Jump to content

Talk:Anilox

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

While this article has some useful information about anilox rollers, it also has important errors. For example, the first sentence says an anilox roller is a "soft cylinder". On the contrary, anilox rollers are hard and almost always made with a base of solid steel or steel tubing that is usually 13 to 15 mm thick (1/2 - 9/16").

Also, they are almost always coated with chrome or ceramic. Chrome-plated anilox rollers are engraved with a knurling tool under high pressure then plated with chrome. Plasma ceramic anilox rollers are coated with ceramic then engraved with a laser.

The article mentions that anilox rollers are scraped with a blade to remove excess ink. While this is the most common system on newer flexographic printing presses, excessive ink can also be removed by a rubber roller which "wipes" the cells. There are many flexographic presses with the latter system and "two roll" systems are preferred for some flexographic functions such as printing a solid white base over which is printed other colors.

The cost of anilox rollers is said to range from US$5,000. This is absolutely untrue. A typical anilox roller with a coating length of 1 meter would cost less than US$1,000 to refurbish with new ceramic and laser engraving. A new roller with a new steel base plus ceramic coating and engraving would cost about US$2,000 in today's dollars (October 2007).Philbee 15:41, 18 October 2007 (UTC)[reply]

Is it a "method"

[edit]

Is anilox a method? I would have said Flexo is the method, and the Anilox roller is a component. Feldercarb (talk) 21:39, 6 October 2023 (UTC)[reply]