GMC CCKW 2½-ton 6×6 truck

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 703Frank (talk | contribs) at 15:14, 20 September 2018 (→‎References: Added Boniface & Jeudy (1990)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

This article is about the original World War II "Deuce-and-a-half". For its successor, see M35 2½-ton cargo truck.
CCKW
CCKW 353 cargo truck with winch
Type2+1⁄2-ton 6×6 Cargo truck
Place of originUnited States
Production history
DesignerYellow Truck and Coach Co.
ManufacturerYellow/GMC Truck and Coach
Chevrolet
Produced1941–45
No. built562,750
VariantsSee text
Specifications (353 Cargo w/winch[1])
Mass8,800 lb (4,000 kg) empty
16,400 lb (7,400 kg) loaded
Length270+1⁄8 in (6.86 m)
Width88 in (2.24 m)
Height93 in (2.36 m) to cab
109+1⁄8 in (2.77 m) overall
EngineGMC 270
91 hp (68 kW)
Transmission5 spd. x 2 range trf. case
SuspensionBeam axles on leaf springs
Fuel capacity40 US gal (150 L)
Operational
range
300 mi (482.8 km)
Maximum speed 45 mph (72 km/h)

The GMC CCKW also known as "Jimmy" was a 2½-ton 6x6 U.S. Army cargo truck that saw heavy service in both World War II and the Korean War. The original "Deuce and a Half", it formed the backbone of the famed Red Ball Express that kept Allied armies supplied as they pushed eastward after the Normandy invasion.[2]

The CCKW came in many variants, including open or closed cab, long wheel base (LWB 353) and short (SWB 352), and over a score of specialized models. It began to be phased out with the deployment of the 6×6 M35 in 1950, but remained in active U.S. service until the mid-1960s. It is related to the Chevrolet G506, built at the same factory.

Etymology

The name CCKW comes from GMC model nomenclature:[3]

  • "C", designed in 1941
  • "C", conventional cab
  • "K", all-wheel drive
  • "W", dual rear axles

History

In 1939-1940 the US Army Ordnance Corps was developing 2+1⁄2-ton (2,268 kg) load-rated 6×6 tactical trucks that could operate off-road in all weather. General Motors, already supplying modified commercial trucks to the Army, modified the 1939 ACKWX–built for the French Army–into the CCKW. The General Motors design was chosen by the Army and went into production at GM'S Yellow Truck and Coach division's Pontiac, Michigan plant alongside 6×4 CCWs. Later they were also manufactured at GM's St. Louis, Missouri Chevrolet plant.[4][5]

By the end of production in 1945, 562,750 CCKWs in all variants had been built, a total second only to the “Jeep”.[6]

Specifications

Engine and drive-line

The CCKW was equipped with the GMC 270 engine, an overhead valve inline-6 with 91 horsepower (68 kW) at 2750rpm and 216 pound force-feet (293 N⋅m) at 1400rpm. A 3+25⁄32 in (96 mm) bore by 4 in (102 mm) stroke gave a 269.5 cu in (4.4 L) displacement.[7] This (gasoline) engine was designed for commercial trucks, and was reliable in service.[8]

The transmission was a Warner T93 5-speed with a direct 4th gear and overdrive 5th gear. The transfer case had high and low gears, and engaged the front axle. Originally all axles were a Timken split type, later trucks also used GM "banjo" types.[9][10]

Chassis

The CCKW had a ladder frame chassis with three driven beam axles, the front on leaf springs, the rear tandem on leaf springs with locating arms. There were two wheelbases, the short Model 352 and the long Model 353. The short, 145 in (368 cm) (Measurements are from the centerline of the front axle to the centerline of rear bogie) was used with a short cargo bed as an artillery prime mover for 75 mm and 105 mm howitzers. All other models used the long 164 in (417 cm) wheelbase. Tires were 7.50-20, brakes were hydraulic with vacuum assist.[8]

Some were fitted with 10,000 lb (4,500 kg) front-mounted winches. A winch added 300 pounds (140 kg) and 14 inches (36 cm).[11]

Some open cab chassis were cut in half behind the cab for air transport. Each half was a load, at the vehicle's destination, the halves were bolted back together.[8][12]

Versions

Van body with canvas roof and doors in place
Gasoline tanker (750 US gal (2,800 L))
CCKW-353-B2 gun truck with M45 Quadmount on M20 trailer in bed, loading ramps attached to side

Initially, all versions used a modified commercial closed cab design having a metal roof and doors. By 1944 an open cab version, with a canvas roof and doors, was used. This was easier to build, and the roof could be removed to lower the shipping height. 1 in 4 of cabs had a machine gun mounting ring above the co-driver's position.[8]

The CCKW provided a platform for the widest range of bodies on any U.S. military vehicle, with the 12 ft (3.7 m) cargo version being the most common. As steel was more heavily rationed during the course of the war, the steel cargo bed was replaced by a wooden one. Wooden beds proved unsatisfactory and a 'composite' bed with steel sides, framing, and wooden bottom slats was developed.[5] However, the composite bed was still unsatisfactory and the bed design returned to all steel.

A standard rectangular van configuration was used in communications, medical, workshop, and many other specialty roles. Special built vans were also used.[13]

Specialized variants

Many specialized variants of the basic 6×6 CCKW were made, some in small numbers, including some converted in the field. These include:[14]

  • Air compressor
  • Bomb service
  • Chemical decontaminating
  • Chemical handling
  • Dental operating van
  • Dump truck
  • Fire engine
  • Fuel & gas tankers (750 US gal (2,800 L))
  • Fuel & oil handling (660 US gal (2,500 L)), (750 US gal (2,800 L))
  • High lift
  • K-53 radio equip. van
  • K-60 radio equip. van
  • Map reproduction van
  • Ordnance maintenance van
  • Pipeline equipment
  • Ponton bolster
  • Semi-trailer tractor[15]
  • Shop equipment GP repair van
  • Surgical van
  • Water purification van
  • Water tanker (700 US gal (2,600 L))
  • Welder's truck

AFKWX

GMC AFKWX-353 cab-over-engine
DUKW in use by American troops in France

The AFKWX (A for 1939, F for forward cab, K for all wheel drive, and W for tandem rear axles) 353, a cab over engine cargo bed version of the CCKW, went into production alongside it in 1942 at Yellow’s Pontiac plant and Chevrolet’s in St. Louis. Otherwise mechanically identical, its compact cabin design allowed a 15 ft (4.6 m), and later 17 ft (5.2 m) cargo bed to be fitted. The first 50 produced had closed cabs, all others were open. The cab over design made engine maintenance difficult. As a result, only 7235 were built, none with a front-mounted winch.[16][17]

CCW

The CCW (C for 1941, C for conventional cab, and W for tandem rear axles), an on-road, 5-ton 6×4 truck version of the CCKW that lacked only its front wheel drive. A beam front axle was used, with the transfer case locked in high range.

DUKW

Main article: DUKW

The DUKW (D for 1942, U for utility, K for all wheel drive, and W for tandem rear axles) (“Duck”) was an amphibious truck that shared the CCKW's driveline. First produced at Yellow’s Pontiac plant, as demand increased production was added to Chevrolet’s St. Louis plant. The hull, designed by an America's Cup winner, had excellent sea-keeping abilities. A very successful design, 21,147 were built.[18][19][20]

Gallery

  • 80th Division crossing the Rhine near Mainz
    80th Division crossing the Rhine near Mainz
  • Red Ball Express convoy, 1944
    Red Ball Express convoy, 1944
  • Restored maintenance vehicle
    Restored maintenance vehicle
  • Restored two part chassis for air transport
    Restored two part chassis for air transport
  • Restored CCKW 353 Cargo truck with open cab, machine gun ring, and front-mounted winch
    Restored CCKW 353 Cargo truck with open cab, machine gun ring, and front-mounted winch

See also

Notes

  1. ^ TM 9-801 (1944), pp. 6–9, 16–19.
  2. ^ Colley (2000).
  3. ^ Whitlock (2004).
  4. ^ Crismon (2001), pp. 9, 184, 326, 330–335, 465.
  5. ^ a b Doyle (2010), p. 9.
  6. ^ Ware (2010), pp. 238–239.
  7. ^ TM 9-801 (1944), pp. 6–9.
  8. ^ a b c d Doyle (2003), pp. 108–118.
  9. ^ TM 9-801 (1944), pp. 13–14, 35–39.
  10. ^ Doyle (2010), pp. 9, 10, 20.
  11. ^ TM 9-801 (1944), pp. 17–18, 54–58.
  12. ^ Doyle (2010), pp. 47–55.
  13. ^ Doyle (2010), pp. 78–80.
  14. ^ TM 9-2800 (1947), pp. 267–268, 272–293.
  15. ^ "GMC CCKW Tractor". The G503 Album. Retrieved 8 August 2017.
  16. ^ Doyle (2003), pp. 105–107.
  17. ^ TM 9-2800 (1947), pp. 268–269.
  18. ^ TM 9-801 (1944), pp. 465.
  19. ^ Doyle (2003), pp. 119–121.
  20. ^ TM 9-2800 (1947), p. 9.

References

External links

Wikimedia Commons has media related to GMC CCKW.

Retrieved from "https://en.wikipedia.org/w/index.php?title=GMC_CCKW_2½-ton_6×6_truck&oldid=860418729"