CT pulmonary angiogram: Difference between revisions
removed Category:Respiratory system procedures; added Category:Respiratory system imaging using HotCat |
m merge two related, single sentence paragraphs |
||
Line 9: | Line 9: | ||
OtherCodes = | |
OtherCodes = | |
||
}} |
}} |
||
'''CT pulmonary angiogram''' (CTPA) is a medical diagnostic test that employs [[computed tomography]] to obtain an image of the [[pulmonary artery|pulmonary arteries]]. Its main use is to diagnose [[pulmonary embolism]] (PE).<ref name=Fedullo/> |
'''CT pulmonary angiogram''' (CTPA) is a medical diagnostic test that employs [[computed tomography]] to obtain an image of the [[pulmonary artery|pulmonary arteries]]. Its main use is to diagnose [[pulmonary embolism]] (PE).<ref name=Fedullo/> It is a preferred choice of imaging in the diagnosis of PE due to its minimally invasive nature for the patient, whose only requirement for the scan is an intravenous line. |
||
It is a preferred choice of imaging in the diagnosis of PE due to its minimally invasive nature for the patient, whose only requirement for the scan is an intravenous line. |
|||
MDCT (multi-detector CT) scanners give the optimum resolution and image quality for this test. Images are usually taken on a 0.625 mm slice thickness, although 2 mm is sufficient. A contrast of 50–100 mls is given to the patient at a rate of 4 ml/s. The tracker/locator is placed at the level of the pulmonary arteries, which sit roughly at the level of the carina. Images are acquired with the maximum intensity of radio-opaque contrast in the pulmonary arteries. This is done using [[bolus tracking]]. |
MDCT (multi-detector CT) scanners give the optimum resolution and image quality for this test. Images are usually taken on a 0.625 mm slice thickness, although 2 mm is sufficient. A contrast of 50–100 mls is given to the patient at a rate of 4 ml/s. The tracker/locator is placed at the level of the pulmonary arteries, which sit roughly at the level of the carina. Images are acquired with the maximum intensity of radio-opaque contrast in the pulmonary arteries. This is done using [[bolus tracking]]. |
Revision as of 19:46, 21 November 2011
CT pulmonary angiogram | |
---|---|
Example of a CTPA, demonstrating a saddle embolus. The white area above the center is the pulmonary artery, opacified by radiocontrast. Inside it, the grey matter is blood clot. The black areas on either side are the lungs, with around it the chest wall. | |
OPS-301 code | 3-222 |
CT pulmonary angiogram (CTPA) is a medical diagnostic test that employs computed tomography to obtain an image of the pulmonary arteries. Its main use is to diagnose pulmonary embolism (PE).[1] It is a preferred choice of imaging in the diagnosis of PE due to its minimally invasive nature for the patient, whose only requirement for the scan is an intravenous line.
MDCT (multi-detector CT) scanners give the optimum resolution and image quality for this test. Images are usually taken on a 0.625 mm slice thickness, although 2 mm is sufficient. A contrast of 50–100 mls is given to the patient at a rate of 4 ml/s. The tracker/locator is placed at the level of the pulmonary arteries, which sit roughly at the level of the carina. Images are acquired with the maximum intensity of radio-opaque contrast in the pulmonary arteries. This is done using bolus tracking.
CT machines are now so sophisticated that the test can be done with a patient visit of 5 minutes with an approximate scan time of only 5 seconds or less.
A normal CTPA scan will show the contrast filling the pulmonary vessels, appearing as bright white. In ideal conditions, the aorta should be empty of contrast, to reduce any partial volume artifact that may result in a false positive. Any mass filling defects, such as an embolus, will appear dark in place of the contrast, filling/blocking the space where blood should be flowing into the lungs.
Diagnostic use
CTPA was introduced in the 1990s as an alternative to ventilation/perfusion scanning, which relies on radionuclide imaging of the blood vessels of the lung. It is regarded as a highly sensitive and specific test for pulmonary embolism.[1]
CTPA is typically only requested if pulmonary embolism is suspected clinically. If the probability of PE is considered low, a blood test called D-dimer may be requested. If this is negative and risk of a PE is considered negligible, then CTPA or other scans are generally not performed. Most patients will have undergone a chest X-ray before CTPA is requested.[1]
After initial concern that CTPA would miss smaller emboli, a 2007 study comparing CTPA directly with ventilation/perfusion scanning found that CTPA identified more emboli without decreasing the risk of long-term complications compared to V/Q scanning.[2]
Contraindications
CTPA is generally avoided in pregnancy due to the amount of ionizing radiation required, which may damage the fetus.[3]
CTPA is contraindicated in known or suspected allergy to contrast media or in renal failure (where contrast agents could worsen the renal function).[2]
Acquisition
The best results are obtained using multidetector computed tomography (MDCT) scanners.[4]
An intravenous cannula is required for the administration of the 50-150 ml. of radiocontrast. This is injected, usually automatically, by a syringe driver, at a rate of 4 ml./second. Many hospitals use bolus tracking, where the scan commences when the contrast is detected at the level of the proximal pulmonary arteries. If this is done manually, scanning commences about 10–12 seconds after the injection has started. Slices of 1-3 mm. are performed at 1-3 mm. intervals, depending on the nature of the scanner (single- versus multidetector).[2]
State of the art CT machines can complete a scan in approximately five seconds and it is possible to complete the entire procedure (set-up, injection and scanning) in the space of five minutes.[citation needed]
Interpretation
On CTPA, the pulmonary vessels are filled with contrast, and appear white. Any mass filling defects (embolus or other matter such as fat or amniotic fluid) appears darker. Generally, the scan should be complete before the contrast reaches the left side of the heart and the aorta, which could result in artifacts.[citation needed]
References
- ^ a b c Fedullo PF, Tapson VF (2003). "Clinical practice. The evaluation of suspected pulmonary embolism". N. Engl. J. Med. 349 (13): 1247–56. doi:10.1056/NEJMcp035442. PMID 14507950.
- ^ a b c Anderson DR, Kahn SR, Rodger MA; et al. (2007). "Computed tomographic pulmonary angiography vs ventilation-perfusion lung scanning in patients with suspected pulmonary embolism". JAMA. 298 (23): 2743–53. doi:10.1001/jama.298.23.2743. PMID 18165667.
{{cite journal}}
: Explicit use of et al. in:|author=
(help)CS1 maint: multiple names: authors list (link) - ^ Scarsbrook AF, Gleeson FV (2007). "Investigating suspected pulmonary embolism in pregnancy". BMJ. 334 (7590): 418–9. doi:10.1136/bmj.39071.617257.80. PMC 1804186. PMID 17322258.
- ^ Schoepf UJ, Goldhaber SZ, Costello P (2004). "Spiral computed tomography for acute pulmonary embolism". Circulation. 109 (18): 2160–7. doi:10.1161/01.CIR.0000128813.04325.08. PMID 15136509.
{{cite journal}}
: CS1 maint: multiple names: authors list (link)