Jump to content

Omnidirectional antenna

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Chetvorno (talk | contribs) at 19:39, 15 July 2017 (Added breakafterimages template). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

In radio communication, an omnidirectional antenna is a class of antenna which radiates radio wave power uniformly in all directions in one plane, with the radiated power decreasing with elevation angle above or below the plane, dropping to zero on the antenna's axis. This radiation pattern is often described as "doughnut shaped". Note that this is different from an isotropic antenna, which radiates equal power in all directions and has a "spherical" radiation pattern. Omnidirectional antennas oriented vertically are widely used for nondirectional antennas on the surface of the Earth because they radiate equally in all horizontal directions, while the power radiated drops off with elevation angle so little radio energy is aimed into the sky or down toward the earth and wasted. Omnidirectional antennas are widely used for radio broadcasting antennas, and in mobile devices that use radio such as cell phones, FM radios, walkie-talkies, wireless computer networks, cordless phones, GPS as well as for base stations that communicate with mobile radios, such as police and taxi dispatchers and aircraft communications.

The radiation pattern of a simple omnidirectional antenna, a vertical half-wave dipole antenna. In this graph the antenna is at the center of the "donut," or torus. Radial distance from the center represents the power radiated in that direction. The power radiated is maximum in horizontal directions, dropping to zero directly above and below the antenna.
Animation of a omnidirectional half-wave dipole antenna transmitting radio waves. The antenna in the center is two vertical metal rods, with an alternating current applied at its center from a radio transmitter (not shown). Loops of electric field (black lines) leave the antenna and travel away at the speed of light; these are the radio waves. The radiation is uniform about the vertical axis but varies with elevation, being greatest in horizontal directions and zero in vertical directions

Types

Radiation pattern of a 3λ/2 monopole antenna. Although the radiation of an omnidirectional antenna is symmetrical in azmuthal directions, it may vary in a complicated way with elevation angle, having lobes and nulls at different angles.

Common types of low-gain omnidirectional antennas are the whip antenna, "Rubber Ducky" antenna, ground plane antenna, vertically oriented dipole antenna, discone antenna, mast radiator, horizontal loop antenna (sometimes known colloquially as a 'circular aerial' because of the shape) and the halo antenna.

Higher-gain omnidirectional antennas can also be built. "Higher gain" in this case means that the antenna radiates less energy at higher and lower elevation angles and more in the horizontal directions. High-gain omnidirectional antennas are generally realized using collinear dipole arrays. These consist of multiple half-wave dipoles mounted collinearly (in a line), fed in phase.[1] The coaxial collinear (COCO) antenna uses transposed coaxial sections to produce in-phase half-wavelength radiators.[2] A Franklin Array uses short U-shaped half-wavelength sections whose radiation cancels in the far-field to bring each half-wavelength dipole section into equal phase. Another type is the Omnidirectional Microstrip Antenna (OMA).[3]

Analysis

Vertical polarized VHF-UHF biconical antenna 170–1100 MHz with omnidirectional H-plane pattern

Omnidirectional radiation patterns are produced by the simplest practical antennas, monopole and dipole antennas, consisting of one or two straight rod conductors on a common axis. Antenna gain (G) is defined as antenna efficiency (e) multiplied by antenna directivity (D) which is expressed mathematically as: . A useful relationship between omnidirectional radiation pattern directivity (D) in decibels and half-power beamwidth (HPBW) based on the assumption of a pattern shape is:[4]

See also

References

  1. ^ Johnson, R; Jasik, H, eds. (1984). Antenna Engineering Handbook. McGraw Hill. pp. 27–14.
  2. ^ Judasz, T., Balsley, B. (March 1989). "Improved Theoretical and Experimental Models for the Coaxial Colinear Antenna". IEEE Transactions on Antennas and Propagation. 37 (3): 289–296. doi:10.1109/8.18724.{{cite journal}}: CS1 maint: multiple names: authors list (link)
  3. ^ Bancroft R (December 5, 2005). "Design Parameters of an Omnidirectional Planar Microstrip Antenna". Microwave and Optical Technology Letters. 47 (5): 414–8. doi:10.1002/mop.21187.
  4. ^ McDonald, Noel (April 1999). "Omnidirectional Pattern Directivity in the Presence of Minor Lobes: Revisited". IEEE Transactions on Antennas and Propagation. 41 (2): 63–8.