Jump to content

Qseven

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 80.146.228.75 (talk) at 10:34, 21 October 2016 (Wrong date for specification 2.0). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Qseven, a computer-on-module (COM) form factor, is a small, highly integrated computer module that can be used in a design application much like an integrated circuit component. It's smaller than other computer-on-module standards such as COM Express, ETX or XTX and is limited to very low power consuming CPUs. The maximum power consumption should be no more than 12 watt.

Since the release of Specification 1.20 (September 10, 2010) Qseven modules can be indifferently based on x86 or ARM architectures.

Interfaces

The Qseven specification defines a rich set of legacy-free interfaces. Older interfaces like PCI, ISA, RS-232 or EIDE are not supported.

Size

  • 70 mm × 70 mm;
  • 70 mm × 40 mm.[1]

Connector

Qseven uses one 230 pin MXM2 SMT edge connector to connect all power and signal lanes to the carrier board. This connector is available from multiple vendors at different heights (5.5 mm and 7.8 mm).

Specification

The Qseven specification is hosted by the independent Qseven consortium. It's freely available at the consortiums website. The current revision 2.00 was released September 9, 2012.

Design Guide

The Qseven design guide provides information for designing a custom system carrier board for Qseven modules. It includes reference schematics for the external circuitry required to implement various peripheral functions. It also explains how to extend the supported buses and how to add additional peripherals and expansion slots to a Qseven-based system. It's available from the Qseven consortium webpage.

See also

References

  1. ^ "sget.org: Qseven". www.sget.org. Retrieved 2016-03-13.
Retrieved from "https://en.wikipedia.org/w/index.php?title=Qseven&oldid=745475766"