basin and Western Canada Sedimentary Basin. It is present in parts of North and South Dakota and Montana in the United States, and in parts of Alberta, Saskatchewan, and southwestern corner of Manitoba in Canada. It is of Late Cambrian to Early Ordovician age and was named for exposures in Whitewood Creek near Deadwood, South Dakota.[2] It is a significant aquifer in some areas, and its conglomerates yielded significant quantities of gold in the Black Hills of South Dakota.[3]

It preserves trace fossils such as Skolithos, and remains of Late Cambrian trilobites and brachiopods,[4] as well as Ordovician fossils.

Stratigraphic position

The angular unconformity between the Deadwood Formation and the underlying Precambrian metamorphic rocks near Rapid City, South Dakota.

At the type locality in the Black Hills of South Dakota and in many other areas, the Deadwood Formation rests unconformably on Precambrian metamorphic rocks that were exposed to a long period of erosion prior to the deposition of the formation. In western Montana, western Saskatchewan and Alberta it overlies the Middle Cambrian rocks of the Earlie Formation or the Pika Formation.[2]

In the Williston Basin it is overlain by the Winnipeg Formation in the center and by the Red River Formation near the margins. In the central and southern Black Hills it is overlain by the Mississippian Englewood Formation. In Alberta and Saskatchewan it is overlain by the Devonian Elk Point Group.[2]

Lithology

In the type area, the Deadwood Formation consists of a basal conglomerate and buff sandstones, overlain a sequence of by grey-green shales, carbonate rocks, and glauconitic quartzose sandstones. Skolithos borings are present in some units.[2] The Deadwood conglomerates contained significant quantities of gold in the Black Hills.[3]

In Saskatchewan the Deadwood consists of fine to very coarse, commonly glauconitic, micaceous, feldspathic, slightly argillaceous and calcareous quartzose sandstones, with minor shales and conglomerates. Conglomerates are common near the base of the formation. They typically consist of Precambrian rock fragments set in finer-grained sediments, and are normally poorly sorted and unstratified.[5]

Environment of deposition

In most areas the sediments of the Deadwood Formation were deposited in near shore, shallow water environments as an ancient sea advanced across the exposed and weathered landscape of Precambrian rocks. Most of the conglomerates appear to be matrix-supported debris flow deposits.[5]

Thickness and distribution

The Deadwood Formation is present beneath large areas of the northern plains, and its thickness can vary over short distances due largely to the substantial topographic relief on the eroded Precambrian surface.[5] It reaches thicknesses of up to about 270 metres (890 ft) in the northern Black Hills. It thins to zero eastward and is absent in northeastern North Dakota and most of eastern Saskatchewan. It is present in the extreme southwestern corner of Manitoba where it may reach thicknesses of 30 metres (100 ft). It thickens westward throughout Saskatchewan and Montana to the Saskatchewan-Alberta border, where it exceeds 300 metres (980 ft). From there it thins towards the mountain front to the west. In the north the formation extends almost to 55°N latitude.[2]

See also

References

  1. ^ Darton, N.H. and Paige, S. (1925). Description of the central Black Hills. U.S. Geological Survey, Professional Paper 65.
  2. ^ a b c d e Glass, D.J. (editor) 1997. Lexicon of Canadian Stratigraphy, vol. 4, Western Canada including eastern British Columbia, Alberta, Saskatchewan and southern Manitoba. Canadian Society of Petroleum Geologists, Calgary, 1423 p. on CD-ROM. ISBN 0-920230-23-7.
  3. ^ a b Irving, J.D., Emmons, S.F. and Jaggar, T.A. (1904). Ore deposits in Cambrian rocks: Gold-bearing conglomerates. Part 2, Chapter 2, p. 98-11, in U.S. Geological Survey, Professional Paper 26. Retrieved 2014-10-04.{{cite book}}: CS1 maint: multiple names: authors list (link)
  4. ^ J. Foster, 2014. Cambrian ocean world: Ancient sea life of North America. Indiana University Press, 432 p., ISBN 0253011884, 9780253011886
  5. ^ a b c Fuzesy, L.M. 1980. Geology of the Deadwood (Cambrian), Meadow Lake and Winnipegosis (Devonian) Formations in west-central Saskatchewan. Saskatchewan Mineral Resources, Report 210, 64 p.