The mixture known as gasoline or petrol, when used in high compression internal combustion engines, has a tendency to knock (also called "pinging" or "pinking") and/or to ignite early before the correctly timed spark occurs (pre-ignition, refer to engine knocking).
Early research into this effect was led by A.H. Gibson and Harry Ricardo in England and Thomas Midgley, Jr. and Thomas Boyd in the United States. The discovery that lead additives modified this behavior led to the widespread adoption of the practice in the 1920s and therefore more powerful higher compression engines. The most popular additive was tetraethyllead. However, with the discovery of the environmental and health damage caused by the lead, attributed to Derek Bryce-Smith, and the incompatibility of lead with catalytic converters found on virtually all US automobiles since 1975, this practice began to wane in the 1980s. Most countries are phasing out leaded fuel although different additives still contain lead compounds. Other additives include aromatic hydrocarbons, ethers and alcohol (usually ethanol or methanol).
The typical antiknock agents in use are:
- Tetraethyllead (Still in use as a high octane additive)
- Methylcyclopentadienyl manganese tricarbonyl (MMT)
- Iron pentacarbonyl
In the U.S., where tetraethyllead had been blended with gasoline (primarily to boost octane levels) since the early 1920s, standards to phase out leaded gasoline were first implemented in 1973. In 1995, leaded fuel accounted for only 0.6% of total gasoline sales and less than 2,000 tons of lead per year. From January 1, 1996, the Clean Air Act banned the sale of leaded fuel for use in on-road vehicles in the United States. Possession and use of leaded gasoline in a regular on-road vehicle now carries a maximum US$10,000 fine in the United States. However, fuel containing lead may continue to be sold for off-road uses, including aircraft, racing cars, farm equipment, and marine engines. The ban on leaded gasoline led to thousands fewer tons of lead being released into the air by automobiles.
A side effect of the lead additives was protection of the valve seats from erosion. Many classic cars' engines have needed modification to use lead-free fuels since leaded fuels became unavailable. However, "Lead substitute" products are also produced and can sometimes be found at auto parts stores.
Gasoline, as delivered at the pump, also contains additives to reduce internal engine carbon buildups, improve combustion, and to allow easier starting in cold climates.
In some parts of South America, Asia, and the Middle East, leaded gasoline is still in use. Leaded gasoline was phased out in sub-Saharan Africa, starting 1 January 2006. A growing number of countries have drawn up plans to ban leaded gasoline in the near future.
Some experts speculate that Leaded petrol was behind a global crime wave in the late 80's and early 90's
To avoid deposits of lead inside the engine, lead scavengers are added to the gasoline together with tetraethyllead. The most common ones are:
Methylcyclopentadienyl manganese tricarbonyl (MMT) has been used for many years in Canada and recently in Australia to boost octane ratings. It also allows old cars, designed to use leaded fuel, to run on unleaded fuel without the need for additives to prevent valve stem erosion.
A large Canadian study from 2002 (funded by automakers, who are against its use) concluded that MMT impairs the effectiveness of automobile emission controls and increases pollution from motor vehicles. However, a later study by the Canadian government found that “no Notice of Defect was found to be potentially caused by MMT.”
Many studies have been undertaken over time that confirmed the use of mmt is compatible with vehicles and safe for human health and the environment. In particular, a 2013 risk assessment on MMT was undertaken by ARCADIS Consulting, following a methodology developed by the European Commission. This risk assessment was verified by an independent panel and found by the EU Commission to be compliant with their methodology. It concluded that “when MMT is used as a fuel additive in petrol, no significant human health or environmental concerns related to exposure to either MMT or its transformation [combustion] products (manganese phosphate, manganese sulphate and manganese tetroxide) were identified even in locations where mmt is approved for use at levels up to 18 mg Mn/l.”
As stated by Health Canada in their risk assessment on the widespread use of MMT in Canadian gasoline, “all analyses indicate that the combustion products of MMT in gasoline do not represent an added health risk to the Canadian population”
MMT is manufactured by reduction of bis(methylcyclopentadienyl) manganese using triethylaluminium. The reduction is conducted under an atmosphere of carbon monoxide. MMT is a so-called half-sandwich compound, or more specifically a piano-stool complex (since the three CO ligands are like the legs of a piano stool). The manganese atom in MMT is coordinated with three carbonyl groups as well as to the methylcyclopentadienyl ring. These hydrophobic organic ligands make MMT highly lipophilic, which may increase bioaccumulation. While the structure of mmt suggests lipophilicity and potential to bioaccumulate, comparison of bioconcentration factors (BCF) reported for plant and animal species in comparison to regulatory-based cutoffs (i.e., US EPA and EU REACH) indicates a low bioaccumulative potential of mmt. Figures 2 and 3 of the study (pages 182 & 184) shows the BCF plotted against time and illustrates the potential BCF of mmt. From these figures, the upper curve (A) demonstrates the 9-day mmt BCF plateauing at approximately 400 in plants and 200 in fish, with both values well below the Bioaccumulative/very Bioaccumulative (B/vB) thresholds of US EPA, EU REACH and Environment & Climate Change Canada.
A variety of related complexes are known, including ferrocene, which is also under consideration as an additive to gasoline.
Ferrocene is the organometallic compound with the formula Fe(C5H5)2. It is the prototypical metallocene, a type of organometallic chemical compound consisting of two cyclopentadienyl rings bound on opposite sides of a central metal atom. Such organometallic compounds are also known as sandwich compounds. The rapid growth of organometallic chemistry is often attributed to the excitement arising from the discovery of ferrocene and its many analogues.
Ferrocene and its numerous derivatives have no large-scale applications, but have many niche uses that exploit their unusual structure (ligand scaffolds, pharmaceutical candidates), robustness (anti-knock formulations, precursors to materials), and redox reactions (reagents and redox standards).
Ferrocene and its derivatives are antiknock agents added to the petrol used in motor vehicles, and are safer than the now-banned tetraethyllead. Petrol additive solutions containing ferrocene can be added to unleaded petrol to enable its use in vintage cars designed to run on leaded petrol. The iron-containing deposits formed from ferrocene can form a conductive coating on the spark plug surfaces.
This compound is a common precursor to diverse iron compounds, including many that are useful in organic synthesis. Fe(CO)5 is prepared by the reaction of fine iron particles with carbon monoxide. Fe(CO)5 is inexpensively purchased.
Most metal carbonyls have 18 valence electrons, and Fe(CO)5 fits this pattern with 8 valence electrons on Fe and five pairs of electrons provided by the CO ligands. Reflecting its symmetrical structure and charge neutrality, Fe(CO)5 is volatile; it is one of the most frequently encountered liquid metal complexes.
Fe(CO)5 is the archetypal fluxional molecule due to the rapid interchange of the axial and equatorial CO groups via the Berry mechanism on the NMR timescale. Consequently, the13C NMR spectrum exhibits only one signal due to the rapid interchange between nonequivalent CO sites.
In Europe, iron pentacarbonyl was once used as an anti-knock agent in petrol in place of tetraethyllead. Two more modern alternative fuel additives are ferrocene and methylcyclopentadienyl manganese tricarbonyl. Fe(CO)5 is used in the production of "carbonyl iron", a finely divided form of iron used in magnetic cores of high-frequency coils for electronics, and for manufacture of the active ingredients of some radar absorbent materials (e.g. iron ball paint). It is famous as a chemical precursor for the synthesis of various iron-based nanoparticles.
Iron pentacarbonyl has been found to be a strong flame speed inhibitor in oxygen based flames.
Toluene is a clear, water-insoluble liquid with the typical smell of paint thinners, redolent of the sweet smell of the related compound benzene. It is an aromatic hydrocarbon that is widely used as an industrial feedstock and as a solvent. Like other solvents, toluene is also used as an inhalant drug for its intoxicating properties.
Toluene can be used as an octane booster in gasoline fuels used in internal combustion engines. Toluene at 86% by volume fueled all the turbo Formula 1 teams in the 1980s, first pioneered by the Honda team. The remaining 14% was a "filler" of n-heptane, to reduce the octane to meet Formula 1 fuel restrictions. Toluene at 100% can be used as a fuel for both two-stroke and four-stroke engines; however, due to the density of the fuel and other factors, the fuel does not vaporize easily unless preheated to 70 degrees Celsius (Honda accomplished this in their Formula 1 cars by routing the fuel lines through the exhaust system to heat the fuel). Toluene also poses similar problems as alcohol fuels, as it eats through standard rubber fuel lines and has no lubricating properties as standard gasoline does, which can break down fuel pumps and cause upper cylinder bore wear.
Toluene has also been used as a coolant for its good heat transfer capabilities in sodium cold traps used in nuclear reactor system loops.
Isooctane is produced on a massive scale in the petroleum industry, usually as a mixture with related hydrocarbons. The alkylation process alkylates isobutane with isobutylene using a strong acid catalyst. In the NExOCTANE process, isobutylene is dimerized into isooctane and then hydrogenated to isooctane.
- Schnaas L, Rothenberg SJ, Flores MF, et al. (July 2004). "Blood lead secular trend in a cohort of children in Mexico City (1987-2002)". Environ. Health Perspect. 112 (10): 1110–5. doi:10.1289/ehp.6636. PMC . PMID 15238286. Archived from the original on 2012-07-08.
- General Review of Emission-Related Notices of Defect and Recalls (Canada and the U.S.), Environment Canada (January 31, 2005)
- Risk Assessment of Methylcyclopentadienyl Manganese Tricarbonyl (mmt) when used as a Fuel Additive, Arcadis (November 2013).
- Risk Assessment for the Combustion Products of Methylcyclopentadienyl Manganese Tricarbonyl (MMT) in Gasoline,” Health Canada (December 6, 1994)
- Garrec, J.P.; Kudo, A. (1985). "Distribution and accumulation of methylcyclopentadienyl manganese tricarbonyl (MMT-antidetonating agent) in an experimental freshwater ecosystem". Environmental Pollution. Series B: 173–188. doi:10.1016/0143-148x(85)90042-4.
- R. Dagani (3 December 2001). "Fifty Years of Ferrocene Chemistry". Chemical and Engineering News. 79 (49): 37–38. doi:10.1021/cen-v079n049.p037. (Subscription required (. ))
- Application of fuel additives Archived 2006-05-05 at the Wayback Machine.
- U.S. Patent 4,104,036
- Samson, S. ; Stephenson, G. R. "Pentacarbonyliron" in Encyclopedia of Reagents for Organic Synthesis (Ed: L. Paquette) 2004, J. Wiley & Sons, New York. doi:10.1002/047084289.
- Streicher HZ, Gabow PA, Moss AH, Kono D, Kaehny WD (1981). "Syndromes of toluene sniffing in adults". Ann. Intern. Med. 94 (6): 758–62. doi:10.7326/0003-4819-94-6-758. PMID 7235417.
- Devathasan G, Low D, Teoh PC, Wan SH, Wong PK (1984). "Complications of chronic glue (toluene) abuse in adolescents". Aust N Z J Med. 14 (1): 39–43. doi:10.1111/j.1445-5994.1984.tb03583.x. PMID 6087782.
- NExOCTANE - Neste Jacobs Archived December 23, 2007, at the Wayback Machine.
- Media related to Antiknock agents at Wikimedia Commons