The wave impedance of an electromagnetic wave is the ratio of the transverse components of the electric and magnetic fields (the transverse components being those at right angles to the direction of propagation). For a transverse-electric-magnetic (TEM) plane wave traveling through a homogeneous medium, the wave impedance is everywhere equal to the intrinsic impedance of the medium. In particular, for a plane wave travelling through empty space, the wave impedance is equal to the impedance of free space. The symbol Z is used to represent it and it is expressed in units of ohms. The symbol η (eta) may be used instead of Z for wave impedance to avoid confusion with electrical impedance.
The wave impedance is given by
where is the electric field and is the magnetic field, in phasor representation. The impedance is in general a complex number.
In terms of the parameters of an electromagnetic wave and the medium it travels through, the wave impedance is given by
where μ is the magnetic permeability, ε is the (real) electric permittivity and σ is the electrical conductivity of the material the wave is travelling through (corresponding to the imaginary component of the permittivity multiplied by omega). In the equation, i is the imaginary unit, and ω is the angular frequency of the wave. In the case of an ideal dielectric (where the conductivity is zero), the equation reduces to the real number
Just as for electrical impedance, the impedance is a function of frequency.
Wave impedance in free space
In free space the wave impedance of plane waves is:
(where epsilon nought is the permitivity constant in free space and mu nought is the permeability constant in free space) and:
- m/s (by current SI definition of metre)
hence, because the values of and are exact, the value of in ohms is exactly:
Wave impedance in an unbounded dielectric
where is the relative dielectric constant.
Wave impedance in a waveguide
For any waveguide in the form of a hollow metal tube, (such as rectangular guide, circular guide, or double-ridge guide), the wave impedance of a travelling wave is dependent on the frequency , but is the same throughout the guide. For transverse electric (TE) modes of propagation the wave impedance is:
where fc is the cut-off frequency of the mode, and for transverse magnetic (TM) modes of propagation the wave impedance is:
Above the cut-off (f > fc), the impedance is real (resistive) and the wave carries energy. Below cut-off the impedance is imaginary (reactive) and the wave is evanescent. These expressions neglect the effect of resistive loss in the walls of the waveguide. For a waveguide entirely filled with a homogeneous dielectric medium, similar expressions apply, but with the wave impedance of the medium replacing Z0. The presence of the dielectric also modifies the cut-off frequency fc.
For a waveguide or transmission line containing more than one type of dielectric medium (such as microstrip), the wave impedance will in general vary over the cross-section of the line.
- Standing Wave Diagram Application for drawing Standing Wave Diagrams, specifying the wave impedance whenever the wave changes mediums.