Alcohol by volume

"ABV" redirects here. For other uses, see ABV (disambiguation).

The alcohol by volume shown on a bottle of absinthe.

Alcohol by volume (abbreviated as ABV, abv, or alc/vol) is a standard measure of how much alcohol (ethanol) is contained in a given volume of an alcoholic beverage (expressed as a volume percent). It is defined as the number of millilitres (mL) of pure ethanol present in 100 mL of solution at 20 °C (68 °F). The number of millilitres of pure ethanol is the mass of the ethanol divided by its density at 20 °C, which is 0.78924 g/mL. The ABV standard is used worldwide. The International Organization of Legal Metrology has tables of density of water–ethanol mixtures at different concentrations and temperatures.

In some countries, e.g., France, alcohol by volume is often referred to as degrees Gay-Lussac (after the French chemist Joseph Louis Gay-Lussac), although there is a slight difference since the Gay-Lussac convention uses the International Standard Atmosphere value for temperature, 15 °C (59 °F).

Volume change

Change in volume with increasing ABV

Mixing two solutions of alcohol of different strengths usually causes a change in volume. Mixing pure water with a solution less than 24% by mass causes a slight increase in total volume, whereas the mixing of two solutions above 24% causes a decrease in volume. The phenomenon of volume changes due to mixing dissimilar solutions is called "partial molar volume". Water and ethanol are both polar solvents. When water is added to ethanol, the smaller water molecules are attracted to the ethanol's hydroxyl group, and each molecule alters the polarity field of the other. The attraction allows for closer spacing between molecules than is usually found in non-polar mixtures.

Thus, ABV is not the same as volume fraction expressed as a percentage. Volume fraction, which is widely used in chemistry, is defined as the volume of a particular component divided by the sum of all components in the mixture when they are measured separately. To make a 50% v/v ethanol solution, for example, you would measure 50 mL of ethanol and separately measure 50 mL of water, then mix the two together. The resulting volume of solution will likely not measure 100 mL due to the change of volume on mixing.

Typical levels

Details about typical amounts of alcohol contained in various beverages can be found in the articles about them.

Drink	Typical ABV
Fruit juice (naturally occurring)	0%-0.09%
Low-alcohol beer	0.05%–1.2%
Kvass	0.05%–1.5%
Kefir	0.2%–2.0%
Kombucha	0.5%–1.5%
Boza	1.0%
Chicha	1.0%–11% (usually 1%–6%)
Beer	2.0%–12% (usually 4%–6%)
Cider	2.0%–12% (usually 4%–8%)
Alcopops	4.0%–17.5%
Malt liquor	5.0%+
Makgeolli	6.5%–7%
Barley wine (strong ale)	8%–15%
Mead	8%–16%
Wine	9%–16% (most often 12.5%–14.5%)
Kilju	15%–17%
Dessert wine	14%–25%
Sake	15% (or 18%–20% if not diluted prior to bottling)
Liqueurs	15%–55%
Fortified wine	15.5%–20% (in the European Union, 18%–22%)
Soju	17%–45% (usually 19%)
Shochu	25%–45% (usually 25%)
Rượu đế	27%-45% (usually 35%- except Ruou tam -40-45%)
Bitters	28%–45%
Applejack	30%-40%
Mezcal, Tequila	32%–60% (usually 40%)
Vodka	35%–95% (usually 40%, minimum of 37.5% in the European Union)
Rum	37.5%–80% (usually 40%)
Brandy	35%–60% (usually 40%)
Grappa	37.5%–60%
Ouzo	37.5%+
Pálinka	37.5%–86% (usually 52%)
Cachaça	38%–54%
Sotol	38%–60%
Stroh	38%–80%
Fernet	39%–45%
Nalewka	40%–45%
Tsipouro	40%-45%
Gin	37.5%–50%
Scotch whisky	40%–63.5%
Whisky	40%–68% (usually 40%, 43% or 46%)
Baijiu	40%–65%
Chacha	40%–70%
Răchie (Central/Southeast European drink)	42%–86%
Maotai	43%-53%
Absinthe	45%–89.9%
Țuică (Romanian drink)	30%–65% (usually 35%–55%)
Arak	60%–65%
Oghi	60%-75%
Poitín	60%–95%
Centerbe (herb liqueur)	70%
Neutral grain spirit	85%–95%
Cocoroco	93%–96%
Rectified spirit	95% up to a practical limit of 95.6%

Alcohol proof

Main article: Alcohol proof

Another way of specifying the amount of alcohol is alcohol proof, which in the United States is twice the alcohol-by-volume number, while in the United Kingdom it is 1.75 times the number (expressed as a percentage). For example, 40% abv is 80 proof in the US and 70 proof in the UK. However, since 1980, alcohol proof in the UK has been replaced by abv as a measure of alcohol content.

Alcohol by weight

In the United States, a few states regulate and tax alcoholic beverages according to alcohol by weight (ABW), expressed as a percentage of total mass. Some brewers print the ABW (rather than the ABV) on beer containers, particularly on low-point versions of popular domestic beer brands.

One can use the following equation to convert between ABV and ABW:

$ABV\times 0.78924=ABW\times {\text{density of beverage at 20 C in g/mL}}$

At relatively low ABV, the alcohol percentage by weight is about 4/5 of the ABV (e.g., 3.2% ABW is about 4% ABV). However, because of the miscibility of alcohol and water, the conversion factor is not constant but rather depends upon the concentration of alcohol. 100% ABW is equivalent to 100% ABV.

Prediction of alcohol content

During the production of wine and beer, yeast is added to a sugary solution. During fermentation, the yeasts consume the sugars and produce alcohol. The density of sugar in water is greater than the density of alcohol in water. A hydrometer is used to measure the change in specific gravity (SG) of the solution before and after fermentation. The volume of alcohol in the solution can then be estimated. There are a number of empirical formulae which brewers and winemakers use to estimate the alcohol content of the liquor made.

Wine

The simplest method for wine has been described by English author C.J.J. Berry:

• $ABV=(\mathrm {Starting~SG} -\mathrm {Final~SG} )/7.36$

Beer

Main article: Beer measurement § Strength

See also: Gravity_(alcoholic_beverage) § Alcohol_content

The calculation for beer is:

$ABV=133.62\times \left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)$

However, many brewers use the following formula which uses a different constant (different probably due to temperature variations and rounding):

$ABV=131.25\left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)$

It is derived in this manner:

• $ABV={\frac {\rho _{C2H5OH}}{\rho _{CO2}}}\times {\frac {\rho _{H2O}}{\rho _{C2H5OH}}}\times {\frac {\rho _{CO2}}{\rho _{H2O}}}\times 100$
• $ABV={\frac {\rho _{C2H5OH}}{\rho _{CO2}}}\times {\frac {\rho _{H2O}}{\rho _{C2H5OH}}}\times {\frac {\rho _{OG}-\rho _{FG}}{\rho _{H2O}}}\times 100$
• $ABV={\frac {\rho _{C2H5OH}}{\rho _{CO2}}}\times {\frac {\rho _{H2O}}{\rho _{C2H5OH}}}\times \left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)\times 100$
• $ABV={\frac {46.0684}{44.0095}}\times {\frac {1.0}{0.78934}}\left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)\times 100$
• $ABV={\frac {1.04678}{0.78934}}\times \left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)\times 100$
• $ABV=133.62\times \left(\mathrm {Starting~SG} -\mathrm {Final~SG} \right)$

1.05 is the ratio of ethanol molecules produced for every molecule of CO₂ produced (46.07 g/mol C2H6O / 44.01 g/mol CO2 = 1.0468) from a single molecule of glucose. The number 0.7936 is the specific gravity of a 100% ethanol solution. Both are unit-less measurements. The difference between the starting SG and the final SG measures the specific gravity lost to CO₂ release.

For higher ABV above 6% many brewers use this formula:

• $ABV={\frac {1.05}{0.79}}\left({\frac {\mathrm {Starting~SG} -\mathrm {Final~SG} }{\mathrm {Final~SG} }}\right)\times 100$

See also

• Alcohol proof
• Unit of alcohol
• Standard drink
• Apparent molar property
• Excess molar quantity
• Volume fraction

Bibliography

• Hehner, Otto (1880). Alcohol Tables: giving for all specific gravities, from 1.0000 to 0.7938, the percentages of absolute alcohol, by weight and volume. London: J & A Churchill. ASIN B0008B5HOU.
• Berry, C. J. J. (1998). First Steps in Winemaking. Nexus Special Interests. ISBN 978-1-85486-139-9. {{cite book}}: Invalid |ref=harv (help)
• Regan, Gary (2003). The Joy of Mixology. Clarkson Potter. ISBN 978-0-609-60884-5. {{cite book}}: Invalid |ref=harv (help)
• Robinson, Jancis (2006). The Oxford Companion to Wine (3rd ed.). Oxford: OUP. ISBN 978-0-19-860990-2. {{cite book}}: Invalid |ref=harv (help)

External links

• "How do brewers measure the alcohol in beer?". HowStuffWorks. 12 December 2000.
• Jayes, Wayne. "Alcohol Strength and Density". sugartech.co.za. The Sugar Engineers.