Jump to content

Newell's algorithm

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Nelsonmax (talk | contribs) at 21:07, 4 June 2018 (Revised to "If the tests are all false, then switch the order of P and Q in the sort, record having done so, and try again. If there is an attempt to switch the order of a polygon a second time, there is a visibility cycle, and the polygons must be split." to give more detail on the detection of cycles.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Newell's Algorithm is a 3D computer graphics procedure for elimination of polygon cycles in the depth sorting required in hidden surface removal. It was proposed in 1972 by brothers Martin Newell and Dick Newell, and Tom Sancha, while all three were working at CADCentre.

In the depth sorting phase of hidden surface removal, if two polygons have no overlapping extents or extreme minimum and maximum values in the x, y, and z directions, then they can be easily sorted. If two polygons, Q and P, do have overlapping extents in the Z direction, then it is possible that cutting is necessary.

Cyclic polygons must be eliminated to correctly sort them by depth

In that case Newell's algorithm tests the following:

  1. Test for Z overlap; implied in the selection of the face Q from the sort list
  2. The extreme coordinate values in X of the two faces do not overlap (minimax test in X)
  3. The extreme coordinate values in Y of the two faces do not overlap (minimax test in Y)
  4. All vertices of P lie deeper than the plane of Q
  5. All vertices of Q lie closer to the viewpoint than the plane of P
  6. The rasterisation of P and Q do not overlap

Note that the tests are given in order of increasing computational difficulty.

Note also that the polygons must be planar.

If the tests are all false, then switch the order of P and Q in the sort, record having done so, and try again. If there is an attempt to switch the order of a polygon a second time, there is a visibility cycle, and the polygons must be split. Splitting is accomplished by selecting one polygon and cutting it along the line of intersection with the other polygon. The above tests are again performed, and the algorithm continues until all polygons pass the above tests.

References

  • Sutherland, Ivan E.; Sproull, Robert F.; Schumacker, Robert A. (1974), "A characterization of ten hidden-surface algorithms", Computing Surveys, 6 (1): 1–55, doi:10.1145/356625.356626.
  • Newell, M. E.; Newell, R. G.; Sancha, T. L. (1972), "A new approach to the shaded picture problem", Proc. ACM National Conference, pp. 443–450.

See also