Jump to content

BS National Beehive

Add links
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Mike Peel (talk | contribs) at 01:02, 5 December 2020 (Removing Commons category link that does not match this article (commons:Category:Bee skeps)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

CGI rendering of BS National Beehive, cutaway to show the internal parts.

The Improved National Beehive was a form of Langstroth beehive standardized by two British Standards (in 1946 and then in 1960, before being withdrawn in 1984[1]). The same standard contained the specification of the Smith beehive: these two forms represent the most popular designs used in the UK.

Design

The National hive, as it usually known, is based on Langstroth hive design principles: a vertical stack of modular components. Its dimensions are generally smaller and notably the brood chamber is shallower than the typical Langstroth hive to suit a less prolific bee strain.

The original specification and the associated Ministry of Agriculture, Fisheries and Food leaflet[2] detail a floor (now often superseded by an open-mesh floor which allows monitoring of Varroa infestation), stand, deeper standard brood boxes, shallower honey Super boxes, a section rack (for production of sections of comb honey), a crownboard and a roof. The main boxes are 18⅛" (460mm) square in footprint: the standard brood boxes being 8⅞" (225mm) tall, and the shallow super 5⅞" (150mm) tall. The main walls are ¾" (19mm) thick.

BS National standard (brood) box, with frames shown through cutaway (two frames removed, to show detail).

The internal frames are supported on runners on two sides of the box, in a deep rebate formed by the two-piece construction of the sides. Because the boxes are square, it is possible to orient frames in two ways with respect to the entrance, either parallel to the entrance block ('warm way'), or perpendicular to it ('cold way').

The National beehive is specifically designed to house frames detailed in the standard. These are 14" (355mm) wide, with a height of either 8½" or 5½" (216mm or 140mm). In brood boxes, up to twelve frames can be used, but (once propolised), twelve frames are typically too tight a fit for easy use, and eleven frames (with, perhaps, a dummy board filling the space) are more common; in honey supers, between nine and twelve can be used, depending on the spacing chosen. The National frames have a long top-bar to the frame (17" or 432mm) giving them long lugs of 1½"/38mm that rest on the runners.

In its original form, the National hive provides ⅜" (9mm) bottom beespace—that is, the top surface of the frame bar is flush with the top of the box, and the lower surface of the frame is one bee space above the bottom of the box. Thus, when two boxes are stacked atop one another, there is exactly one beespace vertically between the frames. However, both top and bottom beespace designs may now be found in use.

Blue: roof. Grey: crownboard Brown: shallow super; Gold: shallow frames. Purple: queen excluder. Red: standard broodbox; pink: standard frames. Lime: floor; green: entrance block. Teal: stand.

The roof shown in the MAFF leaflet is a telescoping cover, with internal dimensions of 18¾" (476mm), meaning a relatively loose fit over the topmost box. The total height of the roof is (depending on timber thickness) around 6¼" (160mm), though a 4" roof is now also common. Supports set into the roof create a 1¼" ventilation space above the crownboard rim (therefore 1½" above the crownboard surface, as it has a raised rim creating ¼" beespace on both sides): the total overlap of the telescoping cover is thus 4.5" (114mm). The roof must be covered with a waterproofing layer: typically this may be galvanized steel sheet.

Box Length x width /mm Height/mm Frame capacity Frame width/mm Frame height/mm Volume/l Comb area/m2 Cells[3]
Standard (brood) 460 x 460 (external)

374 x 424 (internal)

225 11(in practice) 355 216 35.7 1.42 63,525
Shallow (honey super) 150 10–12 140 23.8 0.77–.93 34,700–41,800
Deep (14x12) 315 11 (in practice) 305 50.0 2.07 93,500

Features

The National hive has a number of features which—in addition to the inertia of popularity—recommend it.

  • The standard brood box is considered well suited to non-prolific bees, providing just over 63,000 cells, and has sufficient space both for summer brood rearing, and winter storage.
  • There are several methods to increase the size of the brood chamber, if this is required:
    • Use of a larger 14x12 box (where the height of the frame is 12" (305mm), instead of the standard 8½", and the box is thus either 12⅜" or 12½" tall. (This box is not part of the original British Standard, and is thus of variable height.)
    • A second standard brood box, thereby doubling the size.
    • Brood and a half chamber of a standard and a shallow box.
  • The weight of a full honey super is still manageable by one person, especially as the boxes have secure handholds (created by the two-piece sides).

References

  1. ^ "History of beehives". shop.bsigroup.com. Retrieved 2017-01-27.
  2. ^ "MAFF Leaflet 367" (PDF). May 1961. Retrieved 27 January 2017.
  3. ^ "Honeycomb Cell Size". Retrieved 27 January 2017.
Look up beehive in Wiktionary, the free dictionary.
Retrieved from "https://en.wikipedia.org/w/index.php?title=BS_National_Beehive&oldid=992391098"