Jump to content

Talk:Tape measure

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Luigizanasi (talk | contribs) at 07:29, 6 March 2007 (←Undid revision 111622033 by 81.145.241.168 (talk)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

WikiProject iconMetalworking Unassessed
WikiProject iconThis article is within the scope of WikiProject Metalworking, a collaborative effort to improve the coverage of Metalworking on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking articles
???This article has not yet received a rating on Wikipedia's content assessment scale.
???This article has not yet received a rating on the project's importance scale.

afaik the tape measure (before Fellow's patent) originated in Sheffield. can anyone verify this? Interlude 111 00:01, 27 February 2006 (UTC)[reply]

may some could explayn the truss markings (black diamonds, on my tape) every 19.2 inches and the stud marking (balck triangles) every 16 inches, as far as I know there are 5 truss markings or 6 stud markings in an 8-foot width... Markus Schulz 03/23/06 09:44:54 EST

Retrieved from "https://en.wikipedia.org/w/index.php?title=Talk:Tape_measure&oldid=113014743"