Peaking power plant
![]() | This article has an unclear citation style. (August 2012) |
![](http://upload.wikimedia.org/wikipedia/commons/thumb/2/28/PSEG_Kearny_Peak_across_Hacky_jeh.jpg/220px-PSEG_Kearny_Peak_across_Hacky_jeh.jpg)
Peaking power plants, also known as peaker plants, and occasionally just "peakers," are power plants that generally run only when there is a high demand, known as peak demand, for electricity.[1][2] Because they supply power only occasionally, the power supplied commands a much higher price per kilowatt hour than base load power. Peak load power plants are used in combination with base load power plants, which supply a dependable and consistent amount of electricity, meeting the minimum demand.
Peak hours
In the United States, peak hours usually occur in the afternoon, especially during the summer months when the air conditioning load is high. During this time many workplaces are still open and consuming power. Peak hours can also occur in the evening after work hours, when household appliances are heavily used.
A peaker plant may operate many hours a day, or it may operate only a few hours per year, depending on the condition of the region's electrical grid. Because of the cost of building an efficient power plant, if a peaker plant is only going to be run for a short or highly variable time it does not make economic sense to make it as efficient as a base load power plant. In addition, the equipment and fuels used in base load plants are often unsuitable for use in peaker plants because the fluctuating conditions would severely strain the equipment. For these reasons, nuclear, geothermal, waste-to-energy, coal, biomass and electrochemical energy storage systems are rarely, if ever, operated as peaker plants.
Types
In the US peaker plants are generally gas turbines that burn natural gas. A few burn petroleum-derived liquids, such as diesel oil and jet fuel, but they are usually more expensive than natural gas, so their use is limited. However, many peaker plants are able to use petroleum as a backup fuel. The thermodynamic efficiency of simple-cycle gas turbine power plants ranges from 20 to 42%, with between 30 to 42% being average for a new plant.
For greater efficiency, a heat recovery steam generator (HRSG) is added at the exhaust. This is known as a combined cycle plant. Cogeneration uses waste exhaust heat for process or other heating uses. Both of these options are used only in plants that are intended to be operated for longer periods than usual. Natural gas and diesel generators with reciprocating engines are sometimes used for grid support using smaller plants.
Another option for increased efficiency and power output in gas turbines is installing a turbine inlet air cooling system, that cools down the inlet air temperature increasing mass flow ratio. This option in combination with a thermal energy storage tank, can increase the turbine power output in on-peak periods up to 30%.[3]
Base load power plants
The opposites of peaking plants are base load power plants, which operate continuously, stopping only for maintenance or unexpected outages. Intermediate load following power plants operate between these extremes, curtailing their output in periods of low demand, such as during the night. Base load and intermediate plants are used preferentially to meet electrical demand because the lower efficiencies of peaker plants make them more expensive to operate.[4]
See also
- Base load power plant
- Geothermal electricity
- List of energy storage projects
- Smart grid
- Vehicle-to-grid
- Turbine Inlet Air Cooling
- Load following power plant
References
- ^ Renewable and Efficient Electric Power Systems by Gilbert M. Masters
- ^ http://www.opc.com/PoweringGeorgia/TypesofPowerPlants/PeakingPlants/index.htm
- ^ Kamal NA, Zuhair AM (2006). Enhancing gas turbine output through inlet air cooling. Sudan Eng. Soc. J., 52(4-6): 7-14.
- ^ http://www.opc.com/PoweringGeorgia/TypesofPowerPlants/BaseAndIntermediatePlants/index.htm