Jump to content

File size

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 2600:6c5d:4400:182b:8d55:4b94:a4f2:bdfc (talk) at 22:31, 7 August 2020 (I updated the URL for the first reference cause the old one only brings up a "Page not found". Old link: http://www.jedec.org/down)d/search/JESD100B01.pdf). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

File size is a measure of how much data a computer file contains or, alternately, how much storage it consumes. Typically, file size is expressed in units of measurement based on the byte. By convention, file size units use either a metric prefix (as in megabyte and gigabyte) or a binary prefix (as in mebibyte and gibibyte).[1]

When a file is written to a file system, which is the case in most modern devices, it may consume slightly more disk space than the file requires. This is because the file system rounds the size up to include any unused space left over in the last disk sector used by the file. (A sector is the smallest amount of space addressable by the file system. The size of a disk sectors is several hundred or several thousands bytes.) The wasted space is called slack space or internal fragmentation.[2] Although smaller sector sizes allow for denser use of disk space, they decrease the operational efficiency of the file system.

The maximum file size a file system supports depends not only on the capacity of the file system, but also on the number of bits reserved for the storage of file size information. The maximum file size in the FAT32 file system, for example, is 4,294,967,295 bytes, which is one byte less than four gibibytes.[3]

Conversion table
Traditional units Decimal for comparison
Name IEC Binary Number of bytes Equal to Name IEC Decimal Number of bits Equal to
Kibibyte KiB 210 1,024 1024 B Kilobit kbit 103 1,000 1000 bit
Mebibyte MiB 220 1,048,576 1024 KiB Megabit Mbit 106 1,000,000 1000 kbit
Gibibyte GiB 230 1,073,741,824 1024 MiB Gigabit Gbit 109 1,000,000,000 1000 Mbit
Tebibyte TiB 240 1,099,511,627,776 1024 GiB Terabit Tbit 1012 1,000,000,000,000 1000 Gbit
Pebibyte PiB 250 1,125,899,906,842,624 1024 TiB Petabit Pbit 1015 1,000,000,000,000,000 1000 Tbit
Exbibyte EiB 260 1,152,921,504,606,846,976 1024 PiB Exabit Ebit 1018 1,000,000,000,000,000,000 1000 Pbit
Zebibyte ZiB 270 1,180,591,620,717,411,303,424 1024 EiB Zettabit Zbit 1021 1,000,000,000,000,000,000,000 1000 Ebit
Yobibyte YiB 280 1,208,925,819,614,629,174,706,176 1024 ZiB Yottabit Ybit 1024 1,000,000,000,000,000,000,000,000 1000 Zbit

Kilobyte (KB) (JEDEC), is sometimes referred to unambiguously as kibibyte (KiB)(IEC). Sometimes kB, with lower cased SI-prefix 'k-' for kilo (1000), is used, then always equaling 1000 bytes.

A file system may display all sizes with the metric system with only 'kB' on small files indicating it, while some file systems/operating systems would display sizes in, the traditionally used on computers, binary system for all sizes, e.g. 'KB', while hard disk manufacturers use the metric system (for e.g. GB = 1,000,000,000 bytes and TB = 1000 GB).

File transfers (e.g. "downloads") may use rates of units of bytes (e.g. MB/s) in binary rather than metric system, while networking hardware, such as WiFi, always uses the metric system (Mbit/s, Gbit/s etc.). of units of bits (and it needs to send more than the files themselves, so some overhead needs to be factored in), making superficially similar terms very incompatible.[citation needed]

See also

References

  1. ^ JEDEC Solid State Technology Association (November 2019). "Terms, Definitions, and Letter Symbols for Microprocessors, and Memory Integrated Circuits". JESD 100B.01. p. 8. Retrieved 2009-04-05.
  2. ^ "What is Slack Space?". IT Pro. 2010-01-19. Retrieved 2018-02-17.
  3. ^ "Microsoft Extensible Firmware Initiative FAT32 File System Specification, FAT: General Overview of On-Disk Format". Microsoft. 2000-12-06. Retrieved 2011-07-03.