Jump to content

Radar warning receiver

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Strak Jegan (talk | contribs) at 11:37, 25 February 2015 (References). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Radar warning receiver (RWR) systems detect the radio emissions of radar systems. Their primary purpose is to issue a warning when a radar signal that might be a threat (such as a police speed detection radar) is detected. The warning can then be used, manually or automatically, to evade the detected threat. RWR systems can be installed in all kind of airborne, sea-based, and ground-based assets (such as aircraft, ships, automobiles, military bases). This article is focused mainly on airborne military RWR systems; for commercial police RWR systems, see radar detector.

Depending on the market the RWR system is designed for, it can be as simple as detecting the presence of energy in a specific radar band (such as police radar detectors). For more critical situations, such as military combat, RWR systems are often capable of classifying the source of the radar by the signal's strength, phase and waveform type, such as pulsed power wave or continuous wave with amplitude modulation or frequency modulation (chirped). The information about the signal's strength and waveform can then be used to estimate the most probable type of threat the detected radar poses. Simpler systems are typically installed in less expensive assets like automobiles, while more sophisticated systems are installed in mission critical assets such as military aircraft.

Description

The RWR usually has a visual display somewhere prominent in the cockpit (in some modern aircraft, in multiple locations in the cockpit) and also generates audible tones which feed into the pilot's (and perhaps RIO/co-pilot/GIB's in a multi-seat aircraft) headset. The visual display often takes the form of a circle, with symbols displaying the detected radars according to their direction relative to the current aircraft heading (i.e. a radar straight ahead displayed at the top of the circle, directly behind at the bottom, etc.). The distance from the center of the circle, depending on the type of unit, can represent the estimated distance from the generating radar, or to categorize the severity of threats to the aircraft, with tracking radars placed closer to the center than search radars. The symbol itself is related to the type of radar or the type of vehicle that carries it, often with a distinction made between ground-based radars and airborne radars. Audible tones are usually assigned to each type of threat or type of radar and are fairly distinctive. The more serious the threat, the more shrill the tone[citation needed]. For example, an active missile seeker might be represented by a high pitched, almost continuous trill, whereas the radar of an obsolete fighter type or SAM system might be a low pitched, intermittent buzz.

The RWR is used for identifying, avoiding, evading or engaging threats. For example, a fighter aircraft on a combat air patrol (CAP) might notice enemy fighters on the RWR and subsequently use its own radar set to find and eventually engage the bandit. In addition, the RWR helps identify and classify threats—it's hard to tell[citation needed] which blips on a radar console-screen are dangerous, but since different fighter aircraft typically have different types of radar sets, once they turn them on and point them near the aircraft in question it may be able to tell, by the direction and strength of the signal, which of the blips is which type of fighter.

A non-combat aircraft, or one attempting to avoid engagements, might turn its own radar off and attempt to steer around threats detected on the RWR. Especially at high altitude (more than 30,000 feet AGL), very few[citation needed] threats exist that don't emit radiation. As long as the pilot is careful to check for aircraft that might try to sneak up without radar, say with the assistance of AWACS or GCI, it should be able to steer clear of SAMs, fighter aircraft and high altitude, radar-directed AAA.

SEAD and ELINT aircraft often have sensitive and sophisticated RWR equipment like the U.S. HTS (HARM targeting system) pod which is able to find and classify threats which are much further away than those detected by a typical RWR, and may be able to overlay threat circles on a map in the aircraft's multi-function display (MFD), providing much better[1] information for avoiding or engaging threats, and may even store information to be analyzed later or transmitted to the ground to help the commanders plan future missions.

The RWR can be an important tool for evading threats if avoidance has failed. For example, if a SAM system or enemy fighter aircraft has fired a missile (for example, a SARH-guided missile) at the aircraft, the RWR may be able to detect the change in mode that the radar must use to guide the missile and notify the pilot with much more insistent warning tones and flashing, bracketed symbols on the RWR display. The pilot then can take evasive action to break the missile lock-on or dodge the missile. The pilot may even be able to visually acquire the missile after being alerted to the possible launch. What's more, if an actively guided missile is tracking the aircraft, the pilot can use the direction and distance display of the RWR to work out which evasive maneuvers to perform to outrun or dodge the missile. For example, the rate of closure and aspect of the incoming missile may allow the pilot to determine that if they dive away from the missile, it is unlikely to catch up, or if it is closing fast, that it is time to jettison external supplies and turn toward the missile in an attempt to out-turn it. The RWR may be able to send a signal to another defensive system on board the aircraft, such as a Countermeasure Dispensing System (CMDS), which can eject countermeasures such as chaff, to aid in avoidance.

RWR types in service

See also

References