Jump to content

Gewehr-Granatpatrone 40

From Wikipedia, the free encyclopedia
Gewehr-Granatpatrone 40
A schematic of components.
TypeShaped charge rifle grenade
Place of origin Nazi Germany
Service history
Used byLuftwaffe Fallschirmjäger
WarsWorld War II
Specifications
Mass515 g (18.2 oz)
Length234 mm (9.2 in)
Diameter61 mm (2.4 in)[1]

Maximum firing range91 m (100 yd)
WarheadRDX
Warhead weight6.2 oz (175 g)
Detonation
mechanism
Graze fuze
Blast yield35 mm (1.4 in) RHA[1]

The Gewehr-Granatpatrone 40 or GGP/40 for short was a shaped charge rifle grenade used by German forces during the Second World War. It was originally developed for Luftwaffe Fallschirmjäger units to provide them with a light and portable anti-tank weapon.

History

[edit]

The GGP/40 was developed by WASAG in 1940 at the request of the Luftwaffe.[2] It was not operational in time for the French Campaign but it is thought to have been operational in 1941 and first used by Fallschirmjäger units during the Battle of Crete. However, it soon became apparent that its aerodynamics, accuracy, range and armor penetration were all poor.[3] In 1942 a requirement for a better projectile with 50 mm (2 in) to 70 mm (3 in) of armor penetration was drawn up but experience on the Eastern Front soon showed that even that level of performance would be insufficient so development was abandoned. The army by that time had also developed better rifle grenades.[3]

Design

[edit]
Drawings of German Schießbecher and grenades.

The GGP/40 was not fired from the same Gewehrgranatengerät or Schießbecher ("shooting cup") used by the army, instead using its own spigot type launcher. Unlike the rifle grenades used by the army the GGP/40 did not fit inside the Schießbecher but instead, it had a rubber gasket at the base and fit around the Schießbecher and was held in place by a clip. The GGP/40 was propelled by a rifle cartridge that fired a hollow wooden bullet instead of a blank cartridge.[4] Another key difference between the GGP/40 and the army grenades was that it was fin-stabilized instead of spin-stabilized and did not have a rifled driving band. The major components of the GGP/40 were; rubber base gasket, six tail fins, hollow cylindrical base, graze fuze, bell-shaped warhead, RDX filling, internal steel cone, and convex nose cap. The GGP/40 more closely resembled a mortar round than the army's rifle grenades.[1]

The GGP/40 upon hitting the target ignited the graze fuze which in turn ignited the RDX filling which collapsed the internal steel cone to create a superplastic high-velocity jet to punch through enemy armor. In general, a longer and wider internal cone equates to increased armor penetration. Since shaped charge weapons rely on chemical energy to penetrate enemy armor the low velocity of the grenade did not adversely affect penetration.[5]

References

[edit]
  1. ^ a b c "Gewehrgranate zur Panzerbekämpfung 40: GG/P 40; Munitions-Handbuch , D (Luft) 4603" (PDF). 1942.
  2. ^ "Gazette des Armes n°460 janvier 2014 - Page 32 - 33 - Gazette des Armes n°460 janvier 2014 - Gazette des Armes - armes et défense - autres - Loisirs - 1001mags - Magazines en PDF à 1 € et GRATUITS !". fr.1001mags.com. Retrieved 2019-02-08.
  3. ^ a b Rottman, Gordon (2005). World War II infantry anti-tank tactics. Noon, Steve., Windrow, Martin, 1944-. Oxford: Osprey Publishing. p. 50. ISBN 1841768421. OCLC 57061535.
  4. ^ unknown (1 August 1945). Catalog Of Enemy Ordnance Material. www.paperlessarchives.com/FreeTitles/CatalogOfEnemyOrdnanceMateriel.pdf: Office of the chief of ordnance. p. 318.
  5. ^ "Hollow Charge Grenade (Schuss Gg. P-40) | German Hand & Rifle Grenades, Bulletin No. 59, March 7, 1944 (Lone Sentry)". lonesentry.com. Retrieved 2019-02-08.