Jump to content

Teichfuss Falco

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by BD2412 (talk | contribs) at 19:46, 23 June 2015 (References: Consensus at Template talk:Aviation lists#RfC: Should this navbox be removed from non-mentioned articles? using AWB). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Falco
Role Single seat intermediate performance glider
National origin Italy
Designer Luigi Teichfuss
First flight 1931
Number built 2

The Teichfuss Falco (Template:Lang-en) was an Italian single-seat, intermediate-performance glider, designed by Luigi Teichfuss and flown in 1931.

Design and development

The Falco was designed as a glider with performance better than that of a trainer though not at a soaring competition level. It was a high-wing monoplane, with its single spar wing braced on each side by a pair of faired struts arranged in a V, joining the lower fuselage to the outer end of the central panel at about one-third span. This central panel was rectangular in plan and without dihedral. The outer panels were straight-tapered to blunt tips, the wing becoming thinner and thus acquiring dihedral though retaining a horizontal upper surface. Ailerons occupied the whole trailing edges of these outer panels; there were no inboard flaps or air brakes.[1]

Its wood-framed, plywood-skinned fuselage was deep-sided and hexagonal in cross section, tapering markedly towards the tail. The wing was mounted on a pedestal which continued only briefly behind the wing. The pilot's open cockpit was immediately ahead of the pedestal and below the wing leading edge. There was no fixed tailplane; instead the Falco had a single-piece, all-moving elevator with a straight leading edge and a semi-elliptical trailing edge. There was a small triangular fin which supported a much larger, tall balanced rudder, essentially triangular in shape but with rounded vertices. Hinged above the elevator trailing edge, which had a cut-out for its movement, the rudder extended down to the keel, where it was protected by a small, faired tail bumper. There was a long landing skid with rubber shock absorbers, running from near the nose to under the aft end of the wing pedestal.[1]

The Falco first flew in 1931. Two were built; one was lost in a crash.

Specifications

Data from Pedrielli (2011) pp.36-7[1]

General characteristics

  • Capacity: One
  • Length: 7.06 m (23 ft 2 in)
  • Wingspan: 16 m (52 ft 6 in)
  • Height: 1.44 m (4 ft 9 in) [2]
  • Wing area: 18.60 m2 (200.2 sq ft)
  • Aspect ratio: 14
  • Empty weight: 155 kg (342 lb)
  • Gross weight: 240 kg (529 lb)

Performance

  • Maximum glide ratio: estimated 21.5:1
  • Rate of sink: 0.65 m/s (128 ft/min) minimum[2]
  • Wing loading: 12.9 kg/m2 (2.6 lb/sq ft)

References

  1. ^ a b c Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 36–7. ISBN 9783980883894.
  2. ^ a b "Teichfuss Falco". Retrieved 19 November 2013.