Jump to content

Yakovlev Yak-20

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Chris the speller (talk | contribs) at 15:53, 11 December 2015 (Specifications (Yak-20-1): per WP:HYPHEN, sub-subsection 3, points 3,4,5, replaced: ² → <sup>2</sup> (4), fully- → fully using AWB). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Yak-20
Role Trainer aircraft
Manufacturer Yakovlev
First flight 1949
Number built 2

The Yakovlev Yak-20 (in Russian Як-20), was an experimental piston-engined trainer developed in the USSR in 1949. It did not go into production.[1]

Design and development

In 1949 the Yak-20 was designed by the OKB for use with aviation clubs as a trainer and sport aircraft. Intended to be the cheapest modern aircraft that could serve as a useful pilot trainer and aerobatic sport aircraft, the Yak-20 was intended to be considerably cheaper to build and operate than the contemporary Yak-18.[1]

Though structurally similar to the Yak-18, the Yak-20 had a welded steel tube fuselage which was skinned with aluminium alloy sheet and fabric, with Aluminium alloy wings, skinned in metal back to the single spar, and fabric aft of the spar. Accommodation was side by side under a large blown canopy, which slid open to the rear. The cockpit had dual stick controls, with the pilot sitting to port. There was a central push-pull throttle, and simple gyro instruments. The engine was the newly developed Ivchenko AI-10 five cylinder radial. This engine was small, and extremely light. It was rated at 80 hp, driving a V-515 controllable-pitch counterweight propeller. Fuel was carried in two 35 liter (7.7 gallon) tanks in the wing roots, ahead of the single spar.[1]

Testing

The Yak-20 was designed from the start to be fully aerobatic with very high spin resistance. The two prototypes were tested by pilots Anokhin and Georgii Shiyanov, and later by DOSAAF pilots, as well as a succession of leading aerobatic sport pilots who were invited to fly it. All were eager to see it put into production. State Acceptance trials followed, but the State evaluation team considered the Yak-20 too small and under-powered, recommending a redesign to match the performance of the Yak-18. Some of the criticisms of the State evaluation team were addressed in the second prototype, (Yak-20-2), which, as a result, became heavier and lost the performance edge of the first prototype. With Yak-18 production already in full swing, production of the Yak-20 was deemed superfluous. The final blow came when production of the small Ivchenko AI-10 engine was cancelled.[1]

Variants

Yak-20-1
First Prototype.
Yak-20-2
Second Prototype

Specifications (Yak-20-1)

General characteristics

  • Crew: two, student and instructor

Performance

Similar aircraft

See also

References

  1. ^ a b c d Gunston, 1997
  • Gordon, Yefim (2005). OKB Yakovlev: A History of the Design Bureau and its Aircraft. Hinkley: Midland.
  • Gunston, Bill. Yakovlev Aircraft since 1924. London, UK: Putnam Aeronautical Books, 1997. ISBN 1-55750-978-6.