Jump to content

Talk:Injection molding of liquid silicone rubber

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

I have cleaned up the page. I have made it flow better, and organized it more logically. In doing this, I have put the bit about the injection molding process (versus the properties of the products) into its own section. I have also removed excessive links.

It appears that the original text is citing the "International Plastics Handbook". I'm going to cite it as the source.

Georgesch4 20:22, 3 November 2006 (UTC)[reply]

Wikishness in question

[edit]

Is this really wikiworthy?

'A good cold runner is expensive as compared to conventional hot runner tooling, and will provide a high level of performance IF IT IS PROPERLY MAINTAINED. Unfortunately in my experience this is not usually the case.' — Preceding unsigned comment added by 165.228.233.174 (talk) 07:07, 18 October 2011 (UTC)[reply]