Jump to content

IBM 727

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Rich Farmbrough (talk | contribs) at 18:31, 16 October 2019 (clean up). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

An IBM 704 mainframe with IBM 727 tape drives on the left. (image courtesy of LLNL)
Half-inch tape reel with write protect rings
Model of an IBM 7272 tape drive

The IBM 727 Magnetic Tape Unit was announced for the IBM 701 and IBM 702 on September 25, 1953. It became IBM's standard tape drive for their early vacuum tube era computer systems. Later vacuum tube machines and first-generation transistor computers used the IBM 729-series tape drive. The 727 was withdrawn on May 12, 1971.[1]

The tape had seven parallel tracks – six for data and one to maintain parity. Tapes with character data (BCD) were recorded in even parity. Binary tapes used odd parity. Aluminum strips were glued several feet from the ends of the tape to serve as logical beginning and end of tape markers. Write protection was provided by a removable plastic ring in the back of the tape reel.

tracks 6 data, 1 parity
chars/inch 200 characters/inch
Tape speed 75 inches/second
Rewind speed 500 inches/second (average)
Transfer rate 15,000 characters/second
Start time 5 milliseconds
Stop time 5 milliseconds
Width of tape 1/2 inches
Length of reel 2,400 feet
Composition PET film (Mylar) or cellulose acetate base

References

  1. ^ "IBM 727 Magnetic tape unit". IBM.