Binding post

For the non-electrical fastener, see Sex bolt.

Adapter between five-way binding posts and a male BNC connector

Two insulated, color-coded binding posts at the bottom center of a signal generator

Uninsulated binding posts on a loudspeaker connected to banana plugs

Small black binding posts of an old loudspeaker driver are visible. These binding posts are not compatible with banana plugs of any size. Instead they were endowed with small solder contacts.

A binding post is a connector commonly used on electronic test equipment to terminate (attach) a single wire or test lead. They are also found on loudspeakers and audio amplifiers as well as other electrical equipment.

History

A binding post contains a central threaded metal rod and a cap that screws down on that rod. Binding posts slowly evolved from 19th century general purpose fasteners into 20th century electrical binding posts. Examples of binding posts used during the 19th century are telegraph key and blasting machine devices.

Caps are commonly insulated with plastic and color-coded: red commonly means an active or positive terminal; black indicates an inactive (reference or return) or negative terminal; and green indicates an earth (ground) terminal. Caps during the 19th century were typically bare metal until synthetic plastic, such as Bakelite, became available in the early 20th century.

During the late 1940s, General Radio created a new binding post that had a jack in a cap. Today it is commonly known as a "five-way" or "universal" binding post, which allows many types of connection methods:

• Banana plugs, inserted into the top open end of the binding post.
• Bare wire inserted through the same hole and clamped.
• Bare wire wrapped around the metal post and clamped.
• Pin connector, inserted into a hole drilled through the metal post and clamped by the screw-down portion of the binding post.
• Lug terminal, with a 1/4-inch (6.35 mm) inner diameter, inserted around the metal post and clamped.
• Alligator clip.

Safety

An adjustable switched-mode power supply for laboratory use with three safety banana jacks instead of binding posts

Even so-called isolated binding posts are typically not sufficiently isolated to protect users from coming into contact with their metal parts carrying voltage. As such they are not suitable to be used for carrying dangerous voltages (cf. extra-low voltage). On several types of equipment it has been becoming common to no longer use the traditional binding posts, but safety banana jacks. The universal property of binding posts is lost here, since safety banana jacks can only be used with traditional and safety banana plugs.

In the past, it was common for multiple five-way binding posts to have their drilled holes lined up; this provided convenience in some applications as a bare wire could be strung from post to post to post. But this also impaired safety as two wires or pin connectors could be inserted from opposite sides of two binding posts and the tips of the wires or probes might inadvertently short together. Holes are now normally aligned in such a fashion that such shorts cannot occur.

Standard spacing

In order to permit the use of double banana plugs, the most common distance between the centers of the plugs should be 3⁄4 inch (about 19 mm), which originated on General Radio test equipment during the 1920s, however 3⁄4 inch is not the only spacing.

See also

• Fahnestock clip — an earlier device, now largely supplanted by binding posts
• Banana connector

External links

• About.com glossary definition
• Binding Posts - Pomona Electronics