Jump to content

Tungsten disilicide

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by InternetArchiveBot (talk | contribs) at 09:51, 11 July 2018 (Rescuing 1 sources and tagging 0 as dead. #IABot (v2.0beta)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Tungsten disilicide[1]
Names
IUPAC name
Tungsten disilicide
Identifiers
3D model (JSmol)
ECHA InfoCard 100.031.723 Edit this at Wikidata
  • InChI=1S/2Si.W
  • [Si]#[W]#[Si]
Properties
WSi2
Molar mass 240.011 g/mol
Appearance blue-gray tetragonal crystals
Density 9.3 g/cm3
Melting point 2,160 °C (3,920 °F; 2,430 K)
insoluble
Hazards
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 1: Exposure would cause irritation but only minor residual injury. E.g. turpentineFlammability 0: Will not burn. E.g. waterInstability 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no code
1
0
0
Flash point Non-flammable
Related compounds
Other anions
Tungsten carbide
Tungsten nitride
Other cations
Molybdenum disilicide
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)

Tungsten silicide (WSi2) is an inorganic compound, a silicide of tungsten. It is an electrically conductive ceramic material.

Chemistry

Tungsten silicide can react violently with substances such as strong acids, fluorine, oxidizers, and interhalogens.

Applications

It is used in microelectronics as a contact material, with resistivity 60–80 μΩ cm; it forms at 1000 °C. It is often used as a shunt over polysilicon lines to increase their conductivity and increase signal speed. Tungsten silicide layers can be prepared by chemical vapor deposition, e.g. using monosilane or dichlorosilane with tungsten hexafluoride as source gases. The deposited film is non-stoichiometric, and requires annealing to convert to more conductive stoichiometric form. Tungsten silicide is a replacement for earlier tungsten films.[2] Tungsten silicide is also used as a barrier layer between silicon and other metals, e.g. tungsten.

Tungsten silicide also finds use in microelectromechanical systems and for oxidation-resistant coatings.

Films of tungsten silicide can be plasma-etched using e.g. nitrogen trifluoride gas.

References

  1. ^ Lide, David R. (1998), Handbook of Chemistry and Physics (87 ed.), Boca Raton, FL: CRC Press, pp. 4–91, ISBN 0-8493-0594-2
  2. ^ "Archived copy". Archived from the original on 2001-09-07. Retrieved 2007-08-19. {{cite web}}: Unknown parameter |deadurl= ignored (|url-status= suggested) (help)CS1 maint: archived copy as title (link)