Jump to content

Kayaba Ka-1

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Steelpillow (talk | contribs) at 16:14, 21 July 2020 (Variants: Ka-Go). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Ka-1 / Ka-2
Kayaba Ka-1
Role Autogyro
Manufacturer Kayaba Industry
First flight 26 May 1941
Primary user Imperial Japanese Army Air Service
Produced 1941-1945
Number built 98
Developed from Kellett KD-1A

The Kayaba Ka-1 and Ka-2 were Japanese autogyros, seeing service during World War II for artillery spotting.

Design and development

The Imperial Japanese Army (IJA) developed the Ka-1 autogyro for reconnaissance, artillery-spotting, and anti-submarine uses. The Ka-1 was based on an American design, the Kellett KD-1A, which had been imported to Japan in 1939, but which was damaged beyond repair shortly after arrival.[1] Kayaba Industry was tasked by the IJA to develop a similar machine, and the first prototype was flying on 26 May 1941.[1] The craft was initially developed for use as an observation platform and for artillery spotting duties. The IJA liked the craft's short, (30 m (98 ft)) take-off run, and its low maintenance requirements. Production began in 1941 and the first autogyros were assigned to artillery units for artillery spotting, crewed by pilot and spotter.

The prototype Ka-Go was a repaired Kellett KD-1A powered by a 240 hp (180 kW) Argus As 10c. It went into production as the Ka-1 and about 20 were produced.[2]

Production continued as the Ka-2, powered by Jacobs L-4MA-7 engines, similar to the Kellett KD-1. During production, a shortage of critical components for rotors and engines resulted in severe delivery delays.

A total of 98 Ka-1 and Ka-2 airframes were produced by the end of war, of them 12 were destroyed before being delivered to the IJA, around 30 never had engines installed. About 50 were delivered to the IJA, but only 30 were actually deployed.[1] Some sources have stated that 240 were built, but this cannot be verified.

Operational history

The first Ka-1 (the repaired Kellett KD-1A), first took off from Tamagawa Airfield in May 26, 1941. In the following Army trials, performance was deemed excellent. Originally, it was planned to send the Ka-1 to spot for the artillery units based in mainland China, but the change of the course of war in that theater rendered those plans meaningless. Instead, a few Ka-1 were sent to the Philippines to perform the duties of liaison aircraft as replacements for the Kokusai Ki-76. After some time the IJA finally decided on the best use of these unique aircraft, and the majority of Ka-1 and Ka-2 were pressed into service as anti-submarine patrol aircraft. Pilot training for this speciality started in July 1943 with the first batch of 10 pilots graduating in February 1944; followed by another batch of 40 pilots in September 1944.

Originally, the plan was to deploy the Ka-1/Ka-2 from 2D-class cargo ships to spot enemy submarines, but these ships turned out to be too cramped for operations; therefore the Ka-1/Ka-2 unit was assigned to the Army-operated escort carrier Akitsu Maru from August 1944 until her sinking in November 1944. From 17 January 1945 ASW patrols were resumed from an airstrip on Iki Island with a maintenance base located at Gannosu Airfield in Fukuoka prefecture. ASW patrols also started from May 1945 from Izuhara airfield on Tsushima Island. These missions helped to protect one of the last operational Japanese sea lanes between the ports of Fukuoka and Pusan. Eventually U.S. carrier-based aircraft began to appear even in the Tsushima Strait, so in June 1945 the Ka-1/Ka-2 units were relocated to Nanao base on the Noto Peninsula, in the Sea of Japan, operating from there until the end of the war. The Ka-1/Ka-2 did not directly sink any submarines during the war, however, they were well regarded for issuing submarine warnings.[clarification needed][citation needed]

Variants

  • Ka-Go: Prototype built around a repaired Kellett autogyro.
  • Ka-1: Imperial Japanese Army development of the Ka-Go, powered by a 240 hp (180 kW) Argus As 10 engine.
  • Ka-2: Imperial Japanese Army development of the Ka-1, powered by a 245 hp (183 kW) Jacobs L-4MA-7 engine.

Specifications (Ka-1)

Data from Japanese Aircraft of the Pacific War[1]

General characteristics

  • Crew: 2
  • Length: 9.2 m (30 ft 2 in)
  • Empty weight: 775 kg (1,709 lb)
  • Gross weight: 1,086 kg (2,394 lb)
  • Max takeoff weight: 1,170 kg (2,579 lb)
  • Powerplant: 1 × Argus As 10c inverted V-8 air-cooled piston engine, 180 kW (240 hp)
  • Main rotor diameter: 12.2 m (40 ft 0 in)
  • Main rotor area: 116.9 m2 (1,258 sq ft) 3-bladed auto-rotating rotor
  • Propellers: 2-bladed wooden fixed-pitch propeller

Performance

  • Maximum speed: 165 km/h (103 mph, 89 kn)
  • Cruise speed: 115 km/h (71 mph, 62 kn)
  • Range: 280 km (170 mi, 150 nmi)
  • Service ceiling: 3,500 m (11,500 ft)
  • Rate of climb: 5 m/s (980 ft/min)
  • Time to altitude: 1,000 m (3,300 ft) in 3 min 20 seconds, 2,000 m (6,600 ft) in 7 min 30 seconds
  • Disk loading: 10 kg/m2 (2.0 lb/sq ft)
  • Power/mass: 0.152 kW/kg (0.093 hp/kg)

Armament
2x 60 kg (130 lb) depth-charges

References

  1. ^ a b c d Francillon, Rene (1979). Japanese Aircraft of the Pacific War. London: Putnam & Company Limited. pp. 143–145. ISBN 0 370 30251 6.
  2. ^ "European Helicopter Pioneers". www.vectorsite.net. Archived from the original on 29 June 2011. Retrieved 15 August 2010.