This article needs additional citations for verification. (January 2012) (Learn how and when to remove this template message)
A cable tie (also known as a hose tie, or zip tie, and by the brand names Ty-Rap) is a type of fastener, for holding items together, primarily electrical cables or wires. Because of their low cost and ease of use, cable ties are ubiquitous, finding use in a wide range of other applications. Stainless steel versions, either naked or coated with a rugged plastic, cater for exterior applications and hazardous environments.
The common cable tie, normally made of nylon, has a flexible tape section with teeth that engage with a pawl in the head to form a ratchet so that as the free end of the tape section is pulled the cable tie tightens and does not come undone. Some ties include a tab that can be depressed to release the ratchet so that the tie can be loosened or removed, and possibly reused.
Design and use
The most common cable tie consists of a flexible nylon tape with an integrated gear rack, and on one end a ratchet within a small open case. Once the pointed tip of the cable tie has been pulled through the case and past the ratchet, it is prevented from being pulled back; the resulting loop may only be pulled tighter. This allows several cables to be bound together into a cable bundle and/or to form a cable tree.
A cable tie tensioning device or tool may be used to apply a cable tie with a specific degree of tension. The tool may cut off the extra tail flush with the head in order to avoid a sharp edge which might otherwise cause injury.
In order to increase resistance to ultraviolet light in outdoor applications nylon containing a minimum of 2% carbon black is used to protect the polymer chains and extend the cable tie's service life. Blue cable ties are supplied to the food industry and contain a metal additive so they can be detected by industrial metal detectors. Cable ties made of ETFE (Tefzel) are used in radiation-rich environments. Red cable ties made of ECTFE (Halar) are used for plenum cabling.
PlastiCuffs are handcuffs based on the cable tie design and are used by law enforcement to restrain prisoners. Cable ties are also sometimes used to prevent hubcaps (also known as wheel trims) from falling off a moving vehicle, and some are sold specifically for this purpose.
Cable ties were first invented by Thomas & Betts, an electrical company, in 1958 under the brand name Ty-Rap. Initially they were designed for airplane wire harnesses. The original design used a metal tooth, and these can still be obtained. Manufacturers later changed to the nylon/plastic design.[self-published source]
The design has over the years been extended and developed into numerous spin-off products. One example was a self-locking loop developed as an alternative to purse-string suture in colon anastomosis.
Ty-Rap cable tie inventor, Maurus C. Logan, worked for Thomas & Betts and finished his career with the company as Vice President of Research and Development. During his tenure at Thomas & Betts, he contributed to the development and marketing of many successful Thomas & Betts products. Logan died on 12 November 2007, at the age of 86.
The idea of the cable tie came to Logan while touring a Boeing aircraft manufacturing facility in 1956. Aircraft wiring was a cumbersome and detailed undertaking, involving thousands of feet of wire organized on sheets of 50-foot long plywood and held in place with knotted, waxcoated, braided nylon cord. Each knot had to be pulled tight by wrapping the cord around one's finger which sometimes cut the operator's fingers until they developed thick calluses or "hamburger hands." Logan was convinced there had to be an easier, more forgiving, way to accomplish this critical task.
Cable ties are generally viewed as single-use devices; they are typically cut off rather than loosened and reused. However, if a closed loop needs to be opened again, rather than destroying the cable tie by cutting, it may be possible to release the ratchet from the rack. While some cable ties are designed for reuse with a tab that releases the ratchet, in most cases a sewing needle or similar object (for example a small screwdriver) will need to be interposed between the ratchet and the rack. Ties reused in this way will be weaker than new ones.
Types of specialty cable ties
- Beaded cable ties: Beaded design allows them to be releasable and reusable
- Releasable cable ties: Reusable cable ties with a releasable ratchet
- Ladder style cable ties: For intermediate bundling and retail applications
- Identification cable ties: Built-in flags for written or printed identification
- Parallel entry cable ties: Tamper-proof, low profile heads
- Tear-off cable ties: Quick release design requires no cutting tools
- Pull-tight seals: Tamper-evident seals
- Steggel ties: Heavy duty, multipurpose ties
Other methods of bundling cable together securely and semi-permanently include cable lacing, strapping, binding knots such as the surgeon's knot or constrictor knot, Velcro brand hook-and-loop strips, conveyor belt hooks, twist ties, Rapstrap fasteners, or metal buckle.
- "Stainless steel cable ties" (PDF). Thomas & Betts.
- Dodds, Chris on (15 November 2013). "Detectable Cable Ties for Food Industry". cablejoints.co.uk. Retrieved 14 July 2017.
- Meissner, Craig (December 1, 2002). "Ties That Bind". Police Magazine.
- See the Thomas and Betts official website. Archived November 4, 2013, at the Wayback Machine
- Höglund, Odd V.; Maxon, Oskar; Grönberg, Anders (8 February 2017). "A self-locking loop as an alternative to purse-string suture in colon anastomosis: a feasibility study". BMC Research Notes. 10 (1). doi:10.1186/s13104-017-2412-4. PMC 5299739. PMID 28179015.
- "Maurus C. Logan Obituary".
- Maurus C. Logan, "Cable bundling and supporting strap",U.S. Patent 3,022,557, filed 24 June 1958, issued 27 February 1962.
- Williams, TB; Williams, JM; Rodgerson, DH (June 2017). "Internal fixation of fractured ribs in neonatal foals with nylon cable tie using a modified technique". The Canadian Veterinary Journal. 58 (6): 579–581. PMC 5432144. PMID 28588328.
- "Sterna-Band Sutures for Closure of Median Sternotomies and Lateral Thoracotomies". www.sternaband.com.
- Grapow, Martin TR; Melly, Ludovic F; Eckstein, Friedrich S; Reuthebuch, Oliver T (25 June 2012). "A new cable-tie based sternal closure system: description of the device, technique of implantation and first clinical evaluation". Journal of Cardiothoracic Surgery. 7 (1). doi:10.1186/1749-8090-7-59. PMC 3408342. PMID 22731778.
- Downs, C; Rodgerson, D (March 2011). "The use of nylon cable ties to repair rib fractures in neonatal foals". The Canadian Veterinary Journal. 52 (3): 307–9. PMC 3039906. PMID 21629427.
|Wikimedia Commons has media related to Cable ties.|