Island-class patrol boat
USCGC Knight Island (WPB-1348) commissioned in 1992, the second newest Island-class 110
|Builders:||Bollinger Shipyards, Lockport, Louisiana|
|Operators:||United States Coast Guard, Coast Guard of Georgia, Sea Shepherd Conservation Society|
|Length:||110 ft (34 m)|
|Beam:||21 ft (6.4 m)|
|Draft:||6.5 ft (2.0 m)|
|Propulsion:||2 Paxman Valenta or Caterpillar diesels|
|Boats & landing
|1 - Cutter Boat Medium (Yamaha 90 HP outboard engine)|
|Complement:||16 (2 officers, 14 enlisted)|
The Island-class patrol boat is a class of cutters of the United States Coast Guard. 49 cutters of the class were built, of which 37 remain in commission. Their hull numbers are WPB-1301 through WPB-1349.
The 110 ft (34 m) Island-class patrol boats are a U.S. Coast Guard modification of a highly successful British-designed patrol boat. With excellent range and seakeeping capabilities, the Island class, all named after U.S. islands, replaced the older 95 ft (29 m) Cape-class cutters. These cutters are equipped with advanced electronics and navigation equipment and are used in support of the Coast Guard's maritime homeland security, migrant interdiction, drug interdiction, defense operations, fisheries Enforcement, and search and rescue missions. The 58 ordered Sentinel-class cutters, selected under the Fast Response Cutter (FRC) program, are slated to replace the Island class. Six Island class cutters are currently stationed in Manama, Bahrain as apart of Patrol Forces Southwest Asia to provide the Navy's Fifth Fleet with combat ready assets.
As built, these vessels were all 110 feet (34 m) in length. In 2002 as part of the Integrated Deepwater System Program, the Coast Guard began refitting some of these vessels, adding 13 feet (4.0 m) to the stern to make room for a high-speed stern launching ramp, and replacing the superstructure so that these vessels had enough room to accommodate mixed gender crews. The refit added about 15 tons to the vessel's displacement, and reduced its maximum speed by approximately one knot. The eight cutters being modified were the USCGC Matagorda (WPB-1303), USCGC Attu (WPB-1317), USCGC Metompkin (WPB-1325), USCGC Padre (WPB-1328), USCGC Manitou (WPB-1302), USCGC Monhegan (WPB-1305), USCGC Nunivak (WPB-1306) and the USCGC Vashon (WPB-1308).
In August 2006, a Lockheed Martin engineer went public with allegations that the company and the Coast Guard were ignoring serious security flaws in the refitting project, and that they were likely to repeat the same mistakes on similar projects. The flaws included blind spots in watch cameras, FLIR equipment not suitable for operating under extreme temperatures, and the use of non-shielded cables in secure communications systems, a violation of TEMPEST standards.
In late November 2006 all eight of the 123 ft (37 m) WPBs were taken out of service due to debilitating problems with their lengthened hulls - all eight hulls were cracking when driven at high speed in heavy seas. These as well as other issues - such as C4ISR problems - drove the program $60 million over budget, triple the original bid for the eight boats converted. The 41 unmodified 110's are now being pressed harder to take up the slack. The eight modified were moved to the United States Coast Guard Yard and moored in Arundel Cove.
USCG Matagorda 123 ft conversion with RIB Short Range Prosecutor on rear ramp
- United States Coast Guard
- Georgian Coast Guard two boats donated in September 2016
- Pakistan Navy three ships via EDA in 2015
- Pakistan Maritime Security Agency two ships via EDA in 2016
- Sea Shepherd purchased the former USCGC Block Island and USCGC Pea Island, June 2015
- USCG Marine Protector-class coastal patrol boat
- USCG Short Range Prosecutor
- USCG Cape-class cutter
- USCG Sentinel-class cutter
- "U.S. Donates Two Patrol Boats to Georgian Coast Guard". Civil Georgia. 1 October 2016. Retrieved 1 October 2016.
- "USCG: 110 ft Patrol Boat". Retrieved 1 March 2011.
- "Patrol Forces Southwest Asia". USCG.mil. US Coast Guard. Retrieved 20 March 2017.
- Alpert, B. (August 18, 2011). Feds Sue Bollinger Shipyards Over 'Unseaworthy' Coast Guard Ships. New Orleans Business News. Retrieved March 28, 2012 from http://www.nola.com/business/index.ssf/2011/08/feds_sue_bollinger_shipyards_o.html.
- Nathaniel R. Helms (2005-06-23). "Coast Guard Scramble Over Deepwater Snag". Military.com. Retrieved 2009-10-08.
- "Coast Guard ends cutter conversion program". marinelog.com. 2005-07-18. Retrieved 2009-10-08.
- Griff Witte (2006-08-29). "On YouTube, Charges of Security Flaws". Washington Post. Retrieved 2009-10-08.
- Eric Lipton (2006-11-30). "Coast Guard to Idle 8 Cutters After $100 Million Renovation". The New York Times. Retrieved 2009-10-08.
- U. S. Coast Guard Patrol Craft. HMC James T. Flynn, Jr. USNR(ret). 2012.
|Wikimedia Commons has media related to Island class cutters.|