Jump to content

Mix automation

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Kvng (talk | contribs) at 22:46, 17 August 2020 (lead: link improvements). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Part of a series on
Automation
Automation in general
Robotics and robots
Impact of automation
Trade shows and awards

In music recording, mix automation allows the console to remember the audio engineer's adjustment of faders during the post-production editing process. A timecode is necessary for the synchronization of automation. Modern mixing consoles and digital audio workstations use comprehensive mix automation.

The need for mix automation originates from the 1970s and the changeover from studios mostly using eight-track tape machines to multiple, synchronized 24-track recorders. Mixing could be laborious and require up to four people, and the results could be almost impossible to reproduce. Manufacturers such as Solid State Logic and AMS Neve developed systems which enabled one engineer to oversee every detail of a complex mix, although the computers required to power these desks remained a rarity into the late 1970s.[1]

According to record producer Roy Thomas Baker, Queen's 1975 single "Bohemian Rhapsody" was one of the first mixes to be done with automation.[2]

Types

Voltage Controlled Automation
fader levels are regulated by voltage-controlled amplifiers (VCA). VCAs control the audio level and not the actual fader.
Moving Fader Automation
a motor is attached to the fader, which then can be controlled by the console, digital audio workstation (DAW), or user.
Software Controlled Automation
the software can be internal to the console, or external as part of a DAW. The virtual fader can be adjusted in the software by the user.
MIDI Automation
the communications protocol MIDI can be used to send messages to the console to control automation.

Modes

Auto Write
used the first time automation is created or when writing over existing automation
Auto Touch
writes automation data only while a fader is touched/faders return to any previously automated position after release
Auto Latch
starts writing automation data when a fader is touched/stays in position after release
Auto Read
digital Audio Workstation performs the written automation
Auto Off
automation is temporarily disabled

All of these include the mute button. If mute is pressed during writing of automation, the audio track will be muted during playback of that automation. Depending on software, other parameters such as panning, sends, and plug-in controls can be automated as well. In some cases, automation can be written using a digital potentiometer instead of a fader.

See also

References

  1. ^ Inglis, Sam. "Creative Mix Automation In Your DAW". Sound on Sound. Retrieved 31 August 2019.
  2. ^ Clark, Rick (1 April 1999). "Roy Thomas Baker: TAKING CHANCES AND MAKING HITS". Mix. Archived from the original on 26 April 2005. Retrieved 28 August 2019.
  • Stanley R. Alten. Audio in Media, sixth edition. Wadsworth, 2002.
  • David Miles Huber and Robert Runstein. Modern Recording Techniques, sixth edition. Oxford: Focal Press, 2005.

Free open source Mix automation software

Retrieved from "https://en.wikipedia.org/w/index.php?title=Mix_automation&oldid=973562308"