Beamer (occupation)

Beaming onto a taper's beam. This example is on display at Queen Street Mill Textile Museum, Harle Syke Burnley

A beamer was an occupation in the cotton industry. The taper's beam is a long cylinder with flanges where 400 plus ends (threads) are wound side-by-side. Creels of bobbins with the correct thread, mounted on a beaming frame wind their contents onto the beam. The machine is watched over by a "beamer".

In early days beaming was often done in the weaving shed but later the process tended to be transferred to the spinning mill. The spinners would send lorrys loaded with of beams wound with thread of the ordered specification to the weavers. Several tapers beams would be attached to creels on the Tape Sizing machine, and the threads from these would be sized and combined to create the smaller weavers beams. As a rule of thumb, a tapers beam had thread long enough to make 20 weavers beams.

Colloquially, the term beamer was used for anyone responsible for moving beams of yarn. In a weaving shed that bought its yarn on the beam, the Beamer would be the operative who carried new beams to the looms and gaited them.. A 'drawer-in' was sometimes referred to as a beamer.

References

Bibliography

• Freethly, Ron (2008). Memories of the Lancashire Cotton Mills. Newbury, Berkshire: Countryside Books. ISBN 978 1 84674 104 3. {{cite book}}: Invalid |ref=harv (help)
• Graham, Stanley (2008). Bancroft:The story of a Pennine weaving shed. lulu.com. ISBN 9 781409-255789. {{cite book}}: Invalid |ref=harv (help)
• Greenhalgh, David (2005). "Spinning Process". Retrieved 27 May 2013.