Dagesh

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by YaLindaHadad (talk | contribs) at 22:27, 1 September 2019. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Dagesh
ּ
IPA Biblical ḥazaq: [ː] (gemination)
qal: [v]~[β]→[b], [ɣ]→[ɡ],
[ð]→[d], [x]→[k],
[f]~[ɸ]→[p], [θ]→[t]
Israeli [v]~[β]→[b], [x]~[χ]→[k], [f]→[p]
Transliteration Biblical ḥazaq: doubling of consonant
qal: none
(SBL transliteration system[1])
Israeli v→b, kh→k, f→p
Same appearance mappiq, shuruk
Example
דָּגֵשׁ
"Dagesh" in Hebrew. The center dot on the rightmost character is a dagesh.
Other Niqqud
Shva · Hiriq · Tzere · Segol · Patach · Kamatz · Holam · Dagesh · Mappiq · Shuruk · Kubutz · Rafe · Sin/Shin Dot

The dagesh (Template:Hebrew) is a diacritic used in the Hebrew alphabet. It was added to the Hebrew orthography at the same time as the Masoretic system of niqqud (vowel points). It takes the form of a dot placed inside a Hebrew letter and has the effect of modifying the sound in one of two ways.

An identical mark, called mappiq, has a different phonetic function, and can be applied to different consonants; the same mark is also employed in the vowel shuruk.

Dagesh and mappiq symbols are often omitted in writing. For instance, Template:Hebrew is often written as Template:Hebrew. The use or omission of such marks is usually consistent throughout any given context. The two functions of dagesh are distinguished as either kal (light) or ḥazak (strong).

Dagesh kal

A dagesh kal or dagesh qal (Template:Hebrew, or Template:Hebrew, also "dagesh lene", "weak/light dagesh", opposed to "strong dot") may be placed inside the consonants Template:Hebrew bet, Template:Hebrew gimel, Template:Hebrew dalet, Template:Hebrew kaf, Template:Hebrew pe and Template:Hebrew tav. They each had two sounds: the original "hard" (plosive) sound, and a "soft" (fricative) sound. Before the Babylonian captivity, the soft sounds did not exist in Hebrew, but were added as a result of Aramaic-influenced pronunciation of Hebrew after this point in history. The letters take on their hard sounds when they have no vowel sound before them, and take their soft sounds when a vowel immediately precedes them, across word boundaries in Biblical Hebrew, but not in Modern Hebrew. When vowel diacritics are used, the hard sounds are indicated by a central dot called dagesh, while the soft sounds lack a dagesh. In Modern Hebrew, however, the dagesh only changes the pronunciation of Template:Hebrew bet, Template:Hebrew kaf, and Template:Hebrew pe (traditional Ashkenazic pronunciation also varies the pronunciation of Template:Hebrew tav, and some traditional Middle Eastern pronunciations carry alternate forms for Template:Hebrew dalet).

With dagesh Without dagesh
Symbol Name Transliteration IPA Example Symbol Name Transliteration IPA Example
Template:Hebrew bet b /b/ bun Template:Hebrew vet v /v/ van
[2]Template:Hebrew kaph k /k/ kangaroo Template:Hebrew khaph kh/ch/ḵ /χ/ loch
[3]Template:Hebrew pe p /p/ pass Template:Hebrew phe f/ph /f/ find

* Only in Ashkenazi pronunciation Tav without a dagesh is pronounced [s], while in another traditions it is assumed to have been pronounced [θ] at the time niqqud was introduced. In Modern Hebrew, it is always pronounced [t].

** The letters gimmel (ג) and dalet (ד) may also contain a dagesh kal. This indicates an allophonic variation of the phonemes /ɡ/ and /d/, a variation which no longer exists in modern Hebrew pronunciation. The variations are believed to have been: Template:Hebrew=[ɡ], Template:Hebrew=[ɣ], Template:Hebrew=[d], Template:Hebrew=[ð]. The Hebrew spoken by the Jews of Yemen (Yemenite Hebrew) still preserves unique phonemes for these letters with and without a dagesh.[4]

*** The letter hey (ה) when word final is usually silent in order to indicate the presence of a word-final vowel. But when it receives a dagesh kal, the hey is pronounced instead of being silent. This is the rule in historic pronunciation, but in Modern Hebrew, this rule is generally ignored. However, when a non-silent word-final hey (הּ) occurs, it can take a furtive patach.

Pronunciation

In Israel's general population, the pronunciation of some of the above letters has become identical to the pronunciation of others:

Letter pronounced like Letter
Template:Hebrew
vet
(without dagesh) like Template:Hebrew
vav
Template:Hebrew
khaf
(without dagesh) like Template:Hebrew
chet
Template:Hebrew
tav
(with dagesh) like Template:Hebrew
tet
Template:Hebrew
kaf
(with dagesh) like Template:Hebrew
qof

Dagesh hazak

Dagesh ḥazak or dagesh ḥazaq (Template:Hebrew, "strong dot", i.e. "gemination dagesh", or Template:Hebrew, also "dagesh forte") may be placed in almost any letter, this indicated a gemination (doubling) of that consonant in the pronunciation of pre-modern Hebrew. This gemination is not adhered to in modern Hebrew and is only used in careful pronunciation, such as reading of scriptures in a synagogue service, recitations of biblical or traditional texts or on ceremonious occasions, and then only by very precise readers.

The following letters, the gutturals, almost never have a dagesh: aleph א, he ה, chet ח, ayin ע, resh ר. (A few instances of resh with dagesh are masoretically recorded in the Hebrew Bible, as well as a few cases of aleph with a dagesh, such as in Leviticus 23:17.)

The presence of a dagesh ḥazak or consonant-doubling in a word may be entirely morphological, or, as is often the case, is a lengthening to compensate for a deleted consonant. A dagesh ḥazak may be placed in letters for one of the following reasons:

  • The letter follows the definite article, the word "the". For example, Template:Hebrew shamayim "heaven(s)" in Gen 1:8 is Template:Hebrew Hashshamayim "the heaven(s)" in Gen 1:1. This is because the definite article was originally a stand-alone particle הַל hal, but at some early stage in ancient Hebrew it contracted into a prefix הַ 'ha-', and the loss of the ל 'l' was compensated for by doubling the following letter. In this situation where the following letter is a guttural, the vowel in 'ha-' becomes long to compensate for the inability to double the next letter - otherwise, this vowel is almost always short. This also happens in words taking the prefix לַ 'la-', since it is a prefix created by the contraction of לְ 'le-' + הַ 'ha-'. Occasionally, the letter following a He which is used to indicate a question may also receive a dagesh, e.g. Num 13:20 Template:Hebrew Hashshemena hi? - "whether it is fat".
  • The letter follows the prefix מִ 'mi-' where this prefix is an abbreviation for the word min, meaning "from". For example, the phrase "from your hand", if spelled as two words, would be Template:Hebrew min yadekha. In Gen. 4:11, however, it occurs as one word: Template:Hebrew miyyadekha. This prefix mostly replaces the usage of the particle מִן min in modern Hebrew.
  • The letter follows the prefix שֶׁ 'she-' in modern Hebrew, which is a prefixed contraction of the relative pronoun אֲשֶׁר asher, where the first letter is dropped and the last letter disappears and doubles the next letter. This prefix is rare in Biblical texts, but mostly replaces the use of אֲשֶׁר asher in Modern Hebrew.
  • It marks the doubling of a letter that is caused by a weak letter losing its vowel. In these situations, the weak letter disappears, and the following letter is doubled to compensate for it. For example, compare Ex. 6:7 Template:Hebrew lakachti with Num 23:28, where the first letter of the root ל has been elided: Template:Hebrew vayyikkach. Lamed only behaves as a weak letter in this particular root word, but never anywhere else.
  • If the letter follows a vav consecutive imperfect (sometimes referred to as vav conversive, or vav ha'hipuch), which, in Biblical Hebrew, switches a verb between perfect and imperfect. For example, compare Judges 7:4 Template:Hebrew yelekh "let him go" with Deu. 31:1 Template:Hebrew vayyelekh "he went". A possible reason for this doubling is that the וַ 'va-' prefix could be the remains of an auxiliary verb הָוַיַ hawaya (the ancient form of the verb הָיָה hayah, "to be") being contracted into a prefix, losing the initial 'ha', and the final 'ya' syllable disappearing and doubling the next letter.
  • In some of the binyan verbal stems, where the Piel, Pual and Hitpa'el stems themselves cause doubling in the second root letter of a verb. For example:
    • Ex. 15:9 Template:Hebrew achallek "I shall divide", Piel Stem, first person future tense
    • in the phrase הָלֵּלוּ יַהּ hallelu yah "praise the LORD", where hallelu is in Piel Stem, masculine plural Imperative form
    • Gen. 47:31 Template:Hebrew vayyitchazzek, "he strengthened himself", Hitpael stem

Rafe

In Masoretic manuscripts the opposite of a dagesh would be indicated by a rafe, a small line on top of the letter. This is no longer found in Hebrew, but may still sometimes be seen in Yiddish and Ladino.

Unicode encodings

In computer typography there are two ways to use a dagesh with Hebrew text. Here are Unicode examples:

  • Combining characters:
    • bet + dagesh: בּ בּ = U+05D1 U+05BC
    • kaf + dagesh: כּ כּ = U+05DB U+05BC
    • pe + dagesh: פּ פּ = U+05E4 U+05BC
  • Precomposed characters:
    • bet with dagesh: בּ בּ = U+FB31
    • kaf with dagesh: כּ כּ = U+FB3B
    • pe with dagesh: פּ פּ = U+FB44

Some fonts, character sets, encodings, and operating systems may support neither, one, or both methods.

See also

Notes

  1. ^ Resources for New Testament Exegesis – Transliteration Standards of The SBL Handbook of Style
  2. ^ "ךּ" is rare but exists, e.g. last word in Deuteronomy 7 1 (דברים פרק ז׳ פסוק א׳) in the word "מִמֶּךָּ" – see here
  3. ^ "ףּ" is rare but exists, e.g. second word in Proverbs 30 6 (משלי פרק ל׳ פסוק ו׳) in the word "תּוֹסְףְּ" – see here
  4. ^ "Vocalization of Hebrew Alphabet". Retrieved 2018-09-20.

Further reading

External links