Jump to content

Ohio State Route 435

Route map:
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Ohnoitsjamie (talk | contribs) at 22:03, 15 July 2020 (Reverted edits by DecimalGD (talk) to last version by InternetArchiveBot). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

State Route 435 marker
State Route 435
Route information
Maintained by ODOT
Length4.084 mi[1] (6.573 km)
Existed2003–present
Major junctions
West end US 35 near Octa
Major intersections I-71 in Octa
US 35 near Milledgeville
East end SR 729 near Milledgeville
Location
CountryUnited States
StateOhio
CountiesFayette
Highway system
  • Ohio State Highway System
SR 430 SR 440

State Route 435 (SR 435, OH 435) is a 4.084-mile (6.573 km) long east–west state highway in the southwestern portion of the U.S. state of Ohio. The western terminus of SR 435 is at a partial interchange with U.S. Route 35 (US 35) approximately 5.50 miles (8.85 km) southwest of Jeffersonville, and its eastern terminus is a T-intersection with SR 729 nearly 2 miles (3.2 km) northeast of Milledgeville.

This route follows a former alignment of US 35, which now bypasses this area along a freeway alignment. SR 435 provides access between current U.S. Route 35 and Interstate 71 (I-71), as no direct interchange exists between the two highways.

Route description

Traffic volume on State Route 435
County Log Point Volume
0.5 3,300
0.8 4,270
1.404 9,800
1.65 16,380
1.787 13,500
2.0 6,390
2.562 1,640
2.922 1,440

The entirety of SR 435 is nestled within the northwestern quadrant of Fayette County. This highway is not included as a part of the National Highway System (NHS). The NHS is a network of routes identified as being most important for the economy, mobility and defense of the nation.[3]

SR 435 starts at an incomplete directional T interchange at US 35, and passes through farmland. The route moves southwest and meets the old routing of US 35. SR 435 crosses over I-71 at a diamond interchange, between Allen Road and West Lancaster Road. The route intersects Factory Shops Boulevard, which leads to a shopping center. Then, SR 435 passes over US 35 again, and soon becomes concurrent with SR 729. A mile later, the concurrency ends, and SR 435 ends at SR 729.[1][4]

History

US 35 between Xenia and Washington Court House was moved onto a new freeway alignment in 2003. Consequently, the majority of the former two-lane routing was removed from the state highway system. However, the re-routing resulted in there being no direct connection between US 35 and I-71 at Octa. To alleviate this, a new connector was built between the freeway just northwest of I-71 and the former routing of US 35. From this point to the easternmost point of the SR 729 overlap of the previous routing of US 35, the old routing of US 35 was kept in the state highway system. The connector, along with this portion of former US 35, was assigned the SR 435 designation. This allowed for not only a connection between I-71 and the new US 35 freeway, but also SR 729 and the freeway.[5][6]

Northeast Ohio former plans

SR 435 was once a proposed limited-access north–south highway in Portage County and Stark County, as a result of a regional planning report. Connections in Portage would have been at SR 14, SR 59, SR 261, I-76 and US 224. Connections in Stark would have been at SR 619, State Street NE, SR 173, US 62, SR 153, SR 172, US 30 and would have terminated at SR 183 in Sandy. Designed to relieve traffic from SR 43 and SR 44, its centerline was 1-mile (1.6 km) east of State Route 43. However, the plan was never implemented beyond the planning stages. Instead,[citation needed] the city of Kent and Brimfield Township expanded SR 43 from two lanes to four to provide better access to I-76.[7]

Major intersections

The entire route is in Fayette County.

Locationmi[1]kmDestinationsNotes
Jefferson Township0.000.00
US 35 west – Xenia
Partial interchange; access provided from US 35 eastbound to SR 435 eastbound and from SR 435 westbound to US 35 westbound only
Octa1.534–
1.679
2.469–
2.702
I-71 – Columbus, CincinnatiExit 65 (I-71)
Jefferson Township2.175–
2.448
3.500–
3.940

US 35 east – Washington Court House
Partial interchange; access provided from SR 435 to US 35 eastbound and from US 35 westbound to SR 435 only
Jasper Township2.9134.688
SR 729 south – Milledgeville
Western end of SR 729 concurrency
4.0846.573


SR 729 north / CR 35A east (Old US 35) to US 35 west – Jeffersonville, Washington Court House
Eastern end of SR 729 concurrency
1.000 mi = 1.609 km; 1.000 km = 0.621 mi

References

KML is from Wikidata
  1. ^ a b c Ohio Department of Transportation. "Technical Services DESTAPE - Fayette County" (PDF). Retrieved 2015-06-18.
  2. ^ Staff. "Transportation Information Mapping System". Ohio Department of Transportation. Archived from the original on 2013-09-16. Retrieved 2015-06-18.
  3. ^ National Highway System: Ohio (PDF) (Map). Federal Highway Administration. December 2003. Retrieved 2015-06-18.
  4. ^ "Ohio State Route 435" (Map). Google Maps. Retrieved 2015-06-18.
  5. ^ Ohio Department of Transportation (June 2001). Official Ohio Transportation Map (PDF) (Map) (2001–2002 ed.). c. 1:570,240. Columbus: Ohio Department of Transportation. OCLC 5673562, 31884639, 52954853. Retrieved 2015-06-18.
  6. ^ Ohio Department of Transportation (January 2003). Official Ohio Transportation Map (PDF) (Map) (2003–2004 ed.). c. 1:570,240. Columbus: Ohio Department of Transportation. OCLC 5673562, 31884639. Retrieved 2015-06-18.
  7. ^ 1874–1978 Bicentennial Atlas of Portage County. Ravenna, Ohio: Portage County Historical Society. 1978. pp. K-23, K-25. Pages include a 1975 highway map and a 1974 highway plan for Portage and Summit Counties.