13.2×92mmSR

13.2mm TuF (Tank und Flieger)
Comparison of British .303 and German 13.2mm Tuf
Type	Rifle/machine gun
Place of origin	Germany
Service history
In service	1918–1919
Used by	Germany
Wars	World War I
Production history
Designed	1917
Specifications
Bullet diameter	13.2 mm (0.525 in)
Base diameter	16.3 mm (0.64 in)
Case length	92 mm (3.6 in)
Ballistic performance
Bullet mass/type Velocity Energy 51.5 g Solid 785 m/s 15,868 J
Test barrel length: 39"

The Mauser 13.2mm TuF (German: Tank und Flieger; lit. "tank and aircraft", known also as 13.2×92mmSR) cartridge, was a major step in the development of anti-tank cartridges, being the first one designed for the sole purpose of destroying armored targets.

History

The cartridge was used in the Mauser 1918 T-Gewehr rifle. Its use was also planned in a new machine gun scheduled for deployment in 1919, the MG 18 TuF.

The 13.2 mm Tuf was designed to counter early British tanks which made their appearance during late World War I. Since a tank's path was difficult to determine prior to its deployment near the front, land mines were difficult to employ as a deterrent to their forward passage. Light artillery pieces pressed into service as anti-tank guns were very effective, but cumbersome and difficult to bring into action quickly enough. Thus, another means of combating these early armored vehicles needed to be found. Since early plate armor was relatively thin due to the need to reduce vehicle weight for low powered drive trains to propel the unit (and since tanks were mainly designed to protect from machine gun fire), large bore rifles could be used to harass and kill tank crews.

The development of the .50 BMG round is sometimes confused with the German 13.2 mm TuF. However, the development of the U.S. .50 caliber round was started before this later German project was completed or even known to the Allied countries. When word of the German anti-tank round spread, there was some debate as to whether it should be copied and used as a base for the new machine gun cartridge. However, after some analysis, an exact copy of the German ammunition was ruled out, its performance was inferior to the later .50 BMG (which some maintain is just enlarged .30-06 Springfield round, which in itself is a modification of an earlier German Mauser round), and because it was a semi-rimmed cartridge, making it sub-optimal for an automatic weapon, although others have stated the .50 BMG is nothing more than a rimless necked down copy of the German round. That said, when the U.S. military learned of the German round the .50 BMG was still on the drawing boards and the fact that the .50 BMG was started prior to discovery of the German round can in no way rule out the often stated belief that the German round played a significant part in formulating the .50 BMG round, even if the latter emerged with significantly different ballistic characteristics. Despite an effort by some to claim the .50 BMG was without any outside influences many sources still continue to mention the association between the two rounds, which seems to have at least some merit given the documentary evidence.

Design

The 13.2 Tuf utilized a 92 mm-long semi-rimmed case featuring a shallow bottle-neck. It was developed by the Polte ammunition factory in Magdeburg, Germany.

See also

• List of rifle cartridges
• 13 mm caliber

References

• "An Introduction to Anti-Tank Rifle Cartridges" by Anthony G. Williams