Jump to content

Bonomi BS.5 Ballerina

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Monkbot (talk | contribs) at 21:02, 14 December 2020 (Task 18 (cosmetic): eval 3 templates: del empty params (2×);). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

BS.5 Ballerina
Role Intermediate training glider
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flight 1934
Number built 2

The Bonomi BS.5 Ballerina (Template:Lang-en) was a single seat, medium performance training glider designed and built in Italy in the 1930s.

Design and development

The Ballerina was a high, braced wing aircraft. The wing was mounted on a central pedestal and had a central, straight edged, constant chord centre section, built in two parts, which occupied about a third of the span. There were straight tapered outer panels which carried the ailerons and ended at rounded tips. On each side a pair of V-shaped, faired, steel struts braced the outer ends of the centre section to the base of the fuselage.[1]

The fuselage had an hexagonal cross-section with deep, almost upright sides, its upper surfaces curving down over the nose. It was entirely plywood covered. The cockpit was immediately in front of the wing leading edge, placing the pilot's head on the front of the pedestal. A wooden skid with a rubber shock absorbers ran along the underside to form an undercarriage, assisted by a small, faired tail skid. Under the trailing edge the fuselage dropped down from the pedestal then tapered to the rear. The tail surfaces were all straight tapered and square tipped, with almost all of the surfaces moving. Enough fixed fin and tailplane was retained to allow aerodynamic balancing via an inset hinge.[1]

The Ballerina was capable of using both ridge and thermal lift. Pilots could use it to gain their C badge.[1]

Operational history

At least two Ballerinas were built, slightly different in dimensions and dihedral[1] and the reconstructed pre-war Italian civil register suggests there may have been a third.[2] Two spent some time in Egypt, brought in by Italians but operated by the Egyptian Aero Club.[3]

Specifications

Data from Pedrielli (2011) p.79[1]

General characteristics

  • Crew: One
  • Length: 6.90 m (22 ft 8 in)
  • Wingspan: 16.0 m (52 ft 6 in)
  • Wing area: 16.60 m2 (178.7 sq ft)
  • Aspect ratio: 15.40
  • Empty weight: 130 kg (287 lb)
  • Gross weight: 210 kg (463 lb)

Performance

  • Maximum glide ratio: 22:1 estimated
  • Rate of sink: 0.62 m/s (122 ft/min) [4]
  • Wing loading: 12 kg/m2 (2.5 lb/sq ft)


References

  1. ^ a b c d e Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 76–7. ISBN 9783980883894.
  2. ^ Air Britain: pre-war Italian register (Malcolm Fillmore)
  3. ^ Fekecs, Gábor (Spring 2013). "László Ede Almásy. The Real English Patient" (PDF). VGC News (137): 37.[permanent dead link]
  4. ^ Zuerl, Hubert (1941). Segelflug im Wettbewerb der Völker. Berlin: E. S. Mittler & Sohn. pp. 38, 42.