Jump to content

Hydrogen compressor

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Cydebot (talk | contribs) at 09:49, 4 April 2016 (Robot - Speedily moving category Compressors to Category:Gas compressors per CFDS.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

A hydrogen compressor is a device that increases the pressure of hydrogen by reducing its volume resulting in compressed hydrogen or liquid hydrogen.

Compressor vs pump

Hydrogen compressors are closely related to hydrogen pumps and gas compressors: both increase the pressure on a fluid and both can transport the fluid through a pipe. As gases are compressible, the compressor also reduces the volume of hydrogen gas, whereas the main result of a pump raising the pressure of a liquid is to allow the liquid hydrogen to be transported elsewhere.

Types

Ionic liquid piston compressor

An ionic liquid piston compressor is a hydrogen compressor based on an ionic liquid piston instead of a metal piston as in a piston-metal diaphragm compressor.[1]

Electrochemical hydrogen compressor

A multi-stage electrochemical hydrogen compressor incorporates a series of membrane-electrode-assemblies (MEAs), similar to those used in proton exchange membrane fuel cells; this type of compressor has no moving parts and is compact. With electrochemical compression of hydrogen, a pressure of 5000 psi is achieved. Pressure is believed to go beyond 10,000 psi to the structural limits of the design.[2] A patent is pending for an exergy efficiency of 70 to 80% for pressures up to 10,000 psi or 700 bars.[3] A single stage electrochemical compression to 800 bar was reached in 2011.[4]

Hydride compressor

In a hydride compressor, thermal and pressure properties of a hydride are used to absorb low-pressure hydrogen gas at ambient temperatures and then release high-pressure hydrogen gas at higher temperatures; the bed of hydride is heated with hot water or an electric coil.[5]

Piston-metal diaphragm compressor

Piston-metal diaphragm compressors are stationary high-pressure compressors, four-staged water-cooled, 11–15 kW, 30–50 Nm3/h 40 MPa for dispensation of hydrogen.[6] Since compression generates heat, the compressed gas is to be cooled between stages making the compression less adiabatic and more isothermal. The default assumption on diaphragm hydrogen compressors is an adiabatic efficiency of 70%.[7] Used in hydrogen stations.

Guided rotor compressor

The guided rotor compressor (GRC) is a positive-displacement rotary compressor based upon an envoluted trochoid geometry which utilizes a parallel trochoid curve to define its basic compression volume.[8][9] It has a typical 80 to 85% adiabatic efficiency.[10]

Linear compressor

The single-piston linear compressor uses dynamic counterbalancing, where an auxiliary movable mass is flexibly attached to a movable piston assembly and to the stationary compressor casing using auxiliary mechanical springs with zero vibration export at minimum electrical power and current consumed by the motor.[11] It is used in cryogenics

See also

References