Oxyhydrogen is a mixture of hydrogen (H2) and oxygen (O2) gases. This gaseous mixture is used for torches to process refractory materials and was the first gaseous mixture used for welding. Theoretically, a ratio of 2:1 hydrogen:oxygen is enough to achieve maximum efficiency; in practice a ratio 4:1 or 5:1 is needed to avoid an oxidizing flame.
This mixture may also be referred to as Knallgas (Scandinavian and German Knallgas: "bang-gas"), although some authors define knallgas to be a generic term for the mixture of fuel with the precise amount of oxygen required for complete combustion, thus 2:1 oxyhydrogen would be called "hydrogen-knallgas".
The term Brown's gas refers to oxyhydrogen with a 2:1 molar ratio of H2 and O2 gases, the same proportion as in water. It was named after its Bulgarian inventor Yull Brown (born Iliya Valkov, Bulgarian: Илия Георгиев Вълков), who suggested it to be produced by the electrolysis of water to be used as a fuel for the internal combustion engine. Later "Brown's gas" and HHO has become a fringe science term for a 2:1 mixture of oxyhydrogen obtained under certain special conditions; its proponents claim that it has special properties.
Oxyhydrogen will combust when brought to its autoignition temperature. For the stoichiometric mixture, 2:1 hydrogen:oxygen, at normal atmospheric pressure, autoignition occurs at about 570 °C (1065 °F). The minimum energy required to ignite such a mixture with a spark is about 20 microjoules. At standard temperature and pressure, oxyhydrogen can burn when it is between about 4% and 95% hydrogen by volume.
When ignited, the gas mixture converts to water vapor and releases energy, which sustains the reaction: 241.8 kJ of energy (LHV) for every mole of H2 burned. The amount of heat energy released is independent of the mode of combustion, but the temperature of the flame varies. The maximum temperature of about 2,800 °C (5,100 °F) is achieved with an exact stoichiometric mixture, about 700 °C (1,300 °F) hotter than a hydrogen flame in air. When either of the gases are mixed in excess of this ratio, or when mixed with an inert gas like nitrogen, the heat must spread throughout a greater quantity of matter and the temperature will be lower.
- electrolysis: 2 H2O → 2 H2 + O2
- combustion: 2 H2 + O2 → 2 H2O
William Nicholson was the first to decompose water in this manner in 1800. In theory, the input energy of a closed system will always equal the output energy, as the first law of thermodynamics states. However, in practice no systems are perfectly closed, and the energy required to generate the oxyhydrogen will always exceed the energy released by combusting it, even at maximum practical efficiency, as the second law of thermodynamics implies. (See Electrolysis of water#Efficiency).
Many forms of oxyhydrogen lamps have been described, such as the limelight, which used an oxyhydrogen flame to heat a piece of lime to white hot incandescence. Because of the explosiveness of the oxyhydrogen, limelights have been replaced by electric lighting.
The foundations of the oxy-hydrogen blowpipe were laid down by Carl Wilhelm Scheele and Joseph Priestley around the last quarter of the eighteenth century. The oxy-hydrogen blowpipe itself was developed by the Frenchman Bochard-de-Saron, the English mineralogist Edward Daniel Clarke and the American chemist Robert Hare in the late eighteenth and early nineteenth centuries. It produced a flame hot enough to melt such refractory materials as platinum, porcelain, fire brick, and corundum, and was a valuable tool in several fields of science. It is used in the Verneuil process to produce synthetic corundum.
Due to competition from the acetylene-fueled cutting torch and from arc welding, the oxyhydrogen torch is seldom used today, but it remains the preferred cutting tool in some niche applications—see oxy-fuel welding and cutting.
Oxyhydrogen was once used in working platinum because at the time such a torch was the only device that could attain the temperature required to melt the metal 1,768.3 °C (3,214.9 °F). These techniques have been superseded by the electric arc furnace.
Fringe science 
Brown's gas has become associated with various exaggerated claims. It's also called "HHO gas" after the claims of fringe physicist Ruggero Santilli, who claims that his HHO gas, produced by a special apparatus, is "a new form of water", with new properties, based on his fringe theory of "magnecules". ("MagneGas" or "MagneHydrogen") .
Many other pseudoscientific claims have been made about Brown's gas's pretended ability to neutralize radioactive waste, help plants to germinate, etc.
Oxyhydrogen is often mentioned in conjunction with vehicles that claim to use water as a fuel. The most common and decisive counter-argument against producing this gas on board to use as a fuel or fuel additive is that more energy is needed to split water molecules than is recouped by burning the resulting gas. Additionally, the volume of gas that can be produced for on-demand consumption through electrolysis is very small in comparison to the volume consumed by an internal combustion engine.
- Howard Monroe Raymond (1916), "Oxy-Hydrogen Welding", Modern Shop Practice volume 1, American Technical Society, archived from the original on 2011-03-06
- Viall, Ethan (1921). Gas Torch and Thermite Welding. McGraw-Hill. p. 10. Archived from the original on 2016-08-03.
- W. Dittmar, "Exercises in quantitative chemical analysis", 1887, p. 189 Archived 2014-06-27 at the Wayback Machine.
- "Brown's Gas", Sunday Telegraph, January 16, 1977 (text online Archived 2016-12-20 at the Wayback Machine.)
- "Eagle Research Institute - Brown's Gas - Myth-conceptions". Retrieved 11 July 2018.
- O'Connor, Ken. "Hydrogen" (PDF). NASA Glenn Research Center Glenn Safety Manual (PDF). Archived from the original on 2013-02-02.
- 1911 Encyclopedia. "Oxyhydrogen Flame." (Dead link Archived 2008-02-09 at the Wayback Machine. Accessed 2008-01-19.)
Calvert, James B. (2008-04-21). "Hydrogen". University of Denver. Archived from the original on 2009-04-18. Retrieved 2009-04-23.
An air-hydrogen torch flame reaches 2045 °C, while an oxyhydrogen flame reaches 2660 °C.
- "Adiabatic Flame Temperature". The Engineering Toolbox. Archived from the original on 2008-01-28. Retrieved 2009-04-23. "Oxygen as Oxidizer: 3473 K, Air as Oxidizer: 2483 K"
- "Temperature of a Blue Flame". Archived from the original on 2008-03-16. Retrieved 2008-04-05. "Hydrogen in air: 2,400 K, Hydrogen in Oxygen: 3,080 K"
- Tilden, William Augustus (1926). Chemical Discovery and Invention in the Twentieth Century. Adamant Media Corporation. p. 80. ISBN 0-543-91646-4.
- https://books.google.co.uk/books?id=v2sfCwFk28AC&pg=RA1-PA153&lpg=RA1-PA153&dq=Saron+Oxyhydrogen&source=bl&ots=lUhgBlR2tJ&sig=uJCY78xpjDcMfB1lo2KNh3r5Sv8&hl=en&sa=X&ved=0ahUKEwjz9ILiwJ7UAhXGI8AKHRi8AswQ6AEIJTAE#v=onepage&q=Saron&f=false Archived 2017-12-24 at the Wayback Machine.
- Griffin, John Joseph (1827). A Practical Treatise on the Use of the Blowpipe in Chemical and Mineral Analysis. Glasgow: R. Griffin & co.
- "Verneuil process". Encyclopaedia Britannica. 22 October 2013. Retrieved 11 July 2018.
- P. N. Rao (2001), "24.4 Oxyhydrogen welding", Manufacturing technology: foundry, forming and welding (2 ed.), Tata McGraw-Hill Education, pp. 373–374, ISBN 978-0-07-463180-5, archived from the original on 2014-06-27
- Ball, Philip (10 September 2007). "Burning water and other myths". news@nature. Springer Nature. doi:10.1038/news070910-13. ISSN 1744-7933.
- Ball, Philip (2006). "Nuclear waste gets star attention". news@nature. doi:10.1038/news060731-13. ISSN 1744-7933.
- Weimar, Carrie (May 7, 2007). "Snubbed By Mainstream, Scientist Sues". St. Petersburg Times. Retrieved 3 February 2011.
- Schadewald, R.J. (2008). Worlds of Their Own: A Brief History of Misguided Ideas: Creationism, Flat-Earthism, Energy Scams, and the Velikovsky Affair. Xlibris US. ISBN 978-1-4628-1003-1. Retrieved 11 July 2018.
- Simpson, Bruce (May 2008). "The proof that HHO is a scam". Aardvark Daily. Archived from the original on 2012-02-11. Retrieved 12 Feb 2012.
- Water-Powered Cars: Hydrogen Electrolyzer Mod Can't Up MPGs Archived 2015-03-20 at the Wayback Machine., Mike Allen, August 7, 2008, Popularmechanics.com