A transponder (short for transmitter-responder and sometimes abbreviated to XPDR, XPNDR, TPDR or TP) is an electronic device that produces a response when it receives a radio-frequency interrogation. Aircraft have transponders to assist in identifying them on air traffic control radar; and collision avoidance systems have been developed to use transponder transmissions as a means of detecting aircraft at risk of colliding with each other.
Air traffic control units use the term "squawk" when they are assigning an aircraft a transponder code, e.g., "Squawk 7421". Squawk thus can be said to mean "select transponder code" or "squawking" to mean "I have selected transponder code xxxx".
The transponder receives interrogation from the Secondary Surveillance Radar on 1030 MHz and squawks back on 1090 MHz.
Secondary surveillance radar
Secondary surveillance radar (SSR) is referred to as "secondary", to distinguish it from the "primary radar" that works by passively reflecting a radio signal off the skin of the aircraft. Primary radar determines range and bearing to a target with reasonably high fidelity, but it cannot determine target elevation (altitude) reliably except at close range. SSR uses an active transponder (beacon) to transmit a response to an interrogation by a secondary radar. This response most often includes the aircraft's pressure altitude and a 4-digit octal identifier.
A pilot may be requested to squawk a given code by the air traffic controller via the radio, using a phrase such as "Cessna 123AB, squawk 0363". The pilot then selects the 0363 code on their transponder and the track on the radar screen of the air traffic controller will become correctly associated with their identity.
Because primary radar generally gives bearing and range position information, but lacks altitude information, mode C and mode S transponders also report pressure altitude. Some lower-end altimeters do not normally have a built in encoder and so a modified Gray code, called a Gillham code, is used to pass altitude information to the transponder. Around busy airspace there is often a regulatory requirement that all aircraft be equipped with altitude-reporting mode C or mode S transponders. In the United States, this is known as a Mode C veil. Mode S transponders are compatible with transmitting the mode C signal, and have the capability to report in 25 foot increments. Without the pressure altitude reporting, the air traffic controller has no display of accurate altitude information, and must rely on the altitude reported by the pilot via radio. Similarly, the traffic collision avoidance system (TCAS) installed on some aircraft needs the altitude information supplied by transponder signals.
All mode A, C, and S transponders include an "IDENT" button, which activates a special thirteenth bit on the mode A reply known as IDENT, short for "identify". When ground-based radar equipment receives the IDENT bit, it results in the aircraft's blip "blossoming" on the radar scope. This is often used by the controller to locate the aircraft amongst others by requesting the ident function from the pilot, e.g., "Cessna 123AB, squawk 0363 and ident".
Ident can also be used in case of a reported or suspected radio failure to determine if the failure is only one way and whether the pilot can still transmit or receive, but not both, e.g., "Cessna 123AB, if you read, squawk ident".
Transponder codes are four digit numbers transmitted by the transponder in an aircraft in response to a secondary surveillance radar interrogation signal to assist air traffic controllers in traffic separation. A discrete transponder code (often called a squawk code) is assigned by air traffic controllers to identify an aircraft uniquely in a FIR. This allows easy identification of aircraft on radar.
Squawk codes are four-digit octal numbers; the dials on a transponder read from zero to seven, inclusive. Thus the lowest possible squawk is 0000 and the highest is 7777. Four octal digits can represent up to 4096 different codes, which is why such transponders are often called "4096 code transponders." Care must be taken not to squawk any emergency code during a code change. For example, when changing from 1200 to 6501 (an example of an assigned air traffic control squawk), one might turn the second wheel to a 5 (thus 1500), and then rotate the first wheel backwards in the sequence 1-0-7-6 to get to 6. This would momentarily cause the transponder to squawk the code 7500, which is an emergency code signalling to ATC that the aircraft has been hijacked, causing an unnecessary false alarm situation. However, while it is important to not select an emergency code by mistake, pilots are also instructed to avoid setting the transponder in "standby mode" as a means of avoiding accidental selection, as it causes the loss of target information by ATC. Modern digital transponders allow the direct selection of squawk codes, without having to cycle past other numbers.
Codes assigned by air traffic control
Most codes in the following table can be selected by aircraft if and when the situation requires or allows it, without permission from ATC. Other codes are generally assigned by ATC units. For flights on instrument flight rules (IFR), the squawk code is typically assigned as part of the departure clearance and stays the same throughout the flight.
Flights on visual flight rules (VFR), when in uncontrolled airspace, will "squawk VFR" (or conspicuity code in the UK, 1200 in the U.S., 7000 in Europe). Upon contact with an ATC unit, they will be told to squawk a certain unique code. When changing frequency, for instance because the VFR flight leaves controlled airspace or changes to another ATC unit, the VFR flight will be told to "squawk VFR" again.
In order to avoid confusion over assigned squawk codes, ATC units will typically be allocated blocks of squawk codes, not overlapping with the blocks of nearby ATC units, to assign at their discretion.
Not all ATC units will use radar to identify aircraft, but they assign squawk codes nevertheless. As an example, London Information – the flight information service station that covers the lower half of the UK – does not have access to radar images, but does assign squawk code 1177 to all aircraft that receive a FIS from them. This tells other radar equipped ATC units that that specific aircraft is listening on the London Information radio frequency, in case they need to contact that aircraft.
|Beacon code||Allocated use|
|0500, 0600, 0700||
|2200, 2300, 2400||
|2500, 2600, 2700||
|3100, 3200, 3300, 3400, 3500, 3600, 3700||
|4500, 4600, 4700||
|5061-5062, 5100, 5200||
|5100, 5200, 5300, 5500||
|6500, 6600, 6700||
|7100, 7200, 7300, 7400|
- Transponder-related accidents
- 1986 Cerritos mid-air collision — August 31, 1986 (one of the aircraft equipped with a Mode A, but not Mode C, transponder)
- Iran Air Flight 655 — July 3, 1988 (incorrect interpretation of transponder code a factor in mistaken identity and shot down)
- Korean Air Flight 85 — September 11, 2001 (suspected hijack involving the transponder code, false alarm)
- Gol Transportes Aéreos Flight 1907 — September 29, 2006 (accident where one aircraft had a non-functional transponder)
- Mangine, Robert (2007). "The Truth About Transponders". Retrieved 2008-12-24.
- Farlex, Inc (2008). "XPDR". Retrieved 2008-12-24.
- Farlex, Inc (2008). "XPNDR". Retrieved 2008-12-24.
- Farlex, Inc (2008). "TPDR". Retrieved 2008-12-24.
- Farlex, Inc (2008). "TP". Retrieved 2008-12-24.
- Transport Canada (20 May 2010). "TP 14371 — Transport Canada Aeronautical Information Manual (TC AIM) RAC 1.9 Transponder Operation". Retrieved 21 August 2010.
- Peppler, I.L.: From The Ground Up, pages 238–239. Aviation Publishers Co. Limited, Ottawa Ontario, Twenty Seventh Revised Edition, 1996. ISBN 0-9690054-9-0
- "Air Traffic Control Radar Beacon Transponder (ATCRBS) Airborne Equipment Technical Standard Order C74d" (PDF). Federal Aviation Administration.
- Phil Vabre. "Air Traffic Services Surveillance Systems". www.airwaysmuseum.com. Retrieved 2010-04-15.
- Rogers, Tom. "Transponder Basics". AVweb. Retrieved 2014-03-18.
- Getline, Meryl (17 April 2006). "Ask the Captain: Strangle my WHAT?". USA Today. Retrieved 2008-03-13.
- Vabre, Phil. "Air Traffic Services Surveillance Systems, Including An Explanation of Primary and Secondary Radar". The Airways Museum & Civil Aviation Historical Society. Retrieved 2008-03-13.
- ENR 1.6.2 — SSR Operating Procedures
- ICAO doc 4444 & ICAO Annex 10
- "UK AIP ENR 1.6.2 — SSR Operating Procedures and UK SSR Code Assignment Plan" (PDF). UK Civil Aviation Authority. 6 November 2007.
- US Department of Transportation, Federal Aviation Administration. "JO 7110.66D, National Beacon Code Allocation Plan". US Government. Retrieved 26 April 2012.
- "Radio Communications". Cleared for Takeoff: Your Handbook for Becoming a Private Pilot (Revision E ed.). King Schools, Inc. 2006. pp. 4–16.
- "Change of German VFR transponder codes A/C 7000 replaces A/C 0021 and A/C 0022". SkyControl Aviation & Aerospace News. 6 November 2007.
- Australian AIP ENR 1.6 para 7.1.4
- FAA ORDER/PUBLICATION: 7110.65U dated 5/18/2011
- FAA ORDER/PUBLICATION 7110.65V dated 02/19/2014
- FAA order JO 7110.65U
- "FAA Order 7110.65R (Air Traffic Control procedural manual) — chapter 5.2, Beacon Systems". Federal Aviation Authority. 21 January 2008.
- "DZ Transponder Codes/Separations Flashcards - Quizlet". quizlet.com. Retrieved 21 July 2016.
- Cite error: The named reference
AUS_AIP_1.6_6.4.6was invoked but never defined (see the help page).
- "Aeronautical Information Manual, chapter 4 — Air Traffic Control". Federal Aviation Administration. 6 November 2007.