SY4307A
 |
| SY4307A | |
|---|---|
 Standard Telephones and Cables brand Australian Pentode, type SY4307A, c1940 | |
| Classification | Power Output Pentode |
| Service | Class C amplifier, (Radio Frequency) |
| Cathode | |
| Cathode type | Directly heated |
| Filament voltage: | 6.3v |
| Filament current | 1.16A |
| Socket connections | |
| American 5 Pin, (UX5) with side locating pin between pis 1 and 2. | |
The type SY4307A is a power output pentode possessing a similar power rating, but significantly different characteristics to the far more common type 807 thermionic valve/vacuum tube.
Uses
Although the 807 is used for both audio amplification, (usually class AB, and radio frequency amplification in the 1-30 MHz range, (usually class C), this type was usually used for the latter.
This tube/valve is a pentode with a 'directly heated cathode', meaning that the cathode consists of an emissive oxide coated filament. These features suggest the SY4307A could predate and is contemporary with, the 807 which is a beam power tetrode, a more advanced design with a more linear transfer characteristic and a more complex 'indirectly heated cathode'.
Similarity to 807
If the pinout of the SY4307A is compared to that of the 807 the similarity is striking. All pins are assigned equivalent electrodes with the exception of pin 4, which is the suppressor grid, g3, in this type but in the 807 pin 4 is the connected to equivalent of a suppressor grid, the 'beam plates' and also the separate indirectly heated cathode. It is possible to interchange the two with the relatively minor alteration involving the linking of pins 4 and 5 and ensuring the heater supply is floating (not connected to other heaters). If the heater is supplied from an A.C. source, linking pin 4 to the centre of that source and the cathode bootstrap minimizes hum pickup.
Historical significance
The SY4307A was used extensively during World War II by the Australian armed forces and the example depicted is marked on the Bakelite collar of its base with the "D broad arrow D" commonwealth department of defense mark.
Two SY4307As were used, wired in parallel, as the output stage, or "final", in a transmitter constructed clandestinely by the Australian soldiers of Sparrow Force in Japanese occupied Portuguese Timor in 1942. This transmitter became known affectionately as "Winnie the War Winner", named after the British wartime Prime Minister, Winston Churchill.
-
Side view of SY4307A -
View of directly heated cathode of the SY4307A -
View of UX5 Base of the SY4307A
